Large Grid-Connected Wind Turbines

This book covers the technological progress and developments of a large-scale wind energy conversion system along with its future trends, with each chapter constituting a contribution by a different leader in the wind energy arena. Recent developments in wind energy conversion systems, system optimization, stability augmentation, power smoothing, and many other fascinating topics are included in this book. Chapters are supported through modeling, control, and simulation analysis. This book contains both technical and review articles

Wind generator stability enhancement by using an adaptive artificial neural network-controlled superconducting magnetic energy storage

This paper presents a novel adaptive artificial neural network (ANN)-controlled superconducting magnetic energy storage (SMES) to enhance the transient stability of a grid-connected wind generator system. The control strategy of the SMES unit is developed based on cascaded control scheme of a voltage source converter and a two-quadrant DC-DC chopper using insulated gate bipolar transistors (IGBTs). The proposed controller is used to control the duty cycle of the DC-DC chopper. Detailed modeling and control strategies of the system are presented. The effectiveness of the proposed adaptive ANN-controlled SMES is then compared with that of a conventional proportional-integral (PI)-controlled SMES. The validity of the proposed system is verified with the simulation results which are performed using the standard dynamic power system simulator PSCAD/EMTDC

Model predictive-based secondary frequency control considering heat pump water heaters

The extensive development of renewable energies in power systems causes several problems due to intermittent output power generation. To tackle the challenge, demand response contribution to ancillary service is currently well recognized under the smart grid infrastructure. The application of the heat pump water heater (HPWH) as a controllable load in primary frequency control is well presented in the literature; however, the motivation of this paper is to use HPWHs for secondary frequency control. To this end, a model predictive control (MPC) method for a two-area power system incorporating HPWHs to contribute to secondary frequency control is proposed in this paper. A detailed model of HPWH is employed as a controllable load to control the power consumption during water heating. The MPC method predicts the future control signals using a quadratic programming-based optimization. It uses the system model, past inputs and outputs, as well as system control signals to predict the next signals. The effective performance of the proposed method for the two-area power system with HPWH is demonstrated for different scenarios of load changes, intermittent renewable power generation and parameter variations as the sensitivity analysis

Impact of Slim DC Capacitance on Floating Capacitor H-bridge Motor Drive

This paper discusses the impact of small dc capacitance in a motor drive using a floating capacitor H-bridge topology. The proposed topology is intended for applications where variable frequency control is not required. Special attention is paid on investigating the second-order dc capacitor voltage ripples, whose influence on the induction motor as well as on the motor drive itself is of importance. This issue is addressed in this paper through rigorous mathematical formulations. It is found that by inverting the second-order dc ripple voltage using the conventional SVPWM, no harmful harmonics will be generated in the motor line voltage. This demonstrates the possibility of drastically reducing the dc capacitance of the proposed system. Induction motor as well as H-bridge performance with respect to different dc capacitance values is demonstrated by experiments, which lays the foundation for cost reduction and reliability enhancement of the proposed system

Experimental Validation of a Robust Continuous Nonlinear Model Predictive Control Based Grid-Interlinked Photovoltaic Inverter

This paper presents a robust continuous nonlinear model predictive control (CNMPC) for a grid-connected photovoltaic (PV) inverter system. The objective of the proposed approach is to control the power exchange between the grid and a PV system, while achieving unity power factor operation. As the continuous nonlinear MPC cannot completely remove the steady-state error in the presence of disturbances, the nonlinear disturbance observer-based control is adopted to estimate the offset caused by parametric uncertainties and external perturbation. The stability of the closed-loop system under both nonlinear predictive control and disturbance observer is ensured by convergence of the output-tracking error to the origin. The proposed control strategy is verified using a complete laboratory-scale PV test-bed system consisting of a PV emulator, a boost converter, and a grid-tied inverter. High performance with respect to dc-link voltage tracking, grid current control, disturbance rejection, and unity power factor operation has been demonstrated

Maximizing the economic benefits of a grid-tied microgrid using solar-wind complementarity

The increasing use of intermittent, renewable energy sources (RESs) for electricity generation in microgrids (MGs) requires efficient strategies for reliable and economic operation. Complementarity between RESs provides good prospects for integrating several local energy sources and reducing the costs of MG setup and operations. This paper presents a framework for maximizing the economic benefits of a grid-tied MG by exploiting the spatial and temporal complementarity between solar and wind energies (solar-wind complementarity). The proposed framework considers the cost of energy production from different RESs and the cost of bi-directional energy exchange with the main grid. For a given RES mix, a minimum system power loss (SPL) threshold can also be determined. However, at this SPL threshold, MG energy exchange cost is not always minimized. The framework determines the optimized SPL value (above the threshold) at which MG energy exchange cost gets minimized. Through this framework, MG operator can decide appropriate RES mix and can achieve various tradeoffs according to the energy production cost, solar-wind complementarity of the site and its required economic objectives

On the Role of Renewable Energy Policies and Electric Vehicle Deployment Incentives for a Greener Sector Coupling

Various incentives are introduced for the expansion of electric vehicle fleets and electricity generation from renewable energy resources. Although many researchers studied the effect of these policies on the related sector, there is no study investigating the indirect effect of renewable energy incentives on the deployment of electric vehicles or the indirect effect of electric vehicle adoption policies on the long-term integration of renewable energy resources. The main contribution of this paper is to analyze the impact of the specific incentives on both deployment of electric vehicles in the transportation system and investment in capacity generation in the electricity market. For this purpose, a new framework was designed to analyze the effect of policies on the electric vehicle deployment and development of DC charging stations based on the system dynamics approach. Then, this framework was combined with the existing dynamic models of the electricity market to study the interaction and behavior of both coupled systems from the policymakers' perspective. The effect of policies implementation was interpreted in a mathematical framework and the Net Present Value method was used for assessing the investment in charging infrastructures. Simulation results of a case study in the United States and sensitivity analysis illustrate that increasing the wind capacity incentives accelerated the electrification of the transportation system and increasing the incentives for electrification of transportation system influences wind capacity positively. Moreover, the sensitivity of the electric vehicle adoption to gas price is more than the sensitivity of the wind capacity penetration to gas price

Optimal distribution coefficients of energy resources in frequency stability of hybrid microgrids connected to the power system

The continuous stability of hybrid microgrids (MGs) has been recently proposed as a critical topic, due to the ever-increasing growth of renewable energy sources (RESs) in low-inertia power systems. However, the stochastic and intermittent nature of RESs poses serious challenges for the stability and frequency regulation of MGs. In this regard, frequency control ancillary services (FCAS) can be introduced to alleviate the transient effects during substantial variations in the operating point and the separation from main power grids. In this paper, an efficient scheme is introduced to create a coordination among distributed energy resources (DERs), including combined heat and power, diesel engine generator, wind turbine generators, and photovoltaic panels. In this scheme, the frequency regulation signal is assigned to DERs based on several distribution coefficients, which are calculated through conducting a multi-objective optimization problem in the MATLAB environment. A meta-heuristic approach, known as the artificial bee colony algorithm, is deployed to determine optimal solutions. To prove the efficiency of the proposed scheme, the design is implemented on a hybrid MG. Various operational conditions which render the system prone to experience frequency fluctuation, including switching operation, load disturbance, and reduction in the total inertia of hybrid microgrids, are studied in PSCAD software. Simulation results demonstrate that this optimal control scheme can yield a more satisfactory performance in the presence of grid-following and grid-forming resources during different operational conditions

Offset-Free Direct Power Control of DFIG Under Continuous-Time Model Predictive Control

This paper presents a robust continuous-time model predictive direct power control for doubly fed induction generator (DFIG). The proposed approach uses Taylor series expansion to predict the stator current in the synchronous reference frame over a finite time horizon. The predicted stator current is directly used to compute the required rotor voltage in order to minimize the difference between the actual stator currents and their references over the predictive time. However, as the proposed strategy is sensitive to parameter variations and external disturbances, a disturbance observer is embedded into the control loop to remove the steady-state error of the stator current. It turns out that the steady-state and the transient performances can be identified by simple design parameters. In this paper, the reference of the stator current is directly calculated from the desired stator active and reactive powers without encompassing the parameters of the machine itself. Hence, no extra power control loop is required in the control structure to ensure smooth operation of the DFIG. The feasibility of the proposed strategy is verified by the experimental results of the grid-connected DFIG and satisfactory performances are obtained