242 research outputs found

    Band structure and optical properties of opal photonic crystals

    Full text link
    A theoretical approach for the interpretation of reflectance spectra of opal photonic crystals with fcc structure and (111) surface orientation is presented. It is based on the calculation of photonic bands and density of states corresponding to a specified angle of incidence in air. The results yield a clear distinction between diffraction in the direction of light propagation by (111) family planes (leading to the formation of a stop band) and diffraction in other directions by higher-order planes (corresponding to the excitation of photonic modes in the crystal). Reflectance measurements on artificial opals made of self-assembled polystyrene spheres are analyzed according to the theoretical scheme and give evidence of diffraction by higher-order crystalline planes in the photonic structure.Comment: to appear in PR

    A Combined Ion Implantation/Nanosecond Laser Irradiation Approach towards Si Nanostructures Doping

    Get PDF
    The exploitation of Si nanostructures for electronic and optoelectronic devices depends on their electronic doping. We investigate a methodology for As doping of Si nanostructures taking advantages of ion beam implantation and nanosecond laser irradiation melting dynamics. We illustrate the behaviour of As when it is confined, by the implantation technique, in a SiO2/Si/SiO2multilayer and its spatial redistribution after annealing processes. As accumulation at the Si/SiO2interfaces was observed by Rutherford backscattering spectrometry in agreement with a model that assumes a traps distribution in the Si in the first 2-3 nm above the SiO2/Si interfaces. A concentration of 1014 traps/cm2has been evaluated. This result opens perspectives for As doping of Si nanoclusters embedded in SiO2since a Si nanocluster of radius 1 nm embedded in SiO2should trap 13 As atoms at the interface. In order to promote the As incorporation in the nanoclusters for an effective doping, an approach based on ion implantation and nanosecond laser irradiation was investigated. Si nanoclusters were produced in SiO2layer. After As ion implantation and nanosecond laser irradiation, spectroscopic ellipsometry measurements show nanoclusters optical properties consistent with their effective doping

    Porous silicon bragg reflector and 2D gold-polymer nanograting: a route towards a hybrid optoplasmonic platform

    Get PDF
    Photonic and plasmonic systems have been intensively studied as an effective means to modify and enhance the electromagnetic field. In recent years hybrid plasmonic–photonic systems have been investigated as a promising solution for enhancing light-matter interaction. In the present work we present a hybrid structure obtained by growing a plasmonic 2D nanograting on top of a porous silicon distributed Bragg reflector. Particular attention has been devoted to the morphological characterization of these systems. Electron microscopy images allowed us to determine the geometrical parameters of the structure. The matching of the optical response of both components has been studied. Results indicate an interaction between the plasmonic and the photonic parts of the system, which results in a localization of the electric field profile

    The restoration of the Colosso di Barletta: EDXRF analysis

    Get PDF
    The Colosso di Barletta is an imposing outdoor bronze statue, dating back the V century, located near the Basilica of “Santo Sepolcro” in Barletta (Apulia, Southern Italy). The monument underwent a structural restoration in 1981, during which the Central Institute of Restoration in Rome performed cleaning treatments and consolidation of the patinas. Currently, the Laboratory of Archaeometry of the University of Salento is carrying on a campaign of non-destructive and in situ measurements by using energy dispersion X-ray fluorescence (EDXRF) in order to assess the chemical composition of the alloy and to study its patinas

    Synergic combination of the sol-gel method with dip coating for plasmonic devices

    Get PDF
    Biosensing technologies based on plasmonic nanostructures have recently attracted significant attention due to their small dimensions, low-cost and high sensitivity but are often limited in terms of affinity, selectivity and stability. Consequently, several methods have been employed to functionalize plasmonic surfaces used for detection in order to increase their stability. Herein, a plasmonic surface was modified through a controlled, silica platform, which enables the improvement of the plasmonic-based sensor functionality. The key processing parameters that allow for the fine-tuning of the silica layer thickness on the plasmonic structure were studied. Control of the silica coating thickness was achieved through a combined approach involving sol-gel and dip-coating techniques. The silica films were characterized using spectroscopic ellipsometry, contact angle measurements, atomic force microscopy and dispersive spectroscopy. The effect of the use of silica layers on the optical properties of the plasmonic structures was evaluated. The obtained results show that the silica coating enables surface protection of the plasmonic structures, preserving their stability for an extended time and inducing a suitable reduction of the regeneration time of the chip

    Existence of Heavy Fermions in the Antiferromagnetic Phase of CeIn3

    Full text link
    We report the pressure-dependent optical conductivity spectra of a heavy fermion (HF) compound CeIn3 below the Neel temperature of 10 K to investigate the existence of the HF state in the antiferromagnetic (AFM) phase. The peak due to the interband transition in the hybridization gap between the conduction band and nearly localized 4f states (c-f hybridization) appears at the photon energy of about 20 meV not only in the HF regime but also in the AFM regime. Both the energy and intensity of the c-f hybridization peak continuously increase with the application of pressure from the AFM to the HF regime. This result suggests that the c-f hybridization, as well as the heavy fermions, exists even in the AFM phase of CeIn3.Comment: 5 pages, 3 figure

    Correlation gap in the heavy-fermion antiferromagnet UPd_2Al_3

    Full text link
    The optical properties of the heavy-fermion compound UPd2_2Al3_3 have been measured in the frequency range from 0.04 meV to 5 meV (0.3 to 40 cm1^{-1}) at temperatures 2K<T<3002 {\rm K}<T< 300 K. Below the coherence temperature T50T^*\approx 50 K, the hybridization gap opens around 10 meV. As the temperature decreases further (T20T\leq 20 K), a well pronounced pseudogap of approximately 0.2 meV develops in the optical response; we relate this to the antiferromagnetic ordering which occurs below TN14T_N\approx 14 K. The frequency dependent mass and scattering rate give evidence that the enhancement of the effective mass mainly occurs below the energy which is associated to the magnetic correlations between the itinerant and localized 5f electrons. In addition to this correlation gap, we observe a narrow zero-frequency conductivity peak which at 2 K is less than 0.1 meV wide, and which contains only a fraction of the delocalized carriers. The analysis of the spectral weight infers a loss of kinetic energy associated with the superconducting transition.Comment: RevTex, 15 pages, 7 figure

    Infrared and optical spectroscopy of alpha and gamma-phase Ce

    Get PDF
    We determined the optical properties of alpha- and gamma-phase Ce in the photon energy range from 60 meV to 2.5 eV using ellipsometry and grazing incidence reflectometry. We observe significant changes of the optical conductivity, the dynamical scattering rate, and the effective mass between alpha- and gamma-cerium. The alpha-phase is characterized by Fermi-liquid frequency dependent scattering rate, and an effective mass of about 20 m_e on an energy scale of about 0.2 eV. In gamma-Ce the charge carriers have a large scattering rate in the far infrared, and a carrier mass characteristic of 5d band electrons. In addition we observe a prominent absorption feature in alpha-Ce, which is absent in gamma-Ce, indicating significant differences of the electronic structure between the two phases.Comment: 5 pages, REVTeX, 2 eps-figures, Phys.Rev.Lett., in pres

    Optical study of the electronic phase transition of strongly correlated YbInCu_4

    Full text link
    Infrared, visible and near-UV reflectivity measurements are used to obtain conductivity as a function of temperature and frequency in YbInCu_4, which exhibits an isostructural phase-transition into a mixed-valent phase below T_v=42 K. In addition to a gradual loss of spectral weight with decreasing temperature extending up to 1.5 eV, a sharp resonance appears at 0.25 eV in the mixed-valent phase. This feature can be described in terms of excitations into the Kondo (Abrikosov-Suhl) resonance, and, like the sudden reduction of resistivity, provides a direct reflection of the onset of coherence in this strongly correlated electron system.Comment: 4 pages, 3 figures (to appear in Phys. Rev. B

    Universal scaling in the dynamical conductivity of heavy fermion Ce and Yb compounds

    Full text link
    Dynamical conductivity spectra s(w) have been measured for a diverse range of heavy-fermion (HF) Ce and Yb compounds. A characteristic excitation peak has been observed in the mid-infrared region of s(w) for all the compounds, and has been analyzed in terms of a simple model based on conduction (c)-f electron hybridized band. A universal scaling is found between the observed peak energies and the estimated c-f hybridization strengths of these HF compounds. This scaling demonstrates that the model of c-f hybridized band can generally and quantitatively describe the charge excitation spectra of a wide range of HF compounds.Comment: 5 pages, 1 table, 3 figures, to appear in J. Phys. Soc. Jpn. 76 (2007
    corecore