Examining the quasi-static uniaxial compressive behaviour of commercial high-performance epoxy matrices

Four commercial high-performance aerospace aromatic epoxy matrices, CYCOM®890, CYCOM®977-2, PR520, and PRISM EP2400, were cured to a standardised 2 h, 180 °C cure cycle and evaluated in quasi-static uniaxial compression, as well as by dynamic scanning calorimetry (DSC) and thermogravimetric analysis (TGA). The thermoplastic toughened CYCOM®977-2 formulation displayed an overall increase in true axial stress values across the entire stress-strain curve relative to the baseline CYCOM®890 sample. The particle-toughened PR520 sample exhibited an overall decrease in true axial stress values past the yield point of the material. The PRISM EP2400 resin, with combined toughening agents, led to true axial stress values across the entire plastic region of the stress-strain curve, which were in line with the stress values observed with the CYCOM®890 material. Interestingly, for all formulations, the dilation angles (associated with the volume change during plastic deformation), recorded at 0.3 plastic strain, were close to 0°, with the variations reflecting the polymer structure. Compression data collected for this series of commercial epoxy resins are in broad agreement with a selection of model epoxy resins based on di- and tetra-functional monomers, cured with polyamines or dicarboxylic anhydrides. However, the fully formulated resins demonstrate a significantly higher compressive modulus than the model resins, albeit at the expense of yield stress

Direct dispersion of SWNTs in highly conductive solvent-enhanced PEDOT:PSS films

Poly(3,4-ethylenedioxythiophene) poly(styrenesulfonate) (PEDOT:PSS) is shown to be an effective dispersant for single-wall carbon nanotubes (SWNTs), enabling uniform aqueous suspensions to be obtained at weight loadings of up to 0.23 mg/ml (>1% by weight relative to PEDOT:PSS) without recourse to additional surfactants. Thin films spin-coated from PEDOT:PSS/SWNT suspensions exhibited sheet resistances of 90 Ω/sq. at 80 % transmittance, slightly higher than equivalent films of pure PEDOT:PSS which exhibited sheet resistances of 70 Ω/sq. at the same transmittance

Sexual Size Dimorphism and Body Condition in the Australasian Gannet

Funding: The research was financially supported by the Holsworth Wildlife Research Endowment. Acknowledgments We thank the Victorian Marine Science Consortium, Sea All Dolphin Swim, Parks Victoria, and the Point Danger Management Committee for logistical support. We are grateful for the assistance of the many field volunteers involved in the study.Peer reviewedPublisher PD

Echocardiographic detection of anomalous course of the left innominate vein

Anomalous course of the left innominate vein beneath the aortic arch is a rare congenital anomaly. We report the case of a 3 year old child in whom this defect was detected by two-dimensional and Doppler echocardiography. The echocardiographic appearance of the anomalous course of the left innominate vein is illustrated and the importance of identifying this rare systemic venous anomaly is discussed.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/42535/1/10554_2005_Article_BF01784202.pd

Genome-Wide Association Studies in Dogs and Humans Identify ADAMTS20 as a Risk Variant for Cleft Lip and Palate

Cleft lip with or without cleft palate (CL/P) is the most commonly occurring craniofacial birth defect. We provide insight into the genetic etiology of this birth defect by performing genome-wide association studies in two species: dogs and humans. In the dog, a genome-wide association study of 7 CL/P cases and 112 controls from the Nova Scotia Duck Tolling Retriever (NSDTR) breed identified a significantly associated region on canine chromosome 27 (unadjusted p=1.1 x 10-13; adjusted p= 2.2 x 10-3). Further analysis in NSDTR families and additional full sibling cases identified a 1.44 Mb homozygous haplotype (chromosome 27: 9.29 – 10.73 Mb) segregating with a more complex phenotype of cleft lip, cleft palate, and syndactyly (CLPS) in 13 cases. Whole-genome sequencing of 3 CLPS cases and 4 controls at 15X coverage led to the discovery of a frameshift mutation within ADAMTS20 (c.1360_1361delAA (p.Lys453Ilefs*3)), which segregated concordant with the phenotype. In a parallel study in humans, a family-based association analysis (DFAM) of 125 CL/P cases, 420 unaffected relatives, and 392 controls from a Guatemalan cohort, identified a suggestive association (rs10785430; p =2.67 x 10-6) with the same gene, ADAMTS20. Sequencing of cases from the Guatemalan cohort was unable to identify a causative mutation within the coding region of ADAMTS20, but four coding variants were found in additional cases of CL/P. In summary, this study provides genetic evidence for a role of ADAMTS20 in CL/P development in dogs and as a candidate gene for CL/P development in humans

Small Deletions of SATB2 Cause Some of the Clinical Features of the 2q33.1 Microdeletion Syndrome

Recurrent deletions of 2q32q33 have recently been reported as a new microdeletion syndrome. Clinical features of this syndrome include severe mental retardation, growth retardation, dysmorphic features, thin and sparse hair, feeding difficulties and cleft or high palate. The commonly deleted region contains at least seven genes. Haploinsufficiency of one of these genes, SATB2, a DNA-binding protein that regulates gene expression, has been implicated as causative in the cleft or high palate of individuals with 2q32q33 microdeletion syndrome. In this study we describe three individuals with smaller microdeletions of this region, within 2q33.1. The deletions ranged in size from 173.1 kb to 185.2 kb and spanned part of SATB2. Review of clinical records showed similar clinical features among these individuals, including severe developmental delay and tooth abnormalities. Two of the individuals had behavioral problems. Only one of the subjects presented here had a cleft palate, suggesting reduced penetrance for this feature. Our results suggest that deletion of SATB2 is responsible for several of the clinical features associated with 2q32q33 microdeletion syndrome

Stable Isotope Analysis Can Potentially Identify Completely-Digested Bloodmeals in Mosquitoes

Background: Vertebrate bloodfeeding is a critical component of a mosquito’s ability to transmit pathogens that cause diseases such as malaria, dengue fever and viral encephalitis. Due to degradation by the digestive process, current methods to identify mosquito bloodmeal sources are only useful for approximately 36 hours post-feeding. A critical need exists for technologies to extend this window and gain a more complete picture of mosquito feeding behavior for epidemiological studies. Stable isotopes are useful for investigating organism feeding behavior because the isotopic ratio of an organism’s tissues reflects that of the material it ingests. Methodology/Principal Findings: Proof-of-principle data indicates that after bloodfeeding, Aedes albopictus mosquitoes acquire diagnostic Carbon and Nitrogen stable isotope profiles from their vertebrate hosts that can be accurately identified one week post-feeding, approximately 4 days after the entire bloodmeal has been digested. Total C/N ratio served as a biomarker marker for bloodfeeding (P,0.02), while dN was the most informative variable which could distinguish between unfed, chicken-fed and human-fed mosquitoes (P,0.01). By plotting C/N vs. dN, all feeding treatments could be identified in a double-blind analysis. Conclusions/Significance: These proof-of-principle experiments indicate that analysis of stable isotopes can be used to distinguish bloodfed from unfed mosquitoes, and also distinguish between different vertebrate bloodmeal sources eve

Personality, personnel selection, and job performance

Job Performance: The term job performance can either refer to the objective or subjective outcomes one achieves in a specific job (e.g., the profit of a sales persons, the number of publications of a scientist, the number of successful operations of a surgeon) or to work-related activities (e.g., writing an article, conducting specific surgical acts). In the majority of research on this topic, job performance as an outcome is used. Personnel selection: Personnel selection refers to the process of selecting the best employees for specific jobs. Introduction One major application of personality research is in the area of personnel selection. The key question in this area is to which extent personality can predict how well a candidate will perform on the job he or she is applying for. Most scholars in this area acknowledge that personality has predictive validity for job performance. In line with this, personality assessment is part of the selection procedure in many organizations

Analysis of neonatal clinical trials with twin births

<p>Abstract</p> <p>Background</p> <p>In neonatal trials of pre-term or low-birth-weight infants, twins may represent 10–20% of the study sample. Mixed-effects models and generalized estimating equations are common approaches for handling correlated continuous or binary data. However, the operating characteristics of these methods for mixes of correlated and independent data are not well established.</p> <p>Methods</p> <p>Simulation studies were conducted to compare mixed-effects models and generalized estimating equations to linear regression for continuous outcomes. Similarly, mixed-effects models and generalized estimating equations were compared to ordinary logistic regression for binary outcomes. The parameter of interest is the treatment effect in two-armed clinical trials. Data from the National Institute of Child Health & Human Development Neonatal Research Network are used for illustration.</p> <p>Results</p> <p>For continuous outcomes, while the coverage never fell below 0.93, and the type I error rate never exceeded 0.07 for any method, overall linear mixed-effects models performed well with respect to median bias, mean squared error, coverage, and median width. For binary outcomes, the coverage never fell below 0.90, and the type I error rate never exceeded 0.07 for any method. In these analyses, when randomization of twins was to the same treatment group or done independently, ordinary logistic regression performed best. When randomization of twins was to opposite treatment arms, a rare method of randomization in this setting, ordinary logistic regression still performed adequately. Overall, generalized linear mixed models showed the poorest coverage values.</p> <p>Conclusion</p> <p>For continuous outcomes, using linear mixed-effects models for analysis is preferred. For binary outcomes, in this setting where the amount of related data is small, but non-negligible, ordinary logistic regression is recommended.</p