6 research outputs found
Uptake of pH-Sensitive Gold Nanoparticles in Strong Polyelectrolyte Brushes
The impact of electrostatic attraction on the uptake of gold nanoparticles (AuNPs) into positively charged strong poly-[2-(Methacryloyloxy) ethyl] trimethylammonium chloride (PMETAC) polyelectrolyte brushes was investigated. In this work, PMETAC brushes were synthesized via surface-initiated atom transfer radical polymerization (Si-ATRP). PMETAC/AuNP composite materials were prepared by incubation of the polymer brush coated samples into 3-mercaptopropionic acid-capped AuNP (5 nm in diameter) suspension. The electrostatic interactions were tuned by changing the surface charge of the AuNPs through variations in pH value, while the charge of the PMETAC brush was not affected. Atomic-force microscopy (AFM), ellipsometry, UV/Vis spectroscopy, gravimetric analysis and transmission electron microscopy (TEM) were employed to study the loading and penetration into the polymer brush. The results show that the number density of attached AuNPs depends on the pH value and increases with increasing pH value. There is also strong evidence that the particle assembly is dependent on the pH value of the AuNP suspension. Incubation of PMETAC brushes in AuNP suspension at pH 4 led to the formation of a surface layer on top of the brush (2D assembly) due to sterical hindrance of the clustered AuNPs, while incubation in AuNP suspension at pH 8 led to deeper particle penetration into the brush (3D assembly). The straightforward control of particle uptake and assembly by tuning the charge density of the nanoparticle surface is a valuable tool for the development of materials for colorimetric sensor applications
Multiscaling Approach for Non-Destructive Adhesion Studies of Metal/Polymer Composites
The adhesion of polyamide 6 (PA6)
and polyethylene (PE) toward an aluminum alloy (Al-A) and a dual phase
steel (DPS) is studied by contact angle (CA) measurements and atomic
force microscopy (AFM). With the combination of the two methods the
adhesion properties on a macro- and (sub)microscopic scale can be
determined in a nondestructive way. The work of adhesion per area
(<i>W</i><sub>ad</sub>) of the studied metal/polymer hybrids
qualitatively scales the same on both length scales, that is, Al-A/PA6
> DPS/PA6 > Al-A/PE, DPS/PE. The polymer dominates the adhesion.
The lower adhesion for PE toward the metal surfaces is explained by
dominating van der Waals attraction forces, whereas adhesion for PA6
can also be attributed to attractive polar forces such as hydrogen
bonding. For metal/PA6, <i>W</i><sub>ad</sub> on a macro-
and microscopic length scale is similar. For metal/PE, a discrepancy
is measured with lower adhesion values on the microscopic scale than
on the macroscopic scale
Ethylene Glycol-Based Microgels at Solid Surfaces: Swelling Behavior and Control of Particle Number Density
The adsorption of ethylene glycol
(EG)-based microgel particles at silicon surfaces was investigated.
Monodisperse p-MeO<sub>2</sub>MA-<i>co</i>-OEGMA microgel
particles were synthesized by precipitation polymerization. Particle
size and the volume phase transition temperature (VPTT) can be tailored
by changing the amount of comonomer. The effect of geometrical confinement
on the microgel particles was studied at the solid/liquid interface.
Therefore, layer formation, particle number density, and swelling/deswelling
at the surface were studied in dependence on the spin-coating preparation
parameters and characterized by means of AFM against ambient conditions.
The deswelling/swelling behavior was investigated by AFM in the water-swollen
state