185 research outputs found

    Measurements in Film Cooling Flows With Periodic Wakes”.

    Get PDF
    ABSTRACT Film cooling flows subject to periodic wakes were studied experimentally. The wakes were generated with a spoked wheel upstream of a flat plate. Cases with a single row of cylindrical film cooling holes inclined at 35 degrees to the surface were considered at blowing ratios of 0.25, 0.50, and 1.0 with a steady freestream and with wake Strouhal numbers of 0.15, 0.30, and 0.60. Temperature measurements were made using an infrared camera, thermocouples, and constant current (cold wire) anemometry. Hot wire anemometry was used for velocity measurements. The local film cooling effectiveness and heat transfer coefficient were determined from the measured temperatures. Phase locked flow temperature fields were determined from cold wire surveys. Wakes decreased the film cooling effectiveness for blowing ratios of 0.25 and 0.50 when compared to steady freestream cases. In contrast, effectiveness increased with Strouhal number for the 1.0 blowing ratio cases, as the wakes helped mitigate the effects of jet liftoff. Heat transfer coefficients increased with wake passing frequency, with nearly the same percentage increase in cases with and without film cooling. The time resolved flow measurements show the interaction of the wakes with the film cooling jets. Near-wall flow measurements are used to infer the instantaneous film cooling effectiveness as it changes during the wake passing cycle

    A new perspective on the submillimetre galaxy MM 18423+5938 at redshift 3.9296 from radio continuum imaging

    Get PDF
    The bright submillimetre (sub-mm) galaxy MM 18423+5938 at redshift 3.9296 has been predicted from mid-infrared and millimetre photometry to have an exceptionally large total infrared (IR) luminosity. We present new radio imaging at 1.4 GHz with the Westerbork Synthesis Radio Telescope that is used to determine a radio-derived total IR luminosity for MM 18423+5938 via the well established radio-far-infrared correlation. The flux density is found to be S_1.4 GHz = 217 +/- 37 \mu Jy, which corresponds to a rest-frame luminosity density of L_1.4 GHz = 2.32 +/- 0.40 x 10^25 / u W / Hz, where u is the magnification from a probable gravitational lens. The radio-derived total IR luminosity and star-formation rate are L_8-1000 \mu m = 5.6^+4.1_-2.4 x 10^13 / u L_sol and SFR = 9.4^+7.4_-4.9 x 10^3 / u M_sol / yr, respectively, which are ~9 times smaller than those previously reported. These differences are attributed to the IR spectral energy distribution of MM 18423+5938 being poorly constrained by the limited number of reliable photometric data that are currently available, and from a previous misidentification of the object at 70 \mu m. Using the radio derived total IR luminosity as a constraint, the temperature of the cold dust component is found to be T ~ 24^+7_-5 K for a dust emissivity of \beta = 1.5 +/- 0.5. The radio-derived properties of this galaxy are still large given the low excitation temperature implied by the CO emission lines and the temperature of the cold dust. Therefore, we conclude that MM 18423+5938 is probably gravitationally lensed.Comment: 5 pages, 2 figures, 1 table, accepted for publication in MNRAS Letter

    A Computational Fluid Dynamics Study of Transitional Flows in Low-Pressure Turbines under a Wide Range of Operating Conditions

    Get PDF
    A transport equation for the intermittency factor is employed to predict the transitional flows in low-pressure turbines. The intermittent behavior of the transitional flows is taken into account and incorporated into computations by modifying the eddy viscosity, mu(sub p) with the intermittency factor, gamma. Turbulent quantities are predicted using Menter's two-equation turbulence model (SST). The intermittency factor is obtained from a transport equation model which can produce both the experimentally observed streamwise variation of intermittency and a realistic profile in the cross stream direction. The model had been previously validated against low-pressure turbine experiments with success. In this paper, the model is applied to predictions of three sets of recent low-pressure turbine experiments on the Pack B blade to further validate its predicting capabilities under various flow conditions. Comparisons of computational results with experimental data are provided. Overall, good agreement between the experimental data and computational results is obtained. The new model has been shown to have the capability of accurately predicting transitional flows under a wide range of low-pressure turbine conditions

    Oscillatory Shear Flow-Induced Alignment of Lamellar Melts of Hydrogen-Bonded Comb Copolymer Supramolecules

    Get PDF
    In this work we present the orientational behavior of comb copolymer-like supramolecules P4VP(PDP)1.0, obtained by hydrogen bonding between poly(4-vinylpyridine) and pentadecylphenol, during large-amplitude oscillatory shear flow experiments over a broad range of frequencies (0.001-10 Hz). The alignment diagram, presenting the macroscopic alignment in T/TODT vs ω/ωc, contains three regions of parallel alignment separated by a region of perpendicular alignment. For our material, the order-disorder temperature TODT = 67 °C and ωc, the frequency above which the distortion of the chain conformation dominates the materials’ viscoelasticity, is around 0.1 Hz at 61 °C. For the first time flipping from a pure transverse alignment via biaxial transverse/perpendicular alignment to a perpendicular alignment as a function of the strain amplitude was found.
    • …
    corecore