Electro-optic comb based real time ultra-high sensitivity phase noise measurement system for high frequency microwaves

Recent progress in ultra low phase noise microwave generation indispensably depends on ultra low phase noise characterization systems. However, achieving high sensitivity currently relies on time consuming averaging via cross correlation, which sometimes even underestimates phase noise because of residual correlations. Moreover, extending high sensitivity phase noise measurements to microwaves beyond 10 GHz is very difficult because of the lack of suitable high frequency microwave components. In this work, we introduce a delayed self-heterodyne method in conjunction with sensitivity enhancement via the use of higher order comb modes from an electro-optic comb for ultra-high sensitivity phase noise measurements. The method obviates the need for any high frequency RF components and has a frequency measurement range limited only by the bandwidth (100 GHz) of current electro-optic modulators. The estimated noise floor is as low as −133 dBc/Hz, −155 dBc/Hz, −170 dBc/Hz and −171 dBc/Hz without cross correlation at 1 kHz, 10 kHz, 100 kHz and 1 MHz Fourier offset frequency for a 10 GHz carrier, respectively. Moreover, since no cross correlation is necessary, RF oscillator phase noise can be directly suppressed via feedback up to 100 kHz frequency offset

A photonic frequency discriminator based on a two wavelength delayed self-heterodyne interferometer for low phase noise tunable micro/mm wave synthesis

Low phase noise frequency synthesizers are of paramount interest in many areas of micro-mm wave technology, encompassing for example advanced wireless communication, radar, radio-astronomy, and precision instrumentation. Although this broad research field is not bereft of methods for the generation of either low phase noise micro- or mm waves, no universal system applicable to low phase noise generation for micro and mm waves has yet been demonstrated. Here we propose a new photonic frequency discriminator based on a two wavelength delayed self-heterodyne interferometer which is compatible with such an objective. The photonic frequency discriminator can be a reference both for micro and mm waves to lower their phase noise. As a proof-of-concept, we demonstrate a low phase noise tunable OEO (6–18 GHz) and locking of a heterodyne beat between two cw lasers (10–400 GHz) with low relative phase noise. The required components for the photonic frequency discriminator are off-the-shelf and can be readily assembled. We believe this new type of photonic frequency discriminator will enable a new generation of universal precision tunable sources for the X, K, V, W and mm-bands and beyond

Poly(2-cyclopropyl-2-oxazoline): from rate acceleration by Cyclopropyl to Thermoresponsive properties

The synthesis and microwave-assisted living cationic ring-opening polymerization of 2-cyclopropyl-2-oxazoline is reported revealing the fastest polymerization for an aliphatic substituted 2-oxazoline to date, which is ascribed to the electron withdrawing effect of the cyclopropyl group. The poly(2-cyclopropyl-2-oxazoline) (pCPropOx) represents an alternative thermo-responsive poly(2-oxazoline) with a reversible critical temperature close to body temperature. The cloud point (CP) of the obtained pCPropOx in aqueous solution was evaluated in detail by turbidimetry, dynamic light scattering (DLS) and viscosity measurements. pCPropOx is amorphous with a significantly higher glass transition temperature (T(g) similar to 80 degrees C) compared to the amorphous poly(2-n-propyl-2-oxazoline) (pnPropOx) (T(g) similar to 40 degrees C), while poly(2-isopropyl-2-oxazoline) piPropOx is semicrystalline. In addition, a pCPropOx comb polymer was prepared by methacrylic acid end-capping of the living cationic species followed by RAFT polymerization of the macromonomer. The polymer architecture does not influence the concentration dependence of the CP, however, both the CP and T(g) of the comb polymer are lower due to the increased number of hydrophobic end groups

Neither maternal nor fetal mutation (E474Q) in the α-subunit of the trifunctional protein is frequent in pregnancies complicated by HELLP syndrome

Objective: An association between maternal HELLP syndrome and fetal long chain 3-hydroxyacyl-CoA dehydrogenase (LCHAD) deficiency has been proposed. LCHAD catalyzes the third step in the β-oxidation of fatty acids in mitochondria. Whereas about 75% of LCHAD-deficient patients carry a G-to-C mutation at nucleotide position 1528 (Glu474Gln, E474Q) on both chromosomes, compound heterozygosity for E474Q on one chromosome and a second different LCHAD mutation on the other can be observed in up to 25% of LCHAD-deficiency cases; only very few patients carry two mutations different from E474Q. Genetic analysis of the mother alone is insufficient in case of compound heterozygosity. Since information on the fetal carrier status of the E474Q mutation in maternal HELLP syndrome is rare, we investigated the frequency of the E474Q mutation in families where the mother had HELLP syndrome. Methods: The occurrence of the E474Q mutation was analyzed by PCR and RFLP in 103 mothers with HELLP syndrome, in 82 children of affected pregnancies and in 21 fathers in families where fetal DNA was not available. In addition, 103 control women with only uncomplicated pregnancies were investigated. Results: The mutation E474Q was not detected in the study population. Conclusion: Neither maternal nor fetal heterozygosity for the E474Q mutation is a relevant factor of HELLP syndrom

Filling-in of Far-Red and Near-Infrared Solar Lines by Terrestrial and Atmospheric Effects: Simulations and Space-Based Observations from SCHIAMACHY and GOSAT

Mapping of terrestrial vegetation fluorescence from space is of interest because it can potentially provide global information on the functional status of vegetation including light use efficiency and global primary productivity that can be used for global carbon cycle modeling. Space-based measurement of solar-induced chlorophyll fluorescence is challenging, because its signal is small as compared with the much larger reflectance signal. Ground- and aircraft-based approaches have made use of the dark and spectrally-wide 02-A (approx 760 nm) and O2-B (approx 690 nm) atmospheric features to detect the weak fluorescence signal. More recently, Joiner et a1. and Frankenberg et a1. focused on longer-wavelength solar Fraunhofer lines that can be observed with space-based instruments such as the currently operational GOSAT. They showed that fluorescence can be detected using Fraunhofer lines away from the far-red chlorophyll-a fluorescence peak even when the surface is relatively bright. Here, we build on that work by developing methodology to correct for instrumental artifacts that produce false filling-in signals that can bias fluorescence retrievals. We also examine other potential sources of filling-in at far-red and NIR wavelengths. Another objective is to explore the possibility of making fluorescence measurements from space with lower spectral resolution instrumentation than the GOSAT interferometer. We focus on the 866 nm Ca II solar Fraunhofer line. Very few laboratory and ground-based measurements of vegetation fluorescence have been reported at wavelengths longer than 800 mn. Some results of fluorescence measurements of corn leaves acquired in the laboratory using polychromatic excitation at wavelengths shorter than 665 nm show that at 866 nm, the measured signal is of the order of 0.1-0.2 mw/sq m/nm/sr. In this work we use the following satellite observations: We use SCIAMACHY channel 5 in nadir mode that covers wavelengths between 773 and 1063 nm at a spectral resolution of 0.54 nm. GOSAT has two instrument packages: the Thermal And Near-infrared Sensor for carbon Observation-Fourier Transform Spectrometer (TANSO-FTS) and the Cloud and Aerosol Imager (CAI). We use TANSO-FTS band 1, which extends from approximately 758 to 775 mn and we use cloud fraction derived from the CAL We compare satellite-derived fluorescence with the Enhanced Vegetation Index (EVI), an Aqua/MODIS-derived vegetation reflectance-based index that indicates relative greenness and is used to infer photosynthetic function

Variable-range hopping in quasi-one-dimensional electron crystals

We study the effect of impurities on the ground state and the low-temperature dc transport in a 1D chain and quasi-1D systems of many parallel chains. We assume that strong interactions impose a short-range periodicicity of the electron positions. The long-range order of such an electron crystal (or equivalently, a $4 k_F$ charge-density wave) is destroyed by impurities. The 3D array of chains behaves differently at large and at small impurity concentrations $N$. At large $N$, impurities divide the chains into metallic rods. The low-temperature conductivity is due to the variable-range hopping of electrons between the rods. It obeys the Efros-Shklovskii (ES) law and increases exponentially as $N$ decreases. When $N$ is small, the metallic-rod picture of the ground state survives only in the form of rare clusters of atypically short rods. They are the source of low-energy charge excitations. In the bulk the charge excitations are gapped and the electron crystal is pinned collectively. A strongly anisotropic screening of the Coulomb potential produces an unconventional linear in energy Coulomb gap and a new law of the variable-range hopping $-\ln\sigma \sim (T_1 / T)^{2/5}$. $T_1$ remains constant over a finite range of impurity concentrations. At smaller $N$ the 2/5-law is replaced by the Mott law, where the conductivity gets suppressed as $N$ goes down. Thus, the overall dependence of $\sigma$ on $N$ is nonmonotonic. In 1D, the granular-rod picture and the ES apply at all $N$. The conductivity decreases exponentially with $N$. Our theory provides a qualitative explanation for the transport in organic charge-density wave compounds.Comment: 20 pages, 7 figures. (v1) The abstract is abridged to 24 lines. For the full abstract, see the manuscript (v2) several changes in presentation per referee's comments. No change in result

All polarization-maintaining Er fiber-based optical frequency combs with nonlinear amplifying loop mirror.

A fully stabilized all polarization-maintaining Er frequency comb with a nonlinear amplifying loop mirror with below 0.2 rad carrier-envelope-offset frequency phase noise is demonstrated. The integrated timing jitter is measured as 40 attosecond from 10 kHz to 10 MHz, which is the lowest value of any Er fiber frequency comb to date

The Geography of the International System: The CShapes Dataset

We describe CShapes, a new dataset that provides historical maps of state boundaries and capitals in the post-World War II period. The dataset is coded according to both the Correlates of War and the Gleditsch and Ward (1999) state lists, and is therefore compatible with a great number of existing databases in the discipline. Provided in a geographic data format, CShapes can be used directly with standard GIS software, allowing a wide range of spatial computations. In addition, we supply a CShapes package for the R statistical toolkit. This package enables researchers without GIS skills to perform various useful operations on the GIS maps. The paper introduces the CShapes dataset and structure and gives three examples of how to use CShapes in political science research. First, we show how results from quantitative analysis can be depicted intuitively as a map. The second application gives an example of computing indicators on the CShapes maps, which can then be used in statistical tests. Third, we illustrate the use of CShapes for generating different weights matrices in spatial statistical applications. All the examples can be replicated using the freely available R package and do not require specialized GIS skills. The dataset is available for download from the CShapes website (http://nils.weidmann.ws/projects/cshapes). © Taylor & Francis Group, LLC