577 research outputs found

    Low-Frequency Characterization of Switched dc-dc Converters

    Get PDF
    Averaging techniques are developed here to represent buck, boost, and buck-boost types of switched dc-dc converters by approximate continuous models. Simple analytical expressions in terms of the circuit components are derived for the characteristic transient and frequency responses of timeaveraged (continuous) power-stage models for use in designing and understanding the behavior of corresponding switched power stages. Novel conclusions include the dependence of effective circuit component values upon switch duty ratio and the existence of a real positive zero in certain transfer functions. Responses from analog computer simulations of the switched and averaged power stages agree well and, in turn, confirm the analytic predictions. High-order systems can be analyzed by the averaging technique without a commensurate increase in complexity

    Direct-write electron-beam lithography of an IR antenna-coupled microbolometer onto the surface of a hemispherical lens

    Get PDF
    This article describes a method for performing direct-write lithography of an IR antenna-coupled microbolometer onto the surface of a hemispherical lens. Antennas on a dielectric half-space receive power more efficiently from the substrate side than from the air side. The use of a hemispherical lens facilitates reception through the substrate as well as elimination of trapped surface waves that would normally occur in the substrate. Using direct-write lithography onto the surface of the hemispherical lens eliminates the potential of an air gap between the antenna and lens. Additionally, the accuracy of alignment between the antenna and the center of the lens is controlled at the lithographic step. As a result, there is increased responsivity is observed in the antenna-coupled microbolometer when illuminated from the substrate-side compared to air-side illumination. (c) 2006 American Vacuum Society

    Reassessing the Fighting Performance of Conscript Soldiers During the Malvinas/Falklands War (1982)

    Full text link
    While the idea is controversial, it is quite possible that, at least under certain circumstances, the fighting effectiveness of a conscript army can equal that of a professional army. For any army, fighting effectiveness is not only influenced by the degree of psychological cohesion among soldiers and officers, but also by the organizational culture of each particular service unit towards the preparation for war and the waging of the conflict itself. The Malvinas (Falklands) War of 1982 demonstrates this very well. In this war, two different types of armies confronted one another: the British army, a professional and all volunteer force, and the Argentine army constituted principally of conscripted soldiers. In this regard, some analysts assert that the British concept was vindicated when a force of British professional soldiers defeated an opposing Argentine force of draftees twice as numerous. Analysts in general have rated the capabilities of the Argentine land forces as poor, although there were exceptions and some units performed very well. These cases deserve to be studied. Notably, the most effective Argentine effort came from some small Army units and one Navy unit, the 5th Marine Battalion. For these units, two primary reasons account for the differences in fighting performance. First, small Army groups fought well because there was cohesion among their components, conscripts, noncommissioned officers, and junior officers, especially by the attitude of the latter. Secondly, in the case of the Marine battalion, its performance was the product not only of good training, but also of the different institutional approach to waging war that the Argentine Navy employed. These, in turn, improved cohesion. By focusing upon these units and their effectiveness, a rather new picture of the Malvinas War comes to light that differs quite substantially from those drawn in the immediate aftermath of the war itself. It should also make us rethink the lessons of the war, including those that surround the professionals versus conscripts controversy

    Can modeling and simulation really help power system designers?

    Get PDF
    The rap session provided an informal forum for dissemination of information on the state of the art in modeling and simulation of power processing systems. Merits of time domain and frequency domain approaches were debated and the use of these techniques for the prediction of performance and the optimization of a design were discussed. Although it appears that the present state of the art is somethat primative, interest is high and continued progress and improvement should be forthcoming

    Wintertime Spatial Distribution of Ammonia and its Emission Sources in the Great Salt Lake Region

    Get PDF
    Ammonium-containing aerosols are a major component of wintertime air pollution in many densely populated regions around the world. Especially in mountain basins, the formation of persistent cold-air pools (PCAPs) can enhance particulate matter with diameters less than 2.5 µm (PM2.5) to levels above air quality standards. Under these conditions, PM2.5 in the Great Salt Lake region of northern Utah has been shown to be primarily composed of ammonium nitrate; however, its formation processes and sources of its precursors are not fully understood. Hence, it is key to understanding the emission sources of its gas phase precursor, ammonia (NH3). To investigate the formation of ammonium nitrate, a suite of trace gases and aerosol composition were sampled from the NOAA Twin Otter aircraft during the Utah Winter Fine Particulate Study (UWFPS) in January and February 2017. NH3 was measured using a quantum cascade tunable infrared laser differential absorption spectrometer (QC-TILDAS), while aerosol composition, including particulate ammonium (pNH4), was measured with an aerosol mass spectrometer (AMS). The origin of the sampled air masses was investigated using the Stochastic Time-Inverted Lagrangian Transport (STILT) model and combined with an NH3 emission inventory to obtain model-predicted NHx (=NH3+pNH4) enhancements. Enhancements represent the increase in NH3 mixing ratios within the last 24 h due to emissions within the model footprint. Comparison of these NHx enhancements with measured NHx from the Twin Otter shows that modelled values are a factor of 1.6 to 4.4 lower for the three major valleys in the region. Among these, the underestimation is largest for Cache Valley, an area with intensive agricultural activities. We find that one explanation for the underestimation of wintertime emissions may be the seasonality factors applied to NH3 emissions from livestock. An investigation of inter-valley exchange revealed that transport of NH3 between major valleys was limited and PM2.5 in Salt Lake Valley (the most densely populated area in Utah) was not significantly impacted by NH3 from the agricultural areas in Cache Valley. We found that in Salt Lake Valley around two thirds of NHx originated within the valley, while about 30 % originated from mobile sources and 60 % from area source emissions in the region. For Cache Valley, a large fraction of NOx potentially leading to PM2.5 formation may not be locally emitted but mixed in from other counties

    Low Dose Aerosol Fitness at the Innate Phase of Murine Infection Better Predicts Virulence amongst Clinical Strains of Mycobacterium tuberculosis

    Get PDF
    Background: Evaluation of a quick and easy model to determine the intrinsic ability of clinical strains to generate active TB has been set by assuming that this is linked to the fitness of Mycobacterium tuberculosis strain at the innate phase of the infection. Thus, the higher the bacillary load, the greater the possibility of inducting liquefaction, and thus active TB, once the adaptive response is set. Methodology/Principal Findings: The virulence of seven clinical Mycobacterium tuberculosis strains isolated in Spain was tested by determining the bacillary concentration in the spleen and lung of mice at weeks 0, 1 and 2 after intravenous (IV) inoculation of 10 4 CFU, and by determining the growth in vitro until the stationary phase had been reached. Cord distribution automated analysis showed two clear patterns related to the high and low fitness in the lung after IV infection. This pattern was not seen in the in vitro fitness tests, which clearly favored the reference strain (H37Rv). Subsequent determination using a more physiological low-dose aerosol (AER) inoculation with 10 2 CFU showed a third pattern in which the three best values coincided with the highest dissemination capacity according to epidemiological data. Conclusions/Significance: The fitness obtained after low dose aerosol administration in the presence of the innate immune response is the most predictive factor for determining the virulence of clinical strains. This gives support to a mechanism o

    Aerosol direct radiative effects over the northwest Atlantic, northwest Pacific, and North Indian Oceans: estimates based on in-situ chemical and optical measurements and chemical transport modeling

    Get PDF
    International audienceThe largest uncertainty in the radiative forcing of climate change over the industrial era is that due to aerosols, a substantial fraction of which is the uncertainty associated with scattering and absorption of shortwave (solar) radiation by anthropogenic aerosols in cloud-free conditions (IPCC, 2001). Quantifying and reducing the uncertainty in aerosol influences on climate is critical to understanding climate change over the industrial period and to improving predictions of future climate change for assumed emission scenarios. Measurements of aerosol properties during major field campaigns in several regions of the globe during the past decade are contributing to an enhanced understanding of atmospheric aerosols and their effects on light scattering and climate. The present study, which focuses on three regions downwind of major urban/population centers (North Indian Ocean (NIO) during INDOEX, the Northwest Pacific Ocean (NWP) during ACE-Asia, and the Northwest Atlantic Ocean (NWA) during ICARTT), incorporates understanding gained from field observations of aerosol distributions and properties into calculations of perturbations in radiative fluxes due to these aerosols. This study evaluates the current state of observations and of two chemical transport models (STEM and MOZART). Measurements of burdens, extinction optical depth (AOD), and direct radiative effect of aerosols (DRE ? change in radiative flux due to total aerosols) are used as measurement-model check points to assess uncertainties. In-situ measured and remotely sensed aerosol properties for each region (mixing state, mass scattering efficiency, single scattering albedo, and angular scattering properties and their dependences on relative humidity) are used as input parameters to two radiative transfer models (GFDL and University of Michigan) to constrain estimates of aerosol radiative effects, with uncertainties in each step propagated through the analysis. Constraining the radiative transfer calculations by observational inputs increases the clear-sky, 24-h averaged AOD (34±8%), top of atmosphere (TOA) DRE (32±12%), and TOA direct climate forcing of aerosols (DCF ? change in radiative flux due to anthropogenic aerosols) (37±7%) relative to values obtained with "a priori" parameterizations of aerosol loadings and properties (GFDL RTM). The resulting constrained TOA DCF is ?3.3±0.47, ?14±2.6, ?6.4±2.1 Wm?2 for the NIO, NWP, and NWA, respectively. Constraining the radiative transfer calculations by observational inputs reduces the uncertainty range in the DCF in these regions relative to global IPCC (2001) estimates by a factor of approximately 2. Such comparisons with observations and resultant reductions in uncertainties are essential for improving and developing confidence in climate model calculations incorporating aerosol forcing

    Instrumentation and Measurement Strategy for the NOAA SENEX Aircraft Campaign as Part of the Southeast Atmosphere Study 2013

    Get PDF
    Natural emissions of ozone-and-aerosol-precursor gases such as isoprene and monoterpenes are high in the southeastern US. In addition, anthropogenic emissions are significant in the southeastern US and summertime photochemistry is rapid. The NOAA-led SENEX (Southeast Nexus) aircraft campaign was one of the major components of the Southeast Atmosphere Study (SAS) and was focused on studying the interactions between biogenic and anthropogenic emissions to form secondary pollutants. During SENEX, the NOAA WP-3D aircraft conducted 20 research flights between 27 May and 10 July 2013 based out of Smyrna, TN. Here we describe the experimental approach, the science goals and early results of the NOAA SENEX campaign. The aircraft, its capabilities and standard measurements are described. The instrument payload is summarized including detection limits, accuracy, precision and time resolutions for all gas-and-aerosol phase instruments. The inter-comparisons of compounds measured with multiple instruments on the NOAA WP-3D are presented and were all within the stated uncertainties, except two of the three NO2 measurements. The SENEX flights included day- and nighttime flights in the southeastern US as well as flights over areas with intense shale gas extraction (Marcellus, Fayetteville and Haynesville shale). We present one example flight on 16 June 2013, which was a daytime flight over the Atlanta region, where several crosswind transects of plumes from the city and nearby point sources, such as power plants, paper mills and landfills, were flown. The area around Atlanta has large biogenic isoprene emissions, which provided an excellent case for studying the interactions between biogenic and anthropogenic emissions. In this example flight, chemistry in and outside the Atlanta plumes was observed for several hours after emission. The analysis of this flight showcases the strategies implemented to answer some of the main SENEX science questions
    • …
    corecore