Wearable-based assessment of heart rate response to physical stressors in patients after open-heart surgery with frailty

Due to frailty, cardiac rehabilitation in older patients after open-heart surgery must be carefully tailored, thus calling for informative and convenient tools to assess the effectiveness of exercise training programs. The study investigates whether heart rate (HR) response to daily physical stressors can provide useful information when parameters are estimated using a wearable device. The study included 100 patients after open-heart surgery with frailty who were assigned to intervention and control groups. Both groups attended inpatient cardiac rehabilitation however only the patients of the intervention group performed exercises at home according to the tailored exercise training program. While performing maximal veloergometry test and submaximal tests, i.e., walking, stair-climbing, and stand up and go, HR response parameters were derived from a wearable-based electrocardiogram. All submaximal tests showed moderate to high correlation ( r = 0.59–0.72) with veloergometry for HR recovery and HR reserve parameters. While the effect of inpatient rehabilitation was only reflected by HR response to veloergometry, parameter trends over the entire exercise training program were also well followed during stair-climbing and walking. Based on study findings, HR response to walking should be considered for assessing the effectiveness of home-based exercise training programs in patients with frailty

Formalization of the observations of the sea level variations using XML data schemas and scalable vector graphics format

XML (Extended Markup Language) Data Schemas as the format for information exchange in graphical SVG (Scalable Vector Graphics) format is presented in the paper. SVG file format is a language for two-dimensional graphics and is based on XML. It is suggested to apply it as the advanced version of previous data exchange format TGINEX (Tide Gauge Independent Exchange Format), which contains the plain ASCII data. SVG graphics are formatted from the observations of sea level observations by the tide gauges. As an example, the formalization of data is shown on the base of the sea level observing station KLPD, which is a part of the European Sea Level Service network. XML Data Schemas, in addition, adds header’s information about the marine measurements' site, sensors and any additional necessary information. The correct header formation and the advantages of such data exchange format are analysed. Header is important for exchange between different sites from different countries as so it would be information standartization. Visual appearance of the SVG file, the source, headers and formation of the file in script are described in this paper als

Formalization of the observations of the sea level variations using XML data schemas and scalable vector graphics format

XML (Extended Markup Language) Data Schemas as the format for information exchange in graphical SVG (Scalable Vector Graphics) format is presented in the paper. SVG file format is a language for two-dimensional graphics and is based on XML. It is suggested to apply it as the advanced version of previous data exchange format TGINEX (Tide Gauge Independent Exchange Format), which contains the plain ASCII data. SVG graphics are formatted from the observations of sea level observations by the tide gauges. As an example, the formalization of data is shown on the base of the sea level observing station KLPD, which is a part of the European Sea Level Service network. XML Data Schemas, in addition, adds header’s information about the marine measurements' site, sensors and any additional necessary information. The correct header formation and the advantages of such data exchange format are analysed. Header is important for exchange between different sites from different countries as so it would be information standartization. Visual appearance of the SVG file, the source, headers and formation of the file in script are described in this paper als

Demonstration of Fuel Hot-Spot Pressure in Excess of 50 Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA

A record fuel hot-spot pressure P[subscript hs] = 56±7  Gbar was inferred from x-ray and nuclear diagnostics for direct-drive inertial confinement fusion cryogenic, layered deuterium–tritium implosions on the 60-beam, 30-kJ, 351-nm OMEGA Laser System. When hydrodynamically scaled to the energy of the National Ignition Facility, these implosions achieved a Lawson parameter ∼60% of the value required for ignition [A. Bose et al., Phys. Rev. E 93, LM15119ER (2016)], similar to indirect-drive implosions [R. Betti et al., Phys. Rev. Lett. 114, 255003 (2015)], and nearly half of the direct-drive ignition-threshold pressure. Relative to symmetric, one-dimensional simulations, the inferred hot-spot pressure is approximately 40% lower. Three-dimensional simulations suggest that low-mode distortion of the hot spot seeded by laser-drive nonuniformity and target-positioning error reduces target performance.United States. Department of Energy (DE-NA0001944

Two Dimensional Simulations of Plastic-Shell, Direct-Drive Implosions on OMEGA

Multidimensional hydrodynamic properties of high-adiabat direct-drive plastic-shell implosions on the OMEGA laser system [T. R. Boehly et al., Opt. Commun. 133, 495 (1997)] are investigated using the multidimensional hydrodynamic code, DRACO. Multimode simulations including the effects of nonuniform illumination and target roughness indicate that shell stability during the acceleration phase plays a critical role in determining target performance. For thick shells that remain integral during the acceleration phase, target yields are significantly reduced by the combination of the long-wavelength ({ell} < 10) modes due to surface roughness and beam imbalance and the intermediate modes (20 {le} {ell} {le} 50) due to single-beam nonuniformities. The neutron-production rate for these thick shells truncates relative to one-dimensional (1-D) predictions. The yield degradation in the thin shells is mainly due to shell breakup at short wavelengths ({lambda} {approx} {Delta}, where {Delta} is the in-flight shell thickness). The neutron-rate curves for the thinner shells have significantly lower amplitudes and a fall-off that is less steep than 1-D rates. DRACO simulation results are consistent with experimental observations

Where are we now with European forest multi-taxon biodiversity and where can we head to?

The European biodiversity and forest strategies rely on forest sustainable management (SFM) to conserve forest biodiversity. However, current sustainability assessments hardly account for direct biodiversity indicators. We focused on forest multi-taxon biodiversity to: i) gather and map the existing information; ii) identify knowledge and research gaps; iii) discuss its research potential. We established a research network to fit data on species, standing trees, lying deadwood and sampling unit description from 34 local datasets across 3591 sampling units. A total of 8724 species were represented, with the share of common and rare species varying across taxonomic classes: some included many species with several rare ones (e.g., Insecta); others (e.g., Bryopsida) were represented by few common species. Tree-related structural attributes were sampled in a subset of sampling units (2889; 2356; 2309 and 1388 respectively for diameter, height, deadwood and microhabitats). Overall, multi-taxon studies are biased towards mature forests and may underrepresent the species related to other developmental phases. European forest compositional categories were all represented, but beech forests were over-represented as compared to thermophilous and boreal forests. Most sampling units (94%) were referred to a habitat type of conservation concern. Existing information may support European conservation and SFM strategies in: (i) methodological harmonization and coordinated monitoring; (ii) definition and testing of SFM indicators and thresholds; (iii) data-driven assessment of the effects of environmental and management drivers on multi-taxon forest biological and functional diversity, (iv) multi-scale forest monitoring integrating in-situ and remotely sensed information

The 2023 wearable photoplethysmography roadmap

Photoplethysmography is a key sensing technology which is used in wearable devices such as smartwatches and fitness trackers. Currently, photoplethysmography sensors are used to monitor physiological parameters including heart rate and heart rhythm, and to track activities like sleep and exercise. Yet, wearable photoplethysmography has potential to provide much more information on health and wellbeing, which could inform clinical decision making. This Roadmap outlines directions for research and development to realise the full potential of wearable photoplethysmography. Experts discuss key topics within the areas of sensor design, signal processing, clinical applications, and research directions. Their perspectives provide valuable guidance to researchers developing wearable photoplethysmography technology

Lawson criterion for ignition exceeded in an inertial fusion experiment

For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin "burn propagation" into surrounding cold fuel, enabling the possibility of high energy gain. While "scientific breakeven" (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this Letter reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion