Laser-zone Growth in a Ribbon-to-ribbon (RTR) Process Silicon Sheet Growth Development for the Large Area Silicon Sheet Task of the Low Cost Solar Array Project

A technique for growing limited-length ribbons continually was demonstrated. This Rigid Edge technique can be used to recrystallize about 95% of the polyribbon feedstock. A major advantage of this method is that only a single, constant length silicon ribbon is handled throughout the entire process sequence; this may be accomplished using cassettes similar to those presently in use for processing Czochralski waters. Thus a transition from Cz to ribbon technology can be smoothly affected. The maximum size being considered, 3 inches x 24 inches, is half a square foot, and will generate 6 watts for 12% efficiency at 1 sun. Silicon dioxide has been demonstrated as an effective, practical diffusion barrier for use during the polyribbon formation

Bone measurements and body weights from some Australian feral pigs

A small sample of pig skulls and part-skeletons from Australian feral pigs is described below. The specimens were collected in the initial stage of a research project intended to look at the process of animal domestication when going in reverse, as with the feral pigs of Australia. However, this project was never completed. The data below is offered in the hope that it is sufficient to be useful to those with an interest in pig osteology, and perhaps to encourage further work

Measurements of total alkalinity and inorganic dissolved carbon in the Atlantic Ocean and adjacent Southern Ocean between 2008 and 2010

Water column dissolved inorganic carbon and total alkalinity were measured during five hydrographic sections in the Atlantic Ocean and Drake Passage. The work was funded through the Strategic Funding Initiative of the UK's Oceans2025 programme, which ran from 2007 to 2012. The aims of this programme were to establish the regional budgets of natural and anthropogenic carbon in the North Atlantic, the South Atlantic, and the Atlantic sector of the Southern Ocean, as well as the rates of change of these budgets. This paper describes in detail the dissolved inorganic carbon and total alkalinity data collected along east–west sections at 47° N to 60° N, 24.5° N, and 24° S in the Atlantic and across two Drake Passage sections. Other hydrographic and biogeochemical parameters were measured during these sections, and relevant standard operating procedures are mentioned here. Over 95% of dissolved inorganic carbon and total alkalinity samples taken during the 24.5° N, 24° S, and the Drake Passage sections were analysed onboard and subjected to a first-level quality control addressing technical and analytical issues. Samples taken along 47° N to 60° N were analysed and subjected to quality control back in the laboratory. Complete post-cruise second-level quality control was performed using cross-over analysis with historical data in the vicinity of measurements, and data were submitted to the CLIVAR and Carbon Hydrographic Data Office (CCHDO), the Carbon Dioxide Information Analysis Center (CDIAC) and and will be included in the Global Ocean Data Analyses Project, version 2 (GLODAP 2), the upcoming update of Key et al. (2004)

Optimized delivery of siRNA into 3D tumor spheroid cultures in situ

3D tissue culture provides a physiologically relevant and genetically tractable system for studying normal and malignant human tissues. Despite this, gene-silencing studies using siRNA has proved difficult. In this study, we have identified a cause for why traditional siRNA transfection techniques are ineffective in eliciting gene silencing in situ within 3D cultures and proposed a simple method for significantly enhancing siRNA entry into spheroids/organoids. In 2D cell culture, the efficiency of gene silencing is significantly reduced when siRNA complexes are prepared in the presence of serum. Surprisingly, in both 3D tumour spheroids and primary murine organoids, the presence of serum during siRNA preparation rapidly promotes entry and internalization of Cy3-labelled siRNA in under 2 hours. Conversely, siRNA prepared in traditional low-serum transfection media fails to gain matrigel or spheroid/organoid entry. Direct measurement of CTNNB1 mRNA (encoding β-catenin) from transfected tumour spheroids confirmed a transient but significant knockdown of β-catenin when siRNA:liposome complexes were formed with serum, but not when prepared in the presence of reduced-serum media (Opti-MEM). Our studies suggest a simple modification to standard lipid-based transfection protocols facilitates rapid siRNA entry and transient gene repression, providing a platform for researchers to improve siRNA efficiency in established 3D cultures

Foveal visual acuity is worse and shows stronger contour interaction effects for contrast-modulated than luminance-modulated Cs

Contrast-modulated (CM) stimuli are processed by spatial mechanisms that operate at larger spatial scales than those processing luminance-modulated (LM) stimuli and may be more prone to deficits in developing, amblyopic, and aging visual systems. Understanding neural mechanisms of contour interaction or crowding will help in detecting disorders of spatial vision. In this study, contour interaction effects on visual acuity for LM and CM C and bar stimuli are assessed in normal foveal vision. In Experiment 1, visual acuity is measured for all-LM and all-CM stimuli, at ~3.5× above their respective modulation thresholds. In Experiment 2, visual acuity is measured for Cs and bars of different type (LM C with CM bars and vice versa). Visual acuity is degraded for CM compared with LM Cs (0.46 ± 0.04 logMAR vs. 0.18 ± 0.04 logMAR). With nearby bars, CM acuity is degraded further (0.23 ± 0.01 logMAR or ~2 lines on an acuity chart), significantly more than LM acuity (0.11 ± 0.01 logMAR, ~1 line). Contour interaction for CM stimuli extends over greater distances (arcmin) than it does for LM stimuli, but extents are similar with respect to acuities (~3.5× the C gap width). Contour interaction is evident when the Cs and bars are defined differently: it is stronger when an LM C is flanked by CM bars (0.17 ± 0.03 logMAR) than when a CM C is flanked by LM bars (0.08 ± 0.02 logMAR). Our results suggest that contour interaction for foveally viewed acuity stimuli involves feature integration, such that the outputs of receptive fields representing Cs and bars are combined. Contour interaction operates at LM and CM representational stages, it can occur across stage, and it is enhanced at the CM stage. Greater contour interaction for CM Cs and bars could hold value for visual acuity testing and earlier diagnosis of conditions for which crowding is important, such as in amblyopia

Laser-zone growth in a Ribbon-To-Ribbon (RTR) process. Silicon sheet growth development for the large area silicon sheet task of the low cost silicon solar array project

The Ribbon-to-Ribbon (RTR) approach to silicon ribbon growth is investigated. An existing RTR apparatus is to be upgraded to its full capabilities and operated routinely to investigate and optimize the effects of various growth parameters on growth results. A new RTR apparatus was constructed to incorporate increased capabilities and improvements over the first apparatus and to be capable of continuous growth. New high power lasers were implemented and this led to major improvements in growth velocity -- 4 inch/min. growth has been demonstrated. A major step in demonstration of the full feasibility of the RTR process is reported in the demonstration of RTR growth from CVD polyribbon rather than sliced polyribbon ingots. Average solar cell efficiencies of greater than 9% and a best cell efficiency of 11.7% are reported. Processing was shown to provide a substantial improvement in material minority carrier diffusion length. An economic analysis is reported which treats both the polyribbon fabrication and RTR processes

Laser-zone growth in a Ribbon-To-Ribbon (RTR) process. Silicon sheet growth development for the large area sheet task of the low-cost solar array project

A new calculation of the effects of thermal stresses during growth on silicon ribbon quality is reported. Thermal stress distributions are computed for ribbon growth under a variety of temperature profiles. A growth rate of 55 cu cm/min with a single ribbon was achieved. The growth of RTR ribbon with a fairly uniform parallel dendritic structure was demonstrated. Results with two approaches were obtained for reducing the Mo impurity level in polycrystalline feedstock. Coating the Mo substrate with Si3N4 does not effect thermal shear separation of the polyribbon; this process shows promise of improving cell efficiency and also increasing the useful life of the molybdenum substrate. A number of solar cells were fabricated on RTR silicon grown from CVD feedstock