1,169 research outputs found
Block copolymers of poly(ethylene oxide) and poly(methyl methacrylate)
A series of five AB block copolymers of poly(ethylene oxide) (PEO) and poly(methyl
methacrylate) (PMMA) has been synthesised by the coupling of mono-functional homopolymers by
an esterification reaction. In this series polymers all contain a PMMA component of number
average molecular weight 908 gmo1·1, as measured by end group analysis, and the PEO components
have number average molecular weights of 596, 689, 979,
2023 and 2884 gmol·1, as measured by proton nuclear magnetic resonance
spectroscopy.
Aqueous "solutions" of these copolymers have been prepared both by direct mixing and
via methanol, a solvent for both blocks of the copolymer. Cloud points for these
copolymers have been determined and range from 275K to 368K for the lowest and
highest PEO blocks respectively. Small angle X-ray scattering (SAXS) of aqueous solutions has
been interpreted in terms of a core - shell model and dimensions determined for both.
Radii of gyration for the micellar cores have been shown to vary very little with
variations in copolymer composition, concentration and temperature up to the cloud point.
Fringe thicknesses show a dependence on PEO block length and relating measured fringe
thicknesses to calculated chain conformations indicates that the the chain conformation is best
described as an unperturbed chain. The measured fringe thickness is not altered by
concentration or temperature up to the cloud point. Above the cloud point it is not possible to
interpret the SAXS data in terms of a core shell micellar model. Significant differences in the
SAXS data have been observed depending upon the mode of addition of copolymer to water. This
can be interpreted as differences in micellar
II
structure
With the exception of the lowest molecular weight copolymer all of the copolymers could be used as
steric stabilisers for the aqueous emulsion polymerisation of methyl methacrylate. Polymerisations
were only successful if the copolymer was introduced to the aqueous phase either via methanol or
via the monomer. Direct addition of copolymer to water resulted in low polymerisation
rates and unstable/flocculated products. Emulsions produced have been shown to be stable at pH
levels where the electrophoretic mobility was zero, ie. the emulsions were sterically
stabilised with no contribution from ionic I dipole interactions
Successful pregnancy and delivery in a woman with panhypopituitarism
To The Editor: Pregnancy after a complete loss of hypophyseal function is rare. Lack of growth hormone (GH), adrenocorticotropin (ACTH) and thyroid-stimulating hormone (TSH) in childhood may result in malfunction of different organ systems, affecting fertility. Complete lack of ovarian stimulation by FSH and LH results in anovulation and ovarian atrophy. We present a patient with panhypopituitarism who has achieved pregnancy and delivered through in vitro fertilization (IVF) and embryo transfer (ET). This 35 year-old woman underwent four trans-sphenoidal hypophysectomies at 12, 13, 23 and 26 years of age, for recurrent neuroectodermal cysts (embryonic remnant). Her second operation was complicated by panhypopituitarism with severe diabetes insipidus, treated with adequate doses of hydrocortisone, L-thyroxine and desmopressin. At age 21, cyclic substitution therapy with estrogen and progesterone was given for primary amenorrhea. Two years later, GH therapy was added. At age 33, she requested fertility treatment. GH, cyclic estrogen, and progesterone therapy were stopped, and she underwent ovulation induction, with gonadotropins, followed by IVF and ET, resulting in a successful dichorionic twin pregnancy. She was followed regularly at a combined antenatal clinic. No changes in steroid, desmopressin, or thyroxine doses were required, and the antenatal period was uneventful. An elective caesarean section was performed at 37 weeks gestation, and healthy twin boys (weighing 3.0 and 3.14 kg) were delivered. Clinical course during puerperium was normal.Conception and uncomplicated pregnancy in patients with hypopituitiarism are rare [1,2]. Well-timed substitution of missing hormones enables normal physical development. Stimulation therapy with gonadotropins can induce adequate follicular maturation. IVF-ET may be a useful treatment for infertility in patients with hypopituitarism as it may reduce the incidence of multiple pregnancies associated with higher risk in GH deficient patients
Black swans, cognition and the power of learning from failure
Failure carries undeniable stigma and is difficult to confront for individuals, teams, and organizations. Disciplines such as commercial and military aviation, medicine, and business have long histories of grappling with it, beginning with the recognition that failure is inevitable in every human endeavor. While conservation may arguably be more complex, conservation professionals can draw upon the research and experience of these other disciplines to institutionalize activities and attitudes that foster learning from failures, whether they are minor setbacks or major disasters. Understanding the role of individual cognitive biases, team psychological safety, and organizational willingness to support critical self-examination all contribute to creating a cultural shift in conservation to one that is open to the learning opportunity that failure provides. This new approach to managing failure is a necessary next step in the evolution of conservation effectiveness. This article is protected by copyright. All rights reserved
Query-based Hard-Image Retrieval for Object Detection at Test Time
There is a longstanding interest in capturing the error behaviour of object
detectors by finding images where their performance is likely to be
unsatisfactory. In real-world applications such as autonomous driving, it is
also crucial to characterise potential failures beyond simple requirements of
detection performance. For example, a missed detection of a pedestrian close to
an ego vehicle will generally require closer inspection than a missed detection
of a car in the distance. The problem of predicting such potential failures at
test time has largely been overlooked in the literature and conventional
approaches based on detection uncertainty fall short in that they are agnostic
to such fine-grained characterisation of errors. In this work, we propose to
reformulate the problem of finding "hard" images as a query-based hard image
retrieval task, where queries are specific definitions of "hardness", and offer
a simple and intuitive method that can solve this task for a large family of
queries. Our method is entirely post-hoc, does not require ground-truth
annotations, is independent of the choice of a detector, and relies on an
efficient Monte Carlo estimation that uses a simple stochastic model in place
of the ground-truth. We show experimentally that it can be applied successfully
to a wide variety of queries for which it can reliably identify hard images for
a given detector without any labelled data. We provide results on ranking and
classification tasks using the widely used RetinaNet, Faster-RCNN, Mask-RCNN,
and Cascade Mask-RCNN object detectors. The code for this project is available
at https://github.com/fiveai/hardest
Use of MMG signals for the control of powered orthotic devices: Development of a rectus femoris measurement protocol
Copyright © 2009 Rehabilitation Engineering and Assistive Technology Society (RESNA). This is an Author's Accepted Manuscript of an article published in Assistive Technology, 21(1), 1 - 12, 2009, copyright Taylor & Francis, available online at: http://www.tandfonline.com/10.1080/10400430902945678.A test protocol is defined for the purpose of measuring rectus femoris mechanomyographic (MMG) signals. The protocol is specified in terms of the following: measurement equipment, signal processing requirements, human postural requirements, test rig, sensor placement, sensor dermal fixation, and test procedure. Preliminary tests of the statistical nature of rectus femoris MMG signals were performed, and Gaussianity was evaluated by means of a two-sided Kolmogorov-Smirnov test. For all 100 MMG data sets obtained from the testing of two volunteers, the null hypothesis of Gaussianity was rejected at the 1%, 5%, and 10% significance levels. Most skewness values were found to be greater than 0.0, while all kurtosis values were found to be greater than 3.0. A statistical convergence analysis also performed on the same 100 MMG data sets suggested that 25 MMG acquisitions should prove sufficient to statistically characterize rectus femoris MMG. This conclusion is supported by the qualitative characteristics of the mean rectus femoris MMG power spectral densities obtained using 25 averages
Optimisation of variables for studying dilepton transverse momentum distributions at hadron colliders
In future measurements of the dilepton () transverse momentum,
\Qt, at both the Tevatron and LHC, the achievable bin widths and the ultimate
precision of the measurements will be limited by experimental resolution rather
than by the available event statistics. In a recent paper the variable \at,
which corresponds to the component of \Qt\ that is transverse to the dilepton
thrust axis, has been studied in this regard. In the region, \Qt\ 30 GeV,
\at\ has been shown to be less susceptible to experimental resolution and
efficiency effects than the \Qt. Extending over all \Qt, we now demonstrate
that dividing \at\ (or \Qt) by the measured dilepton invariant mass further
improves the resolution. In addition, we propose a new variable, \phistarEta,
that is determined exclusively from the measured lepton directions; this is
even more precisely determined experimentally than the above variables and is
similarly sensitive to the \Qt. The greater precision achievable using such
variables will enable more stringent tests of QCD and tighter constraints on
Monte Carlo event generator tunes.Comment: 8 pages, 5 figures, 2 table
The design and characterization of a 300 channel, optimized full-band millimeter filterbank for science with SuperSpec
SuperSpec is an integrated, on-chip spectrometer for millimeter and sub-millimeter astronomy. We report the approach, design optimization, and partial characterization of a 300 channel filterbank covering the 185 to 315 GHz frequency band that targets a resolving power R ~ 310, and fits on a 3.5×5.5 cm chip. SuperSpec uses a lens and broadband antenna to couple radiation into a niobium microstrip that feeds a bank of niobium microstrip half-wave resonators for frequency selectivity. Each half-wave resonator is coupled to the inductor of a titanium nitride lumped-element kinetic inductance detector (LEKID) that detects the incident radiation. The device was designed for use in a demonstration instrument at the Large Millimeter Telescope (LMT)
Radiation damage in the LHCb vertex locator
The LHCb Vertex Locator (VELO) is a silicon strip detector designed to reconstruct charged particle trajectories and vertices produced at the LHCb interaction region. During the first two years of data collection, the 84 VELO sensors have been exposed to a range of fluences up to a maximum value of approximately 45 × 1012 1 MeV neutron equivalent (1 MeV neq). At the operational sensor temperature of approximately −7 °C, the average rate of sensor current increase is 18 μA per fb−1, in excellent agreement with predictions. The silicon effective bandgap has been determined using current versus temperature scan data after irradiation, with an average value of Eg = 1.16±0.03±0.04 eV obtained. The first observation of n+-on-n sensor type inversion at the LHC has been made, occurring at a fluence of around 15 × 1012 of 1 MeV neq. The only n+-on-p sensors in use at the LHC have also been studied. With an initial fluence of approximately 3 × 1012 1 MeV neq, a decrease in the Effective Depletion Voltage (EDV) of around 25 V is observed. Following this initial decrease, the EDV increases at a comparable rate to the type inverted n+-on-n type sensors, with rates of (1.43±0.16) × 10−12 V/ 1 MeV neq and (1.35±0.25) × 10−12 V/ 1 MeV neq measured for n+-on-p and n+-on-n type sensors, respectively. A reduction in the charge collection efficiency due to an unexpected effect involving the second metal layer readout lines is observed
Genotype, Childhood Maltreatment, and Their Interaction in the Etiology of Adult Antisocial Behaviors
BACKGROUND: Maltreatment by an adult or caregiver during childhood is a prevalent and important predictor of antisocial behaviors in adulthood. A functional promoter polymorphism in the monoamine oxidase A (MAOA) gene has been implicated as a moderating factor in the relationship between childhood maltreatment and antisocial behaviors. Although there have been numerous attempts at replicating this observation, results remain inconclusive. METHODS: We examined this gene-environment interaction hypothesis in a sample of 3356 white and 960 black men (aged 24-34) participating in the National Longitudinal Study of Adolescent Health. RESULTS: Primary analysis indicated that childhood maltreatment was a significant risk factor for later behaviors that violate rules and the rights of others (p .05). Power analyses indicated that these results were not due to insufficient statistical power. CONCLUSIONS: We could not confirm the hypothesis that MAOA genotype moderates the relationship between childhood maltreatment and adult antisocial behaviors
Recommended from our members
Depression, Stressful Life Events, and the Impact of Variation in the Serotonin Transporter: Findings from the National Longitudinal Study of Adolescent to Adult Health (Add Health)
BackgroundThe low transcriptionally efficient short-allele of the 5HTTLPR serotonin transporter polymorphism has been implicated to moderate the relationship between the experience of stressful life events (SLEs) and depression. Despite numerous attempts at replicating this observation, results remain inconclusive.MethodsWe examined this relationship in young-adult Non-Hispanic white males and females between the ages of 22 and 26 (n = 4724) participating in the National Longitudinal Study of Adolescent to Adult Health (Add Health) with follow-up information every six years since 1995.ResultsLinear and logistic regression models, corrected for multiple testing, indicated that carriers of one or more of the S-alleles were more sensitive to stress than those with two L-alleles and at a higher risk for depression. This relationship behaved in a dose-response manner such that the risk for depression was greatest among those who reported experiencing higher numbers of SLEs. In post-hoc analyses we were not able to replicate an interaction effect for suicide ideation but did find suggestive evidence that the effects of SLEs and 5HTTLPR on suicide ideation differed for males and females. There were no effects of childhood maltreatment.DiscussionOur results provide partial support for the original hypothesis that 5-HTTLPR genotype interacts with the experience of stressful life events in the etiology of depression during young adulthood. However, even with this large sample, and a carefully constructed a priori analysis plan, the results were still not definitive. For the purposes of replication, characterizing the 5HTTLPR in other large data sets with extensive environmental and depression measures is needed
- …