The analog signal processing board for the HEAT telescopes

Abstract The aim of the Pierre Auger Observatory is to measure with high statistics the flux, the arrival directions and the mass composition of cosmic rays at the highest energies. Since 2009, the Auger Collaboration has added three new High Elevation Auger Telescopes (HEAT) along with a new 25 km 2 infill array in the field of view of the new telescopes. These enhancements have lowered the energy threshold of the Observatory by about an order of magnitude. In combination with the existing telescopes in Coihueco the vertical field of view is extended to about 60°, allowing the measurement of nearby air showers arising from primaries with energies as low as 2×10 17 eV. In this paper we describe the new front-end analog board developed to process the signals generated by the photomultipliers of the HEAT telescopes. Eighty analog boards have been produced, fully characterized and tested. The main characteristics of the electronic circuits and the circuit parameters are illustrated

THE ARCADE PROJECT

n/

Measurement of the cosmic ray spectrum above 4×10184{\times}10^{18} eV using inclined events detected with the Pierre Auger Observatory

A measurement of the cosmic-ray spectrum for energies exceeding $4{\times}10^{18}$ eV is presented, which is based on the analysis of showers with zenith angles greater than $60^{\circ}$ detected with the Pierre Auger Observatory between 1 January 2004 and 31 December 2013. The measured spectrum confirms a flux suppression at the highest energies. Above $5.3{\times}10^{18}$ eV, the "ankle", the flux can be described by a power law $E^{-\gamma}$ with index $\gamma=2.70 \pm 0.02 \,\text{(stat)} \pm 0.1\,\text{(sys)}$ followed by a smooth suppression region. For the energy ($E_\text{s}$) at which the spectral flux has fallen to one-half of its extrapolated value in the absence of suppression, we find $E_\text{s}=(5.12\pm0.25\,\text{(stat)}^{+1.0}_{-1.2}\,\text{(sys)}){\times}10^{19}$ eV.Comment: Replaced with published version. Added journal reference and DO

Energy Estimation of Cosmic Rays with the Engineering Radio Array of the Pierre Auger Observatory

The Auger Engineering Radio Array (AERA) is part of the Pierre Auger Observatory and is used to detect the radio emission of cosmic-ray air showers. These observations are compared to the data of the surface detector stations of the Observatory, which provide well-calibrated information on the cosmic-ray energies and arrival directions. The response of the radio stations in the 30 to 80 MHz regime has been thoroughly calibrated to enable the reconstruction of the incoming electric field. For the latter, the energy deposit per area is determined from the radio pulses at each observer position and is interpolated using a two-dimensional function that takes into account signal asymmetries due to interference between the geomagnetic and charge-excess emission components. The spatial integral over the signal distribution gives a direct measurement of the energy transferred from the primary cosmic ray into radio emission in the AERA frequency range. We measure 15.8 MeV of radiation energy for a 1 EeV air shower arriving perpendicularly to the geomagnetic field. This radiation energy -- corrected for geometrical effects -- is used as a cosmic-ray energy estimator. Performing an absolute energy calibration against the surface-detector information, we observe that this radio-energy estimator scales quadratically with the cosmic-ray energy as expected for coherent emission. We find an energy resolution of the radio reconstruction of 22% for the data set and 17% for a high-quality subset containing only events with at least five radio stations with signal.Comment: Replaced with published version. Added journal reference and DO

Measurement of the Radiation Energy in the Radio Signal of Extensive Air Showers as a Universal Estimator of Cosmic-Ray Energy

We measure the energy emitted by extensive air showers in the form of radio emission in the frequency range from 30 to 80 MHz. Exploiting the accurate energy scale of the Pierre Auger Observatory, we obtain a radiation energy of 15.8 \pm 0.7 (stat) \pm 6.7 (sys) MeV for cosmic rays with an energy of 1 EeV arriving perpendicularly to a geomagnetic field of 0.24 G, scaling quadratically with the cosmic-ray energy. A comparison with predictions from state-of-the-art first-principle calculations shows agreement with our measurement. The radiation energy provides direct access to the calorimetric energy in the electromagnetic cascade of extensive air showers. Comparison with our result thus allows the direct calibration of any cosmic-ray radio detector against the well-established energy scale of the Pierre Auger Observatory.Comment: Replaced with published version. Added journal reference and DOI. Supplemental material in the ancillary file

Development of a Carbon Nanotubes Based Photodetetor

The purpose of this PhD thesis has been the development of a new solid-state photodetector based on carbon nanotubes grown on doped silicon substrates. Carbon nanotubes films can be easily grown on large area creating large photocathode with unique and precious characteristics: low cost, high quantum efficiency, high linearity, and stable at room temperature. It has been demonstrated that the heterojunction created between a film of carbon nanotubes and silicon generates a light sensitive detector with good quantum efficiency in the visible range. In fact, the carbon nanotubes layer absorbs photons producing electron-hole pairs that can be separated by the carbon nanotubes film and the electrical field inside the depletion zone of the heterojunction. The charge produces a photocurrent drained out by the applied voltage. It was found that dark current measurements are well explained by assuming that the charge transport is controlled by tunneling between carbon nanostructures and silicon. Starting from this observation, a first model has been proposed. In order to simulate the devices behavior, we started with an equivalent circuit: once the parameter values are fixed we are able to reproduce the current-voltage characteristics, both in dark conditions and under illumination for different light intensities. After the characterization and the study of the first group of photodetectors, a series of silicon substrates have been made, some with internal junctions in the order to obtain an internal amplification. The surprising result of this research has been that substrates with internal junctions and covered with carbon nanotubes do not showed mechanisms of internal charge multiplication, but simple substrates and without internal junctions have shown mechanisms of charge multiplication. This phenomenon probably is due to the presence of the film of carbon nanotubes

Atmospheric aerosol characterization using the central laser facility at the Pierre Auger Observatory

The Fluorescence Detector of the Pierre Auger Observatory uses the atmosphere as a huge calorimeter that needs continuous monitoring to ensure unbiased physics results. The Central Laser Facility (CLF), a calibrated laser source located near the centre of the Observatory, is used to measure the light attenuation due to aerosols, highly variable even on time scales of one hour. Two independent, fully compatible procedures based on the analysis of CLF vertical events have been developed. Five years of hourly aerosol characterization are provide

Depth of Maximum of Air-Shower Profiles at the Auger Observatory: Measurements at Energies above 10^17.8 eV

We report a study of the distributions of the depth of maximum, Xmax, of extensive air-shower profiles with energies above 1017.8eV as observed with the fluorescence telescopes of the Pierre Auger Observatory. The analysis method for selecting a data sample with minimal sampling bias is described in detail as well as the experimental cross-checks and systematic uncertainties. Furthermore, we discuss the detector acceptance and the resolution of the Xmax measurement and provide parametrizations thereof as a function of energy. The energy dependence of the mean and standard deviation of the Xmax distributions are compared to air-shower simulations for different nuclear primaries and interpreted in terms of the mean and variance of the logarithmic mass distribution at the top of the atmosphere

Reconstruction of inclined air showers detected with the Pierre Auger Observatory

We describe the method devised to reconstruct inclined cosmic-ray air showers with zenith angles greater than 60 degrees detected with the surface array of the Pierre Auger Observatory. The measured signals at the ground level are fitted to muon density distributions predicted with atmospheric cascade models to obtain the relative shower size as an overall normalization parameter. The method is evaluated using simulated showers to test its performance. The energy of the cosmic rays is calibrated using a sub-sample of events reconstructed with both the fluorescence and surface array techniques. The reconstruction method described here provides the basis of complementary analyses including an independent measurement of the energy spectrum of ultra-high energy cosmic rays using very inclined events collected by the Pierre Auger Observatory