Use of threshold electrolyte concentration analysis to determine salinity and sodicity limit of irrigation water

This research studied threshold electrolyte concentration (TEC) of irrigation water and its effect on the infiltration rate of two contrasting soils from Pernambuco state, Brazil. The experiment was conducted in the Soil Chemistry and Salinity Laboratory of Federal Rural University of Pernambuco. Each soil was packed in five Buchner funnels, where one funnel from each soil was submitted to treatment with solution of electrical conductivity (EC) of 0.5, 1.0, 2.0, 4.0 or 8.0 dS m-1. For each funnel containing soil, an increasing ratio of NaCl to CaCl2 was applied in a treatment solution to achieve 10 increasing values of sodium adsorption ratio (SAR) from 0 to 100. These solutions were applied through a Mariotte bottle, with a constant hydraulic head of ~2 cm (pressure potential). After a liter of solution had drained, in the flux was collected for a known time interval, until steady state was reached. Darcy's equation was used to calculate saturated hydraulic conductivity (Ksat) and a mathematical model used to calculate the TEC as a 20% reduction in Ksat. By increasing SAR similar behavior was noted between the two soils, whereby Ksat decreased, although the relative decrease in Ksat was greater for SAR of 100 in the soil with higher clay content

Desempenho de um aquecedor solar de água em Manaus

A commercial, domestic solar water heater was tested in Manaus during the whole year round. The performance was monitored using various parameters: incident solar radiation, temperature of water in the tank and at the entrance and exit of the collectors, as well as the velocity of the thermosiphon The latter was measured by injecting printing ink into the pipework which was fitted with transparent plastic windows in appropriate places. The efficiency of the collectors was seen to vary during the day. The maximum value ever observed was 58% and values of 37% are calculated for the data described In detail. Collector angle in the range 4°-25° did not affect performance significantly Hot water for showers (150 l) at > 45°C should be obtained in 93% of the days of the year.Um aquecedor solar de água comercial para fins domésticos foi testado em Manaus tanto no verão quanto no inverno. O desempenho foi medido em função da radiação incidente, observando-se a temperatura da água no reservatório e na entrada e na saída do coletor. A velocidade de termossifonagem foi medida através de uma injeção de tinta em tubulação transparente. A eficiência variou durante o dia. O valor máximo observado foi do 58% e valores de 37% são mostrados nos dados analisados em detalhe. O ângulo de inclinação (de 4 até 25°) não teve influência significativa no desempenho dos coletores. Agua quente (150 l) acima de 45°C seria obtida em pelo menos 93% dos dias do ano

Componentes de produção como indicadores de tolerância à seca em cana-de-açúcar

A deficiência de água é um dos principais fatores que limitam a produção da cana-de-açúcar (Saccharum officinarum L.). Estudar os efeitos do estresse hídrico sobre os componentes de produção e sua relação com a produtividade pode ajudar os programas de melhoramento a selecionar genótipos produtivos sob essa condição. O objetivo deste estudo foi investigar as relações entre os caracteres número de colmos, altura de colmos, diâmetro de colmos e massa de colmos com a produtividade de cana-de-açúcar cultivada em uma área, sob deficiência moderada de água, durante o período de maior desenvolvimento, a fim de prover informações que auxiliem melhoristas na adoção de características para selecionar variedades tolerantes à seca. Foram cultivados 78 genótipos e dois padrões, um tolerante e outro sensível ao estresse hídrico, sob deficiência moderada de água em campo e durante o ano agrícola 2005/2006 em Weslaco, Texas, Estados Unidos. Produtividade e os componentes de produção foram avaliados. Sob estresse, o padrão tolerante (TCP93-4245) apresentou maior produtividade, número de colmos, altura de colmos e massa de colmos do que o padrão sensível (TCP87-3388). Entretanto, o padrão sensível apresentou maior diâmetro de colmos. Associação linear foi encontrada entre produtividade e seus componentes, mas diâmetro de colmos foi bastante instável entre os genótipos. Altura de colmos apresentou correlação positiva com número, diâmetro e massa de colmos. Diâmetro de colmos também apresentou correlação positiva com massa de colmos. Portanto, durante o processo de seleção, quando um desses componentes é melhorado para tolerância à seca, o componente correlacionado deverá também ser melhorado, tornando-se possível selecionar genótipos com elevada produtividade e número, altura e massa de colmos sob deficiência hídrica.Water deficit is one of the major factors limiting the production of sugarcane (Saccharum officinarum L.). A study of the effects of limited water condition on yield components and their relationship with productivity can aid breeding programs in selecting for high yielding genotypes under this condition. The objective of this study was to investigate the relationships among the parameters stalk number, stalk height, stalk diameter, and stalk weight with cane yield in sugarcane growing in a field under moderate water stress during its grand growth period, in order to provide information to help breeders in adopting traits for selecting drought tolerant varieties. Seventy-eight genotypes plus two controls, one drought-tolerant and one drought-susceptible, were grown under a moderate water deficit condition in the field in 2005/2006 at Weslaco, TX. Productivity and yield components were measured. Under stress, the tolerant control (TCP93-4245) showed higher productivity, stalk number, stalk height and stalk weight than the susceptible one (TCP87-3388). However, the susceptible control showed higher stalk diameter. Linear association was found between productivity and its yield components, but stalk diameter showed to be fairly unstable among genotypes. Stalk height showed significant correlation with stalk number, stalk diameter and stalk weight. Stalk diameter also showed positive correlation with stalk weight. Therefore, during the selection procedure, when one of these traits is enhanced by drought tolerance, the correlated trait should also increase, making it feasible to select genotypes with high productivity, stalk number, stalk height, and stalk weight under water deficit

A connected and automated vehicle readiness framework to support road authorities for C-ITS services

Connected and Automated Vehicles (CAVs) can have a profound influence on transport systems. However, most levels of automation and connectivity require support from the road infrastructure. Additional support such as Cooperative Intelligent Transport Systems (C-ITS) services can facilitate safe and efficient traffic, and alleviate the environmental impacts of road surface vehicles. However, due to the rapidly evolving technology, C-ITS service deployment requirements are not always clear. Furthermore, the costs and benefits of infrastructure investments are subject to tremendous uncertainty. This study articulates the requirements using a structured approach to propose a CAV-Readiness Framework (CRF). The main purpose of the CRF is allowing road authorities to assess their physical and digital infrastructure readiness, define requirements for C-ITS services, and identify future development paths to reach higher levels of readiness to support CAVs by enabling C-ITS services. The CRF is intended to guide and support road authorities' investment decisions on infrastructure

Semiquantum Chaos and the Large N Expansion

We consider the dynamical system consisting of a quantum degree of freedom $A$ interacting with $N$ quantum oscillators described by the Lagrangian \bq L = {1\over 2}\dot{A}^2 + \sum_{i=1}^{N} \left\{{1\over 2}\dot{x}_i^2 - {1\over 2}( m^2 + e^2 A^2)x_i^2 \right\}. \eq In the limit $N \rightarrow \infty$, with $e^2 N$ fixed, the quantum fluctuations in $A$ are of order $1/N$. In this limit, the $x$ oscillators behave as harmonic oscillators with a time dependent mass determined by the solution of a semiclassical equation for the expectation value \VEV{A(t)}. This system can be described, when \VEV{x(t)}= 0, by a classical Hamiltonian for the variables G(t) = \VEV{x^2(t)}, $\dot{G}(t)$, A_c(t) = \VEV{A(t)}, and $\dot{A_c}(t)$. The dynamics of this latter system turns out to be chaotic. We propose to study the nature of this large-$N$ limit by considering both the exact quantum system as well as by studying an expansion in powers of $1/N$ for the equations of motion using the closed time path formalism of quantum dynamics.Comment: 30 pages, uuencoded LaTeX file (figures included

Influence of flock treatment with the antibiotic tylosin on poultry meat quality: results of a preliminary experiment

The veterinary antibiotic tylosin was administered to broilers at sub-therapeutic and therapeutic levels to study its effect on the quality of poultry breast meat. No statistically significant differences were observed in moisture content, pH, drip loss, colour and extent of lipid oxidation between the breast meat from treated and not treated birds. However, the cooking loss of the meat from the birds administered tylosin was significantly higher than that from the not treated ones. Additionally, the mean shear force of the breast meat was significantly lower for the sub-therapeutically treated broilers than for the not treated and the therapeutically treated ones. It was concluded that the level at which tylosin was administered to the broilers affected the quality of the breast meat, particularly its textural properties

Multivariate discrimination and the Higgs + W/Z search

A systematic method for optimizing multivariate discriminants is developed and applied to the important example of a light Higgs boson search at the Tevatron and the LHC. The Significance Improvement Characteristic (SIC), defined as the signal efficiency of a cut or multivariate discriminant divided by the square root of the background efficiency, is shown to be an extremely powerful visualization tool. SIC curves demonstrate numerical instabilities in the multivariate discriminants, show convergence as the number of variables is increased, and display the sensitivity to the optimal cut values. For our application, we concentrate on Higgs boson production in association with a W or Z boson with H -> bb and compare to the irreducible standard model background, Z/W + bb. We explore thousands of experimentally motivated, physically motivated, and unmotivated single variable discriminants. Along with the standard kinematic variables, a number of new ones, such as twist, are described which should have applicability to many processes. We find that some single variables, such as the pull angle, are weak discriminants, but when combined with others they provide important marginal improvement. We also find that multiple Higgs boson-candidate mass measures, such as from mild and aggressively trimmed jets, when combined may provide additional discriminating power. Comparing the significance improvement from our variables to those used in recent CDF and DZero searches, we find that a 10-20% improvement in significance against Z/W + bb is possible. Our analysis also suggests that the H + W/Z channel with H -> bb is also viable at the LHC, without requiring a hard cut on the W/Z transverse momentum.Comment: 41 pages, 5 tables, 29 figure

Clean and efficient energies for Europe : socio-economic impact of energy research

Report of the independent expert panelLaunched in 1994, the Fourth Framework Programme (FP4) covering research and demonstration aimed to improve the security of energy supply and to reduce the impact of the production and use of energy on the environment, in particular CO2 and the other greenhouse gases. Other important EU objectives were also addressed including strengthening the technological basis of the energy industry (e.g. employment and export potential), improving European social and economic cohesion and contributing to co-operation with third countries. It also supported research on overall energy RTD strategy in the inter-disciplinary area of energy-environment-economy. Six years after the Programme’s launch, at a stage when most of the projects have been completed, and the Sixth Framework Programme is being planned, it was considered appropriate to assess not only the scientific and technical quality of the completed projects, but also their impact on society, the economy and the environment. The present analysis was organised to allow quick feedback for the preparation of the new Framework Programme. This was achieved by convening a panel of ten experts from different Member States. Using questionnaires, project final reports and direct contacts where necessary, the Panel investigated the expected overall impact by examining the scientific and technical results as well as the social and economic impact of a sample of about 90 already finished Non-Nuclear Energy projects, most of them three years ago (time necessary to expect some concrete results), representing in total a e84 million investment by the Commission. The contribution to Community policies, particularly emphasised in the present Framework Programme, as well as the Programmes’s addition to European Added Value were both explored. The results of this impact assessment of about one-fifth of the projects funded under the Non-Nuclear Energy Programme of the Fourth Framework Programme for the period 1994-1998 (better known as JOULE), were analysed and critically reviewed and are presented in this report. Among the main conclusions of the report, it is worth noting that the vast majority of the examined projects have developed new technical advances. Furthermore, the commercial leverage of funded research projects is positive and its major non-commercial impact is on the improvement of the environment and particularly on CO2 emissions. The social and economic impact remains, in general, limited, but could be improved through better understanding and application of the European Added Value principles. The Fifth Framework Programme made a further step towards refocusing European energy research and aiming to provide effective responses to the major challenges facing European society. It is important to fully exploit the experience and the results from the research undertaken under the FP4 since the knowledge generated relates directly to the objectives of the next Energy Research Programme. It also provides the groundwork for launching effective and innovative approaches to implementing the “European Research Area”. Based on the present pilot exercise, the remaining projects of the Non-Nuclear Energy Programme of the FP4 will be assessed to provide a full picture of the impact of the Programme. Finally, the present pilot exercise should help to provide a methodological base for other research programmes to develop quick-response, feedback to decision-makers to allow for the development of better informed research policies and actions. It should also help to bring more quickly the results and socio-economic implications of European research to European citizens, companies and institutions

Morphological and conductivity studies of di-ureasil xerogels containing lithium triflate

Sol–gel derived poly(oxyethylene)/siloxane hybrids doped with lithium triflate, LiCF3SO3, have been investigated. The host hybrid matrix of these materials, named di-ureasil and represented by U(600), is composed by a siliceous framework to which polyether chains containing 8.5 oxyethylene repeat units are covalently bonded through urea linkages. Xerogel samples U(600)nLiCF3SO3 with n (where n is the molar ratio of oxyethylene moieties per Li+ ion) between ∞ and 0.1 have been examined. X-ray diffraction and differential scanning calorimetry have provided conclusive evidence that the xerogels analyzed are entirely amorphous. The salt-rich material with n=1 exhibits the highest conductivity over the whole range of temperature analyzed (e.g. 4.3×10−6 and 2.0×10−4 Ω−1 cm−1, respectively, at 25 and 94 °C).Fundação para a Ciência e a Tecnologia (FCT