A test and measurement technique for determining possible lightning-induced voltages in aircraft electrical circuits

Transient analyzer consists of four 0.5 microfarads capacitors chargeable by self-contained solid state 50 KV dc power supply operating from standard 110 Vac line voltage. Unit can circulate unidirectional current impulses of up to 500 amperes through aircraft at waveshapes similar to those of natural lightning strokes

Preliminary tests of vulnerability of typical aircraft electronics to lightning-induced voltages

Tests made on two pieces of typical aircraft electronics equipment to ascertain their vulnerability to simulated lightning-induced transient voltages representative of those which might occur in flight when the aircraft is struck by lightning were conducted. The test results demonstrated that such equipment can be interfered with or damaged by transient voltages as low as 21 volts peak. Greater voltages can cause failure of semiconductor components within the equipment. The results emphasize a need for establishment of coordinated system susceptibility and component vulnerability criteria to achieve lightning protection of aerospace electrical and electronic systems

Lightning effects on the NASA F-8 digital-fly-by-wire airplane

The effects of lightning on a Digital Fly-By-Wire (DFBW)aircraft control system were investigated. The aircraft was a NASA operated F-8 fitted with a modified Apollo guidance computer. Current pulses similar in waveshape to natural lightning, but lower in amplitude, were injected into the aircraft. Measurements were made of the voltages induced on the DFBW circuits, the total current induced on the bundles of wires, the magnetic field intensity inside the aircraft, and the current density on the skin of the aircraft. Voltage measurements were made in both the line-to-ground and line-to-line modes. Voltages measured at the non-destructive test level were then scaled upward to determine how much would be produced by actual lightning. A 200,000 ampere severe lightning flash would produce between 40 and 2000 volts in DFBW circuits. Some system components are expected to be vulnerable to these voltages

Targeting the Hippo/YAP/TAZ signalling pathway: Novel opportunities for therapeutic interventions into skin cancers

\ua9 2022 The Authors. Experimental Dermatology published by John Wiley & Sons Ltd.Skin cancers are by far the most frequently diagnosed human cancers. The closely related transcriptional co-regulator proteins YAP and TAZ (WWTR1) have emerged as important drivers of tumour initiation, progression and metastasis in melanoma and non-melanoma skin cancers. YAP/TAZ serve as an essential signalling hub by integrating signals from multiple upstream pathways. In this review, we summarize the roles of YAP/TAZ in skin physiology and tumorigenesis and discuss recent efforts of therapeutic interventions that target YAP/TAZ in in both preclinical and clinical settings, as well as their prospects for use as skin cancer treatments

Reply to ``Comment on `Magnetic field effects on neutron diffraction in the antiferromagnetic phase of UPt3UPt_3'''

Fak, van Dijk and Wills (FDW) question our interpretation of elastic neutron-scattering experiments in the antiferromagnetic phase of UPt_3. They state that our analysis is incorrect because we average over magnetic structures that are disallowed by symmetry. We disagree with FDW and reply to their criticism. FDW also point out that we have mistaken the magnetic field direction in the experiment reported by N. H. van Dijk et al. [Phys. Rev. B 58, 3186 (1998)]. We correct this error and note that our previous conclusion is also valid for the correct field orientation.Comment: 3 page

Order and phase nucleation in nonequilibrium nanocomposite Fe-Pt thin films with perpendicular magnetic anisotropy

We report on the time evolution of mass transport upon annealing nonequilibrium Fe-Pt nanocomposite films, leading to nucleation of L1(0) chemically ordered phase. The nonequilibrium nanocomposite films were fabricated by applying Fe(+) ion implantation to epitaxial Pt films grown on (001) MgO substrates, yielding Fe nanoclusters embedded in a Pt matrix at a tailored penetration depth. Time-resolved x-ray diffraction studies were carried out using synchrotron radiation, allowing determination of the activation energy for nucleation of the FePt L1(0) phase within the segregated nanoclusters during annealing. The growth of the segregated L1(0) ordered phase was modeled using ideal grain-size law and found to be dominated by strain-driven surface nucleation. The activation energies were found to correlate with the nanocluster size. Magnetic characterization of selected annealed samples indicates perpendicular magnetic anisotropy with high coercive field coincident with high value of the chemical order parameter of the ordered phase within the magnetic nanoclusters

Comment on "Magnetic field effects on neutron diffraction in the antiferromagnetic phase of UPt3"

Moreno and Sauls [Phys. Rev. B 63, 024419 (2000)] have recently tried to reanalyze earlier neutron scattering studies of the antiferromagnetic order in UPt3 with a magnetic field applied in the basal plane. In their calculation of the magnetic Bragg peak intensities, they perform an average over different magnetic structures belonging to distinct symmetry representations. This is incorrect. In addition, they have mistaken the magnetic field direction in one of the experiments, hence invalidating their conclusions concerning the experimental results.Comment: Revised 5 June 2001: Added group theory analysis and modified discussion of S and K domain

Experience with a fluorescence‐based beam position monitor at the APS

We have recently redesigned the first crystal mount of our cryogenically cooled monochromator to reduce its sensitivity to pressure fluctuations in the cryogenic lines feeding the Si (111) crystal. With the use of a fluorescence‐based X‐ray beam position monitor (BPM) placed 19 m away from the monochromator, much operational experience has been gained on the sensitivity of the beam position and intensity to small changes in the cooling system. In this presentation, we will describe our X‐ray BPM design and performance and will provide examples of changes that have made the beam position more stable on our beamline. One such change for example has been the top‐up operation of the Advanced Photon Source (APS), which has reduced the thermal drifts associated with the ring current decay. © 2004 American Institute of PhysicsPeer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/87659/2/679_1.pd