502 research outputs found
An investigation of potential applications of OP-SAPS: Operational Sampled Analog Processors
The application of OP-SAP's (operational sampled analog processors) in pattern recognition system is summarized. Areas investigated include: (1) human face recognition; (2) a high-speed programmable transversal filter system; (3) discrete word (speech) recognition; and (4) a resolution enhancement system
Real time flight simulation methodology
An example sensitivity study is presented to demonstrate how a digital autopilot designer could make a decision on minimum sampling rate for computer specification. It consists of comparing the simulated step response of an existing analog autopilot and its associated aircraft dynamics to the digital version operating at various sampling frequencies and specifying a sampling frequency that results in an acceptable change in relative stability. In general, the zero order hold introduces phase lag which will increase overshoot and settling time. It should be noted that this solution is for substituting a digital autopilot for a continuous autopilot. A complete redesign could result in results which more closely resemble the continuous results or which conform better to original design goals
A polymorphic reconfigurable emulator for parallel simulation
Microprocessor and arithmetic support chip technology was applied to the design of a reconfigurable emulator for real time flight simulation. The system developed consists of master control system to perform all man machine interactions and to configure the hardware to emulate a given aircraft, and numerous slave compute modules (SCM) which comprise the parallel computational units. It is shown that all parts of the state equations can be worked on simultaneously but that the algebraic equations cannot (unless they are slowly varying). Attempts to obtain algorithms that will allow parellel updates are reported. The word length and step size to be used in the SCM's is determined and the architecture of the hardware and software is described
Preliminary experimental results for a cryogenic brush seal configuration
Preliminary fluid nitrogen flow data are reported for a five-brush, ceramic-coated-rub-runner brush seal system, where the brushes and the rub runner were placed at each end of a centrally pressurized multifunction tester ('back-to-back' set of brushes) and tested at rotor speeds of 0, 10, 18, and 22.5 krpm. After testing, both the brushes and the ceramic-coated rub runner appeared pristine. The coating withstood both the thermomechanical and dynamic loadings with minor wear track scarring. The bristle tips showed some indication of material shearing (smearing) wear. The Ergun porous flow equation was applied to the brush seal data. The Ergun relation, which required heuristic information to characterize the coefficients, fit the gaseous data but was in poor agreement with the fluid results. The brush seal exit conditions were two phase. Two-phase, choked-flow design charts were applied but required one data point at each rotor speed to define the (C(sub f)A x Constant) flow and area coefficients. Reasonable agreement between prediction and data was found, as expected, but such methods are not to be construed as two-phase-flow brush seal analyses
Examining the Links Between Challenging Behaviors in Youth with ASD and Parental Stress, Mental Health, and Involvement: Applying an Adaptation of the Family Stress Model to Families of Youth with ASD
Raising a child with autism spectrum disorder (ASD) poses unique challenges that may impact parents’ mental health and parenting experiences. The current study analyzed self-report data from 77 parents of youth with ASD. A serial multiple mediation model revealed that parenting stress (SIPA) and parental mental health (BAI and BDI-II) appears to be impacted by challenging adolescent behaviors (SSIS-PBs) and, in turn, affect parental involvement (PRQ), controlling for social skills (SSIS-SSs). Further, the study explored the malleability of parents’ mental health over the course of a social skills intervention, and provides modest evidence that parent depressive symptoms decline across intervention. This study illustrates the importance of considering the entire family system in research on youth with ASD
Social Difficulties in Youth with Autism With and Without Anxiety and ADHD Symptoms
Social difficulties inherent to autism spectrum disorder are often linked with co‐occurring symptoms of anxiety and attention deficit hyperactivity disorder (ADHD). The present study sought to examine the relation between such co‐occurring symptoms and social challenges. Parents of adolescents with autism (N = 113) reported upon social challenges via the social responsiveness scale (SRS) and anxiety and ADHD symptomatology via the Child Behavior Checklist. Results revealed differences in SRS scores across co‐occurring symptom subgroups (Anxiety, ADHD, Both, Neither)—namely, adolescents with autism and anxiety as well as those with autism, anxiety, and ADHD showed greater scores on the SRS than the other groups. Implications for research and clinical practice are discussed and recommendations are offered. Lay Summary
Anxiety and attention deficit hyperactivity disorder (ADHD) symptoms are related to greater social challenges for adolescents with autism spectrum disorder. The present study found that autism with anxiety and autism with anxiety and ADHD, was related to greater social difficulties than autism alone. Findings provide further support for the intertwined nature of anxiety and ADHD symptoms in autism. What this may mean for research and clinical practice is considered and recommendations are suggested
Social Difficulties in Youth with Autism With and Without Anxiety and ADHD Symptoms
Social difficulties inherent to autism spectrum disorder are often linked with co‐occurring symptoms of anxiety and attention deficit hyperactivity disorder (ADHD). The present study sought to examine the relation between such co‐occurring symptoms and social challenges. Parents of adolescents with autism (N = 113) reported upon social challenges via the social responsiveness scale (SRS) and anxiety and ADHD symptomatology via the Child Behavior Checklist. Results revealed differences in SRS scores across co‐occurring symptom subgroups (Anxiety, ADHD, Both, Neither)—namely, adolescents with autism and anxiety as well as those with autism, anxiety, and ADHD showed greater scores on the SRS than the other groups. Implications for research and clinical practice are discussed and recommendations are offered. Lay Summary
Anxiety and attention deficit hyperactivity disorder (ADHD) symptoms are related to greater social challenges for adolescents with autism spectrum disorder. The present study found that autism with anxiety and autism with anxiety and ADHD, was related to greater social difficulties than autism alone. Findings provide further support for the intertwined nature of anxiety and ADHD symptoms in autism. What this may mean for research and clinical practice is considered and recommendations are suggested
Stability of Nonlinear Control Systems by the Second Method of Liapunov
This report investigates the stability of autonomous closed-loop control systems containing nonlinear elements. An n-th order nonlinear autonomous system is described by a set of n first order differential equations of the type dxi/dt=xi(x1, x2, …xn) i=1,2,…n. Liapunov\u27s second (direct) method is used in the stability analysis of such systems. This method enables one to prove that a system is stable (or unstable) if a function V=V (x1, x2, … xn) can be found which, together with its time derivative, satisfies the requirements of Liapunov\u27s stability (or instability) theorems. At the present time, there are no generally applicable straight forward procedures available for constructing these Liapunov\u27s functions. Several Liapunov\u27s functions, applicable to systems described in the canonic form of differential equations, have been reported in the literature. In this report, it is shown that any autonomous closed-loop system containing a single nonlinear element can be described by canonic differential equations. The stability criteria derived from the Liapunov\u27s functions for canonic systems give sufficient and not necessary conditions for stability. It is known that these criteria reject many systems which are actually stable. The reasons why stable systems are sometimes rejected by these simplified stability criteria are investigated in the report. It is found that a closed-loop system will always be rejected by these simplified stabi1ity criteria if the root locus of the transfer function G(s), representing the linear portion of the system, is not confined to the left-half of the s-plane for all positive values of the loop gain. A pole-shifting technique and a zero-shifting technique, extending -the applicability of the simplified stability criteria to systems that are stable for sufficiently high and/or sufficiently low values of the loop gain, are proposed in this report. New simplified stability criteria have been developed which incorporate the changes in the canonic form of differential equations caused by the application of the zero-shifting technique. Other methods of constructing Liapunov\u27s functions for nonlinear control systems are presented in Chapter III, These include the work of Pliss, Aizerman and Krasovski. Numerous other procedures, which have been reported in literature, apply to only very special cases of automatic control systems. No attempt has been made to account for all of these special cases and the presentation of methods of constructing Liapunov’s functions is limited to only those which are more generally applicable. A pseudo-canonic transformation has been developed which enables one to find stability criteria of canonic systems without the use of complex variables. The results of this research indicate that the second method of Liapunov is a very powerfuI tool of exact stability analysis of nonlinear systems. Additional research, especially in the direction of the methods of construction of Liapunov’s functions, will not only yield new analysis and synthesis procedures, but also will aid in arriving at a set of meaningful performance specifications for nonlinear control systems
Specification and Data Presentation in Linear Control Systems-Part Two
This is the second part of a 2 volume report on the specification and data presentation in linear control systems. This volume deals with Sample Data Systems, Linear Time Variable Parameter Systems, and Performance Indices, which are respectively Chapter II, III, and IV of the volume. Since these subjects are somewhat unrelated, a separate abstract is given at the beginning of each chapter, with the exception of the introductory Chapter I. The separate chapter abstracts are repeated here for the convenience of the reader. Abstract - Linear Sampled Data Control Systems The specifications recommended, for use with sampled data control systems are those recommended for linear, continuous systems [1]. These specifications must be supplemented, as is dictated by the requirements of a particular system, by compatibility considerations that are detailed in the following sections. Abstract - The Specification of Linear Time Variable Parameter Systems Linear time variable parameter (LTVP) systems are defined and subdivided into those systems with fast or slow variations and/or large or small variations. The methods of analysis of such systems are reviewed, and the following recommendations are made. Specifications 1) Time Domain Specifications (a) LTVP systems with fast variation of parameters. Simulated unfrozen system step function responses should all lie within a prescribed envelope. Whenever possible, the actual system response should be obtained. (b) LTVP systems with slow variation of parameters. Simulated or actual frozen or unfrozen system step function responses should all lie within a prescribed envelope. 2) Frequency Domain Specifications (a) LTVP system with fast variation of parameters. Frequency domain specifications are not recommended. (b) LTFP system with slow variation of parameters. The family of frequency response curves of the system frozen at different instants should all lie within a predetermined envelope. Data Presentation It is recommended that the region of variation of closed loop poles of the frozen system be exhibited on the complex plane. Thus, for example, if the only varying parameter is an open loop gain, then the region of variation of the closed loop poles will correspond to the root loci over the total range of variation of gain. It is also recommended that a family of Nyquist diagrams corresponding to the system frozen at different instants be displayed in the case of system with slow variations of parameters. Abstract - Performance Index This study was undertaken to determine whether or not Performance Indices should be used to evaluate and specify control systems* It is recommended that they not be used at this time by the Air Force for the stated purpose. A performance index is defined and detailed discussions are presented for the various performance indices. Analytical methods for evaluating performance indices are presented
Threats from the air: damselfly predation on diverse prey taxa
To understand the diversity and strength of predation in natural communities, researchers must quantify the total amount of prey species in the diet of predators. Metabarcoding approaches have allowed widespread characterization of predator diets with high taxonomic resolution. To determine the wider impacts of predators, researchers should combine DNA techniques with estimates of population size of predators using mark–release–recapture (MRR) methods, and with accurate metrics of food consumption by individuals. Herein, we estimate the scale of predation exerted by four damselfly species on diverse prey taxa within a well‐defined 12‐ha study area, resolving the prey species of individual damselflies, to what extent the diets of predatory species overlap, and which fraction of the main prey populations are consumed. We identify the taxonomic composition of diets using DNA metabarcoding and quantify damselfly population sizes by MRR. We also use predator‐specific estimates of consumption rates, and independent data on prey emergence rates to estimate the collective predation pressure summed over all prey taxa and specific to their main prey (non‐biting midges or chironomids) of the four damselfly species. The four damselfly species collectively consumed a prey mass equivalent to roughly 870 (95% CL 410–1,800) g, over 2 months. Each individual consumed 29%–66% (95% CL 9.4–123) of its body weight during its relatively short life span (2.1–4.7 days; 95% CL 0.74–7.9) in the focal population. This predation pressure was widely distributed across the local invertebrate prey community, including 4 classes, 19 orders and c. 140 genera. Different predator species showed extensive overlap in diets, with an average of 30% of prey shared by at least two predator species. Of the available prey individuals in the widely consumed family Chironomidae, only a relatively small proportion (0.76%; 95% CL 0.35%–1.61%) were consumed. Our synthesis of population sizes, per‐capita consumption rates and taxonomic distribution of diets identifies damselflies as a comparatively minor predator group of aerial insects. As the next step, we should add estimates of predation by larger odonate species, and experimental removal of odonates, thereby establishing the full impact of odonate predation on prey communities.Peer reviewe
- …