49 research outputs found

    On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection

    Get PDF
    A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)

    Overview of the JET results in support to ITER

    Get PDF

    Symbolic Systems Biology: Hybrid Modeling and Analysis of Biological Networks

    No full text
    How do living cells compute and control themselves, and communicate with their environment? We describe the modeling and analysis of dynamic and reactive biological systems involving both discrete and continuous behaviors, to help begin to answer that question

    COREDIV and SOLPS Numerical Simulations of the Nitrogen Seeded JET ILW L-mode Discharges

    No full text
    In this paper we present the comparison of simulations with the numerical codes COREDIV and SOLPS5.0 for JET L-mode discharges with ITER like wall (ILW). The simulations have been performed for L-mode shots with and without nitrogen seeding (#82291 - 9) which are characterised by relatively low auxiliary heating power (PNBI = 1.1 MW) and low electron density (ne = 2.35 × 1019 m–3). Comparisons are made to the experimental measurements (e.g. radiation levels, plasma profiles) and the differences between the results from the two codes (e.g. temperature and density profiles at the outer divertor plate) are shown and discussed

    An FPGA-based bolometer for the MAST-U Super-X divertor

    No full text
    A new resistive bolometer system has been developed for MAST-Upgrade. It will measure radiated power in the new Super-X divertor, with millisecond time resolution, along 16 vertical and 16 horizontal lines of sight. The system uses a Xilinx Zynq-7000 series Field-Programmable Gate Array (FPGA) in the D-TACQ ACQ2106 carrier to perform real time data acquisition and signal processing. The FPGA enables AC-synchronous detection using high performance digital filtering to achieve a high signal-to-noise ratio and will be able to output processed data in real time with millisecond latency. The system has been installed on 8 previously unused channels of the JET vertical bolometer system. Initial results suggest good agreement with data from existing vertical channels but with higher bandwidth and signal-to-noise ratio
    corecore