The effects of selective logging methods on hydrological parameters in Peninsular Malaysia.

An experimental forest watershed, consisting of three small catchments at Berembun, Negeri Sembilan, in Peninsular Malaysia has been monitored from 1979 to 1987. Adequate instruments were installed for continuous collection of hydrologic and climatic data. The calibration and post-treatment phases lasted for three and four years respectively. Two types of treatments were imposed -namely commercial selective logging and supervised selective logging in catchment 1 and catchment 3 whilst catchment 2 remained as a control. Pertinent logging guidelines were prescribed and assessed in C3 in terms of hydrological responses. Significant water yield increases were observed after forest treatment in both catchments amounting to 165 mm (70%) and 87 mm (37%) respectively in the first year; increases persisted to the fourth year after treatment. Magnitude and rate of water yield increase primarily depended on the amount of forest removed and the prevailing rainfall regime and the increase was largely associated with baseflow augmentation. Interestingly, both types of selective loggings produced no significant effect on peak discharge while the commercial logging resulted in a significant increase in stormflow volume and initial discharge. Such responses can be explained by the extensive nature of selective logging which normally left a substantial area of forest intact and minimal disturbance to flow channels. Thus, conservation measures introduced in this study - the use of buffer strips, cross drains, an appropriate percentage for the forest road network,- were found to be effective and beneficial in ameliorating the hydrological impacts

Prevalence, associated factors and outcomes of pressure injuries in adult intensive care unit patients: the DecubICUs study

Funder: European Society of Intensive Care Medicine; doi: http://dx.doi.org/10.13039/501100013347Funder: Flemish Society for Critical Care NursesAbstract: Purpose: Intensive care unit (ICU) patients are particularly susceptible to developing pressure injuries. Epidemiologic data is however unavailable. We aimed to provide an international picture of the extent of pressure injuries and factors associated with ICU-acquired pressure injuries in adult ICU patients. Methods: International 1-day point-prevalence study; follow-up for outcome assessment until hospital discharge (maximum 12 weeks). Factors associated with ICU-acquired pressure injury and hospital mortality were assessed by generalised linear mixed-effects regression analysis. Results: Data from 13,254 patients in 1117 ICUs (90 countries) revealed 6747 pressure injuries; 3997 (59.2%) were ICU-acquired. Overall prevalence was 26.6% (95% confidence interval [CI] 25.9–27.3). ICU-acquired prevalence was 16.2% (95% CI 15.6–16.8). Sacrum (37%) and heels (19.5%) were most affected. Factors independently associated with ICU-acquired pressure injuries were older age, male sex, being underweight, emergency surgery, higher Simplified Acute Physiology Score II, Braden score 3 days, comorbidities (chronic obstructive pulmonary disease, immunodeficiency), organ support (renal replacement, mechanical ventilation on ICU admission), and being in a low or lower-middle income-economy. Gradually increasing associations with mortality were identified for increasing severity of pressure injury: stage I (odds ratio [OR] 1.5; 95% CI 1.2–1.8), stage II (OR 1.6; 95% CI 1.4–1.9), and stage III or worse (OR 2.8; 95% CI 2.3–3.3). Conclusion: Pressure injuries are common in adult ICU patients. ICU-acquired pressure injuries are associated with mainly intrinsic factors and mortality. Optimal care standards, increased awareness, appropriate resource allocation, and further research into optimal prevention are pivotal to tackle this important patient safety threat

Correction to: Prevalence, associated factors and outcomes of pressure injuries in adult intensive care unit patients: the DecubICUs study

The original version of this article unfortunately contained a mistake

Prevalence, associated factors and outcomes of pressure injuries in adult intensive care unit patients: the DecubICUs study

Funder: European Society of Intensive Care Medicine; doi: http://dx.doi.org/10.13039/501100013347Funder: Flemish Society for Critical Care NursesAbstract: Purpose: Intensive care unit (ICU) patients are particularly susceptible to developing pressure injuries. Epidemiologic data is however unavailable. We aimed to provide an international picture of the extent of pressure injuries and factors associated with ICU-acquired pressure injuries in adult ICU patients. Methods: International 1-day point-prevalence study; follow-up for outcome assessment until hospital discharge (maximum 12 weeks). Factors associated with ICU-acquired pressure injury and hospital mortality were assessed by generalised linear mixed-effects regression analysis. Results: Data from 13,254 patients in 1117 ICUs (90 countries) revealed 6747 pressure injuries; 3997 (59.2%) were ICU-acquired. Overall prevalence was 26.6% (95% confidence interval [CI] 25.9–27.3). ICU-acquired prevalence was 16.2% (95% CI 15.6–16.8). Sacrum (37%) and heels (19.5%) were most affected. Factors independently associated with ICU-acquired pressure injuries were older age, male sex, being underweight, emergency surgery, higher Simplified Acute Physiology Score II, Braden score 3 days, comorbidities (chronic obstructive pulmonary disease, immunodeficiency), organ support (renal replacement, mechanical ventilation on ICU admission), and being in a low or lower-middle income-economy. Gradually increasing associations with mortality were identified for increasing severity of pressure injury: stage I (odds ratio [OR] 1.5; 95% CI 1.2–1.8), stage II (OR 1.6; 95% CI 1.4–1.9), and stage III or worse (OR 2.8; 95% CI 2.3–3.3). Conclusion: Pressure injuries are common in adult ICU patients. ICU-acquired pressure injuries are associated with mainly intrinsic factors and mortality. Optimal care standards, increased awareness, appropriate resource allocation, and further research into optimal prevention are pivotal to tackle this important patient safety threat

The effects of selective logging methods on hydrological parameters in Peninsular Malaysia.

An experimental forest watershed, consisting of three small catchments at Berembun, Negeri Sembilan, in Peninsular Malaysia has been monitored from 1979 to 1987. Adequate instruments were installed for continuous collection of hydrologic and climatic data. The calibration and post-treatment phases lasted for three and four years respectively. Two types of treatments were imposed -namely commercial selective logging and supervised selective logging in catchment 1 and catchment 3 whilst catchment 2 remained as a control. Pertinent logging guidelines were prescribed and assessed in C3 in terms of hydrological responses. Significant water yield increases were observed after forest treatment in both catchments amounting to 165 mm (70%) and 87 mm (37%) respectively in the first year; increases persisted to the fourth year after treatment. Magnitude and rate of water yield increase primarily depended on the amount of forest removed and the prevailing rainfall regime and the increase was largely associated with baseflow augmentation. Interestingly, both types of selective loggings produced no significant effect on peak discharge while the commercial logging resulted in a significant increase in stormflow volume and initial discharge. Such responses can be explained by the extensive nature of selective logging which normally left a substantial area of forest intact and minimal disturbance to flow channels. Thus, conservation measures introduced in this study - the use of buffer strips, cross drains, an appropriate percentage for the forest road network,- were found to be effective and beneficial in ameliorating the hydrological impacts

Effect of Temperature and Acid Concentration on Rhizophora mucronata Tannin as a Corrosion Inhibitor

The effect of temperature and acid concentration on a newly formulated tannin as a corrosion inhibitor for carbon steel in oil and gas facilities was investigated. Corrosion rate of carbon steel in HCl acid solutions (0, 5, 10, 15, 20, 25 and 30%) by Rhizophora mucronata tannin (RMT) was studied using chemical (weight loss method) and spectroscopic (FTIR) techniques at various temperatures in the ranges of 26–70 °C. At 20% optimum concentration of acid, the FTIR result showed the presence of hydroxyl group, aromatic group, esters and the substituted benzene group, indicating the purity of the tannin. The increase in HCl acid concentration and temperature increased the corrosion rate, but the rate of corrosion was mild with RMT. Therefore, the use of RMT as a cost-effective and environmental-friendly corrosion-inhibiting agent for carbon steel is herein proposed