125 research outputs found
HIGH VOLTAGE OPERATIONAL TRANSCONDUCTIVE AMPLIFIER (OTA) DESIGN FOR A CONTROL LOOP
An operational transconductance amplifier (OTA) is typically used in the optical transmitter for an analog control. Additionally, for an OTA, the input range may be shifted to the output range and the output range is to be limited to safely operate a cascode/drive transistor. OTA operation is linear and is not digitally switched. Presented herein is an OTA design that can operate with a power supply voltage greater than the drain-source voltage (VDS) breakdown voltage. The output range can be limited to the gate-source voltage (VGS) breakdown range and can be adapted to a desired range using a cascode transistor. Additionally, the OTA design presented herein can operate safely in non-switched applications
Electrically conductive, transparent polymeric nanocomposites modified by 2D Ti3C2Tx (MXene)
The electrically conductive, transparent, and flexible self-standing thin nanocomposite films based on copolyamide matrix (coPA:Vestamelt X1010) modified with 2D Ti3C2Tx (MXene) nanosheets were prepared by casting and their electrical, mechanical and optical properties and then, were investigated. The percolation threshold of the MXene filler within the coPA matrix was found to be 0.05 vol. %, and the highest determined electrical conductivity was 1.4 x 10(-2) Scm(-1) for the composite filled with 5 wt. % (1.8 vol. %) of MXene. The electrical conductivity of the as-prepared MXene was 9.1 Scm(-1), and the electrical conductivity of the MAX phase (the precursor for MXene preparation) was 172 Scm(-1). The transparency of the prepared composite films exceeded 75%, even for samples containing 5 wt. % of MXene, as confirmed by UV spectroscopy. The dynamic mechanical analysis confirmed the improved mechanical properties, such as the storage modulus, which improved with the increasing MXene content. Moreover, all the composite films were very flexible and did not break under repeated twisting. The combination of the relatively high electrical conductivity of the composites filled with low filler content, an appropriate transparency, and good mechanical properties make these materials promising for applications in flexible electronics.Qatar University Collaborative High Impact Grant [QUHI-CENG-18/19-1
Antibacterial potential of electrochemically exfoliated graphene sheets
Electrochemically exfoliated graphene is functionalized graphene with potential application in biomedicine. Two most relevant biological features of this material are its electrical conductivity and excellent water dispersibility. In this study we have tried to establish the correlation between graphene structure and its antibacterial properties. The exfoliation process was performed in a two electrode-highly oriented pyrolytic graphite electrochemical cell. Solution of ammonium persulfate was used as an electrolyte. Exfoliated graphene sheets were dispersed in aqueous media and characterized by atomic force microscopy, scanning electron microscopy, Raman spectroscopy, Fourier transform infrared spectroscopy, X photoelectron spectroscopy, X-ray diffraction, electron paramagnetic resonance, zeta potential, contact angle measurements and surface energy. Antibacterial assays have shown lack of the significant antibacterial activity. Major effect on bacteria was slight change of bacteria morphology. Membrane remained intact despite significant change of chemical content of membrane components.This is the peer reviewed version of the paper: Marković, Z. M., Matijašević, D. M., Pavlović, V. B., Jovanović, S. P., Holclajtner-Antunović, I. D., Špitalský, Z., Mičušik, M., Dramićanin, M. D., Milivojević, D. D., Nikšić, M. P., & Todorović Marković, B. M. (2017). Antibacterial potential of electrochemically exfoliated graphene sheets. Journal of Colloid and Interface Science, 500, 30–43. [https://doi.org/10.1016/j.jcis.2017.03.110][https://www.sciencedirect.com/science/article/abs/pii/S0021979717303776?via%3Dihub
Electrically conductive, transparent polymeric nanocomposites modified by 2D Ti3C2Tx (MXene)
The electrically conductive, transparent, and flexible self-standing thin nanocomposite films based on copolyamide matrix (coPA:Vestamelt X1010) modified with 2D Ti3C2Tx (MXene) nanosheets were prepared by casting and their electrical, mechanical and optical properties and then, were investigated. The percolation threshold of the MXene filler within the coPA matrix was found to be 0.05 vol. %, and the highest determined electrical conductivity was 1.4 × 10-2 S·cm-1 for the composite filled with 5 wt. % (1.8 vol. %) of MXene. The electrical conductivity of the asprepared MXene was 9.1 S·cm-1, and the electrical conductivity of the MAX phase (the precursor for MXene preparation) was 172 S·cm-1. The transparency of the prepared composite films exceeded 75%, even for samples containing 5 wt. % of MXene, as confirmed by UV spectroscopy. The dynamic mechanical analysis confirmed the improved mechanical properties, such as the storage modulus, which improved with the increasing MXene content. Moreover, all the composite films were very flexible and did not break under repeated twisting. The combination of the relatively high electrical conductivity of the composites filled with low filler content, an appropriate transparency, and good mechanical properties make these materials promising for applications in flexible electronics.Author Contributions: Conceptualization, I.K. and M.M.; methodology, I.K. and P.S.; software, P.S.; validation, P.S. A.T.; formal analysis, P.S., Z.S., M.M, and Ma.M.; investigation, A.T., P.S., M.M., Ma.M., J.P. and A.P.; resources, I.K.; data curation, P.S., J.P., I.K., Ma.M., and M.M.; writing—original draft preparation, A.T., P.S., M.M. and Z.S.; writing—review and editing, I.K., M.M. and P.S.; visualization, P.S., J.P. and A.P.; supervision, I.K.; project administration, I.K.; funding acquisition, I.K.; Funding: This publication was supported by Qatar University Collaborative High Impact Grant QUHI-CENG-18/19-1. The findings achieved herein are solely the responsibility of the authors
- …