3,829 research outputs found

    Tests of sunspot number sequences: 2. Using geomagnetic and auroral data

    Get PDF
    We compare four sunspot-number data sequences against geomagnetic and terrestrial auroral observations. The comparisons are made for the original SIDC (Solar Influences Data Center) composite of Wolf/ZĂŒrich/International sunspot number [RISNv1], the group sunspot number [RG] by Hoyt and Schatten (Solar Phys., 181, 491, 1998), the new “backbone” group sunspot number [RBB] by Svalgaard and Schatten (Solar Phys., doi: 10.1007/s11207-015-0815-8, 2016), and the “corrected” sunspot number [RC] by Lockwood, Owens, and Barnard (J. Geophys. Res., 119, 5172, 2014). Each sunspot number is fitted with terrestrial observations, or parameters derived from terrestrial observations to be linearly proportional to sunspot number, over a 30-year calibration interval of 1982 - 2012. The fits are then used to compute test sequences, which extend further back in time and which are compared to RISNv1, RG, RBB, and RC. To study the long-term trends, comparisons are made using averages over whole solar cycles (minimum-to-minimum). The test variations are generated in four ways: i) using the IDV(1d) and IDV geomagnetic indices (for 1845 - 2013) fitted over the calibration interval using the various sunspot numbers and the phase of the solar cycle; ii) from the open solar flux (OSF) generated for 1845 - 2013 from four pairings of geomagnetic indices by Lockwood et al. (Ann. Geophys., 32, 383, 2014) and analysed using the OSF continuity model of Solanki, SchĂŒssler, and Fligge (Nature, 408, 445, 2000) which employs a constant fractional OSF loss rate; iii) the same OSF data analysed using the OSF continuity model of Owens and Lockwood (J. Geophys. Res., 117, A04102, 2012) in which the fractional loss rate varies with the tilt of the heliospheric current sheet and hence with the phase of the solar cycle; iv) the occurrence frequency of low-latitude aurora for 1780 - 1980 from the survey of Legrand and Simon (Ann. Geophys., 5, 161, 1987). For all cases, RBB exceeds the test terrestrial series by an amount that increases as one goes back in time

    Extended γ‐ray emission in solar flares

    Get PDF
    During the solar flare events on 11 and 15 June 1991, COMPTEL measured extended emission in the neutron capture line for about 5 hours after the impulsive phase. The time profiles can be described by a double exponential decay with decay constants on the order of 10 min for the fast and 200 min for the slow component. Within the statistical uncertainty both flares show the same long‐term behaviour. The spectrum during the extended phase is significantly harder than during the impulsive phase and pions are not produced in significant numbers before the beginning of the extended emission. Our results with the measurements of others allow us to rule out long‐term trapping of particles in non‐turbulent loops to explain the extended emission of these two flares and our data favour models based on continued acceleration

    Power law creep and delayed failure of gels and fibrous materials under stress

    Get PDF
    Motivated by recent experiments studying the creep and breakup of a protein gel under stress, we introduce a simple mesoscopic model for the irreversible failure of gels and fibrous materials, and demonstrate it to capture much of the phenomenology seen experimentally. This includes a primary creep regime in which the shear rate decreases as a power law over several decades of time, a secondary crossover regime in which the shear rate attains a minimum, and a tertiary regime in which the shear rate increases dramatically up to a finite time singularity, signifying irreversible material failure. The model also captures a linear Monkman–Grant scaling of the failure time with the earlier time at which the shear rate attained its minimum, and a Basquin-like power law scaling of the failure time with imposed stress, as seen experimentally. The model furthermore predicts a slow accumulation of low levels of material damage during primary creep, followed by the growth of fractures leading to sudden material failure, as seen experimentally
    • 

    corecore