Restorative Dentistry: Dental composite depth of cure with halogen and blue light emitting diode technology

Objectives To test the hypothesis that a blue light emitting diode (LED) light curing unit (LCU) can produce an equal dental composite depth of cure to a halogen LCU adjusted to give an irradiance of 300 mWcm–2 and to characterise the LCU's light outputs. Materials and methods Depth of cure for three popular composites was determined using a penetrometer. The Student's t test was used to analyse the depth of cure results. A power meter and a spectrometer measured the light output. Results The spectral distribution of the LCUs differed strongly. The irradiance for the LED and halogen LCUs were 290 mWcm–2 and 455 mWcm–2, when calculated from the scientific power meter measurements. The LED LCU cured all three dental composites to a significantly greater (P < 0.05) depth than the halogen LCU. Conclusions An LED LCU with an irradiance 64% of a halogen LCU achieved a significantly greater depth of cure. The LCU's spectral distribution of emitted light should be considered in addition to irradiance as a performance indicator. LED LCUs may have a potential for use in dental practice because their performance does not significantly reduce with time as do conventional halogen LCUs

Changes in vegetative cover on Western Arctic Herd winter range from 1981 to 2005: potential effects of grazing and climate change

The population of the Western Arctic Herd, estimated at 490 000 caribou (Rangifer tarandus granti) in 2003, is at its highest level in 30 years. Twenty permanent range transects were established in the winter range of the Western Arctic Herd in 1981 to assess the impacts of grazing. These transects were revisited in 1995 and 1996 (1995/96). Only 18 of the transects were re-located, so an additional 7 transects were established in 1996. In 2005, all 25 remaining transects were revisited. Lichen coverage dropped by a relative 45.1% between 1981 and 1995/96 and by an additional relative 25.6% between 1995/96 and 2005. There was a significant decline in primary forage lichens between 1995/96 and 2005. Caribou use was greater in areas with high lichen abundance. Graminoid cover increased by a relative 118.4% from 1981 to 1995/96 and again by a relative 26.1% from 1995/96 to 2005. Shrub cover increased during the study whereas forb cover declined. The decline in lichen abundance on the winter range of the Western Arctic Herd over 24 years is an index of caribou habitat condition. The observed changes in vegetation cover can be attributed to caribou grazing, fire, and possibly global climate change. Continued declines in lichen cover could lead to population declines within the herd, range shifts, or both

Diets of Overwintering Caribou, Rangifer tarandus, Track Decadal Changes in Arctic Tundra Vegetation

We compared winter diets of Western Arctic Herd Caribou (Rangifer tarandus) from 1995/1996 and 2005 using microhistological fecal analysis on samples collected at paired permanent vegetation transects. Changes in the diets of Caribou followed the same trends as vegetative changes documented in long-term studies in northwestern Alaska. Lichens were significantly less prevalent on the landscape and in the winter diets of Caribou between 1995/1996 and 2005, while graminoids (grasses and sedges) were significantly more prevalent. Dramatic changes are forecasted for Arctic ecosystems under global warming scenarios which may continue the trend of declining lichens in northwestern Alaska and in the diet of Western Arctic Herd Caribou. The question of whether or not the altered diet will affect the population dynamics of this herd remains unresolved

Measurement of length distribution of beta-lactoglobulin fibrils by multiwavelength analytical ultracentrifugation

The whey protein beta-lactoglobulin is the building block of amyloid fibrils which exhibit a great potential in various applications. These include stabilization of gels or emulsions. During biotechnological processing, high shear forces lead to fragmentation of fibrils and therefore to smaller fibril lengths. To provide insight into such processes, pure straight amyloid fibril dispersions (prepared at pH 2) were produced and sheared using the rotor stator setup of an Ultra Turrax. In the first part of this work, the sedimentation properties of fragmented amyloid fibrils sheared at different stress levels were analyzed with mulitwavelength analytical ultracentrifugation (AUC). Sedimentation data analysis was carried out with the boundary condition that fragmented fibrils were of cylindrical shape, for which frictional properties are known. These results were compared with complementary atomic force microscopy (AFM) measurements. We demonstrate how the sedimentation coefficient distribution from AUC experiments is influenced by the underlying length and diameter distribution of amyloid fibrils. In the second part of this work, we show how to correlate the fibril size reduction kinetics with the applied rotor revolution and the resulting energy density, respectively, using modal values of the sedimentation coefficients obtained from AUC. Remarkably, the determined scaling laws for the size reduction are in agreement with the results for other material systems, such as emulsification processes or the size reduction of graphene oxide sheets.</p

A new view of electrochemistry at highly oriented pyrolytic graphite

Major new insights on electrochemical processes at graphite electrodes are reported, following extensive investigations of two of the most studied redox couples, Fe(CN)64–/3– and Ru(NH3)63+/2+. Experiments have been carried out on five different grades of highly oriented pyrolytic graphite (HOPG) that vary in step-edge height and surface coverage. Significantly, the same electrochemical characteristic is observed on all surfaces, independent of surface quality: initial cyclic voltammetry (CV) is close to reversible on freshly cleaved surfaces (>400 measurements for Fe(CN)64–/3– and >100 for Ru(NH3)63+/2+), in marked contrast to previous studies that have found very slow electron transfer (ET) kinetics, with an interpretation that ET only occurs at step edges. Significantly, high spatial resolution electrochemical imaging with scanning electrochemical cell microscopy, on the highest quality mechanically cleaved HOPG, demonstrates definitively that the pristine basal surface supports fast ET, and that ET is not confined to step edges. However, the history of the HOPG surface strongly influences the electrochemical behavior. Thus, Fe(CN)64–/3– shows markedly diminished ET kinetics with either extended exposure of the HOPG surface to the ambient environment or repeated CV measurements. In situ atomic force microscopy (AFM) reveals that the deterioration in apparent ET kinetics is coupled with the deposition of material on the HOPG electrode, while conducting-AFM highlights that, after cleaving, the local surface conductivity of HOPG deteriorates significantly with time. These observations and new insights are not only important for graphite, but have significant implications for electrochemistry at related carbon materials such as graphene and carbon nanotubes

Spatial effects, sampling errors, and task specialization in the honey bee

Task allocation patterns should depend on the spatial distribution of work within the nest, variation in task demand, and the movement patterns of workers, however, relatively little research has focused on these topics. This study uses a spatially explicit agent based model to determine whether such factors alone can generate biases in task performance at the individual level in the honey bees, Apis mellifera. Specialization (bias in task performance) is shown to result from strong sampling error due to localized task demand, relatively slow moving workers relative to nest size, and strong spatial variation in task demand. To date, specialization has been primarily interpreted with the response threshold concept, which is focused on intrinsic (typically genotypic) differences between workers. Response threshold variation and sampling error due to spatial effects are not mutually exclusive, however, and this study suggests that both contribute to patterns of task bias at the individual level. While spatial effects are strong enough to explain some documented cases of specialization; they are relatively short term and not explanatory for long term cases of specialization. In general, this study suggests that the spatial layout of tasks and fluctuations in their demand must be explicitly controlled for in studies focused on identifying genotypic specialists

Multi-resolution anisotropy studies of ultrahigh-energy cosmic rays detected at the Pierre Auger Observatory

We report a multi-resolution search for anisotropies in the arrival directions of cosmic rays detected at the Pierre Auger Observatory with local zenith angles up to $80^\circ$ and energies in excess of 4 EeV ($4 \times 10^{18}$ eV). This search is conducted by measuring the angular power spectrum and performing a needlet wavelet analysis in two independent energy ranges. Both analyses are complementary since the angular power spectrum achieves a better performance in identifying large-scale patterns while the needlet wavelet analysis, considering the parameters used in this work, presents a higher efficiency in detecting smaller-scale anisotropies, potentially providing directional information on any observed anisotropies. No deviation from isotropy is observed on any angular scale in the energy range between 4 and 8 EeV. Above 8 EeV, an indication for a dipole moment is captured; while no other deviation from isotropy is observed for moments beyond the dipole one. The corresponding $p$-values obtained after accounting for searches blindly performed at several angular scales, are $1.3 \times 10^{-5}$ in the case of the angular power spectrum, and $2.5 \times 10^{-3}$ in the case of the needlet analysis. While these results are consistent with previous reports making use of the same data set, they provide extensions of the previous works through the thorough scans of the angular scales.Comment: Published version. Added journal reference and DOI. Added Report Numbe