Seasonal variations of atmospheric C2-C7 nonmethane hydrocarbons in Tokyo

Eighteen C2-C7 NMHCs (nonmethane hydrocarbons) were measured hourly during the Integrated Measurement Program for Aerosol and Oxidant Chemistry in Tokyo (IMPACT) measurement campaigns conducted in central Tokyo during four different periods (summer/autumn of 2003 and winter/summer of 2004). The ambient atmospheric concentrations of NMHCs showed an inverse correlation with wind speed and mixing height and were significantly affected by mesoscale weather conditions. The mixing ratio of isoprene tightly correlated with solar flux and temperature in summer, as it was dominantly emitted by the local vegetation. All the observed NMHCs except isoprene showed high correlation with each other in winter (r2 > 0.5), suggesting concurrent accumulation under stagnant condition and common sources. Emission ratios were calculated on the basis of the correlation with carbon monoxide and ethyne. Compared to the typical winter NMEC composition, during summer there was a significant increase (up to 7 times higher than wintertime) of C4-C5 alkanes from ftiel evaporation; of C2-C3 alkenes, n-hexane and benzene from chemical industry; and of toluene from local manufacturers, reflecting the temperature dependence of these evaporative emissions. In addition to the online measurements in Tokyo, canister sampling at a suburban site (Kisai) followed by multidimensional GC analyses was conducted during the summer campaign in 2004. The atmospheric concentrations of longer-lived compounds (≥ several days) at Kisai showed the buildup under sea breeze circulation. The average ambient, concentration of toluene was 2 times higher than that in central Tokyo, likely because of substantial emissions from local industries as reported in the prefectural statistics. Copyright 2007 by the American Geophysical Union

Evolution of mixing state of black carbon particles: Aircraft measurements over the western Pacific in March 2004

We report the evolution of the mixing state of black carbon (BC) particles in urban plumes measured by an airborne single particle soot photometer. The aircraft observations were conducted over the ocean near the coast of Japan in March 2004. The number fiaction of coated BC particles with a core diameter of 180 mn increased from 0.35 to 0.63 within 12 hours (h), namely 2.3% h-1, after being emitted from the Nagoya urban area in Japan. BC particles with a core diameter of 250 nm increased at the slower rate of 1.0% h-1. The increase in coated BC particles was associated with increases in non-sea salt sulfate and water-soluble organic carbon by a factor of approximately two, indicating that these compounds contributed to the coating on the BC particles. These results give direct evidence that BC particles become internally mixed on a time scale of 12 h in urban plumes. Copyright 2007 by the American Geophysical Union

Seasonal cycles of ozone and oxidized nitrogen species in northeast Asia - 2:A model analysis of the roles of chemistry and transport

[1] The dominant factors controlling the seasonal variations of ozone (O-3) and three major oxidized nitrogen species, peroxyacetyl nitrate (PAN), nitrogen oxides (NOx), and nitric acid (HNO3), in northeast Asia are investigated by using a three-dimensional global chemical transport model to analyze surface observations made at Rishiri Island, a remote island in northern Japan. The model was evaluated by comparing with observed seasonal variations, and with the relationships between O-3, CO, and PAN. We show that the model reproduces the chemical environment at Rishiri Island reasonably well, and that the seasonal cycles of O-3, CO, NOy species, and VOCs are well predicted. The impact of local emissions on some of these constituents is significant, but is not the dominant factor affecting the seasonal cycles. The seasonal roles of chemistry and transport in controlling O-3 and PAN are revealed by examining production/ destruction and import/ export/deposition fluxes in the boundary layer over the Rishiri region. For O-3, transport plays a key role throughout the year, and the regional photochemical contribution is at most 10% in summer. For PAN, in contrast, transport dominates in winter, while in-situ chemistry contributes as much as 75% in summer. It is suggested that the relative contribution of transport and in-situ chemistry is significantly different for O-3 and PAN, but that the wintertime dominance of transport due to the long chemical lifetimes of these species is sufficient to drive the seasonal cycles of springtime maximum and summertime minimum characteristic of remote sites

Impact of open crop residual burning on air quality over Central Eastern China during the Mount Tai Experiment 2006 (MTX2006)

The impact of open crop residual burning (OCRB) on O<sub>3</sub>, CO, black carbon (BC) and organic carbon (OC) concentrations over Central Eastern China (CEC; 30–40° N, 111–120° E), during the Mount Tai Experiment in 2006 (MTX2006) was evaluated using a regional chemical transport model, the Models–3 Community Multiscale Air Quality Modeling System (CMAQ). To investigate these pollutants during MTX2006 in June 2006, daily gridded OCRB emissions were developed based on a bottom-up methodology using land cover and hotspot information from satellites. This model system involving daily emissions captured monthly–averages of observed concentrations and day-to-day variations in the patterns of O<sub>3</sub>, CO, BC and OC at the summit of Mount Tai (36° N, 117° E, 1534 m a.s.l., Shandong Province of the People's Republic of China) with high correlation coefficients between the model and observations ranging from 0.55 to 0.69. These results were significantly improved from those using annual biomass burning emissions. For monthly-averaged O<sub>3</sub>, the simulated concentration of 80.8 ppbv was close to the observed concentration (81.3 ppbv). The MTX2006 period was roughly divided into two parts: 1) polluted days with heavy OCRB in the first half of June; and 2) cleaner days with negligible field burning in the latter half of June. Additionally, the first half of June was characterized by two high-pollution episodes during 5–7 and 12–13 June, separated by a relatively cleaner intermediate period during 8–10 June. In the first high-pollution episode, the model captured the high O<sub>3</sub>, CO, BC and OC concentrations at the summit of Mount Tai, which were associated with OCRB over southern CEC and subsequent northward transport. For this episode, the impacts of OCRB emissions on pollutant concentrations were 26% (O<sub>3</sub>), 62% (CO), 79% (BC) and 80% (OC) at the summit of Mount Tai. The daily OCRB emissions were an essential factor in the evaluation of these pollutants during MTX2006. These emissions have a large impact not only on primary pollutants but also on secondary pollutants, such as O<sub>3</sub>, in the first half of June over northeastern Asia. The model reproduced reasonably well the variation of these pollutants in MTX2006, but underestimated daily averages of both CO and BC by a factor of 2, when using emission data from almost solely anthropogenic fuel sources in the latter half of the observation period when field burning can be neglected

Mass concentrations of black carbon measured by four instruments in the middle of Central East China in June 2006

Author name used in this publication: Gao, J.Author name used in this publication: Wang, T.2008-2009 > Academic research: refereed > Publication in refereed journalVersion of RecordPublishe

Alteration of the size distributions and mixing states of black carbon through transport in the boundary layer in east Asia

Ground-based measurements of black carbon (BC) were performed near an industrial source region in the early summer of 2014 and at a remote island in Japan in the spring of 2015. Here, we report the temporal variations in the transport, size distributions, and mixing states of the BC-containing particles. These particles were characterized using a continuous soot monitoring system, a single particle soot photometer, and an aerosol chemical speciation monitor. The effects of aging on the growth of BC-containing particles were examined by comparing the ground-based observations between the near-source and remote island sites. Secondary formation of sulfate and organic aerosols strongly affected the increases in BC coating (i.e., enhancement of cloud condensation nuclei activity) with air mass aging from the source to the outflow regions. The effects of wet removal on BC microphysics were elucidated by classifying the continental outflow air masses depending on the enhancement ratios of BC to CO (ΔBC ∕ ΔCO), which were used as an indicator of the transport efficiency of BC. It was found that ΔBC ∕ ΔCO ratios were controlled mainly by the wet removal during transport in the planetary boundary layer (PBL) on the timescale of 1–2 days. The meteorological conditions and backward trajectory analyses suggested that air masses strongly affected by wet removal originated mainly from a region in southern China (20–35° N) in the spring of 2015. Removal of large and thickly coated BC-containing particles was detected in the air masses that were substantially affected by the wet removal in the PBL, as predicted by Köhler theory. The size and water solubility of BC-containing particles in the PBL can be altered by the wet removal as well as the condensation of non-BC materials

Disrupted Membrane Structure and Intracellular Ca2+ Signaling in Adult Skeletal Muscle with Acute Knockdown of Bin1

Efficient intracellular Ca2+ ([Ca2+]i) homeostasis in skeletal muscle requires intact triad junctional complexes comprised of t-tubule invaginations of plasma membrane and terminal cisternae of sarcoplasmic reticulum. Bin1 consists of a specialized BAR domain that is associated with t-tubule development in skeletal muscle and involved in tethering the dihydropyridine receptors (DHPR) to the t-tubule. Here, we show that Bin1 is important for Ca2+ homeostasis in adult skeletal muscle. Since systemic ablation of Bin1 in mice results in postnatal lethality, in vivo electroporation mediated transfection method was used to deliver RFP-tagged plasmid that produced short –hairpin (sh)RNA targeting Bin1 (shRNA-Bin1) to study the effect of Bin1 knockdown in adult mouse FDB skeletal muscle. Upon confirming the reduction of endogenous Bin1 expression, we showed that shRNA-Bin1 muscle displayed swollen t-tubule structures, indicating that Bin1 is required for the maintenance of intact membrane structure in adult skeletal muscle. Reduced Bin1 expression led to disruption of t-tubule structure that was linked with alterations to intracellular Ca2+ release. Voltage-induced Ca2+ released in isolated single muscle fibers of shRNA-Bin1 showed that both the mean amplitude of Ca2+ current and SR Ca2+ transient were reduced when compared to the shRNA-control, indicating compromised coupling between DHPR and ryanodine receptor 1. The mean frequency of osmotic stress induced Ca2+ sparks was reduced in shRNA-Bin1, indicating compromised DHPR activation. ShRNA-Bin1 fibers also displayed reduced Ca2+ sparks' amplitude that was attributed to decreased total Ca2+ stores in the shRNA-Bin1 fibers. Human mutation of Bin1 is associated with centronuclear myopathy and SH3 domain of Bin1 is important for sarcomeric protein organization in skeletal muscle. Our study showing the importance of Bin1 in the maintenance of intact t-tubule structure and ([Ca2+]i) homeostasis in adult skeletal muscle could provide mechanistic insight on the potential role of Bin1 in skeletal muscle contractility and pathology of myopathy

An overview of using small punch testing for mechanical characterization of MCrAlY bond coats

Considerable work has been carried out on overlay bond coats in the past several decades because of its excellent oxidation resistance and good adhesion between the top coat and superalloy substrate in the thermal barrier coating systems. Previous studies mainly focus on oxidation and diffusion behavior of these coatings. However, the mechanical behavior and the dominant fracture and deformation mechanisms of the overlay bond coats at different temperatures are still under investigation. Direct comparison between individual studies has not yet been achieved due to the fragmentary data on deposition processes, microstructure and, more apparently, the difficulty in accurately measuring the mechanical properties of thin coatings. One of the miniaturized specimen testing methods, small punch testing, appears to have the potential to provide such mechanical property measurements for thin coatings. The purpose of this paper is to give an overview of using small punch testing to evaluate material properties and to summarize the available mechanical properties that include the ductile-to-brittle transition and creep of MCrAlY bond coat alloys, in an attempt to understand the mechanical behavior of MCrAlY coatings over a broad temperature range

A method of determining where to target surveillance efforts in heterogeneous epidemiological systems

The spread of pathogens into new environments poses a considerable threat to human, animal, and plant health, and by extension, human and animal wellbeing, ecosystem function, and agricultural productivity, worldwide. Early detection through effective surveillance is a key strategy to reduce the risk of their establishment. Whilst it is well established that statistical and economic considerations are of vital importance when planning surveillance efforts, it is also important to consider epidemiological characteristics of the pathogen in question—including heterogeneities within the epidemiological system itself. One of the most pronounced realisations of this heterogeneity is seen in the case of vector-borne pathogens, which spread between ‘hosts’ and ‘vectors’—with each group possessing distinct epidemiological characteristics. As a result, an important question when planning surveillance for emerging vector-borne pathogens is where to place sampling resources in order to detect the pathogen as early as possible. We answer this question by developing a statistical function which describes the probability distributions of the prevalences of infection at first detection in both hosts and vectors. We also show how this method can be adapted in order to maximise the probability of early detection of an emerging pathogen within imposed sample size and/or cost constraints, and demonstrate its application using two simple models of vector-borne citrus pathogens. Under the assumption of a linear cost function, we find that sampling costs are generally minimised when either hosts or vectors, but not both, are sampled