Classification of journal surfaces using surface topography parameters and software methods to compensate for stylus geometry

Measurements made with a stylus surface tracer which provides a digitized representation of a surface profile are discussed. Parameters are defined to characterize the height (e.g., RMS roughness, skewness, and kurtosis) and length (e.g., autocorrelation) of the surface topography. These are applied to the characterization of crank shaft journals which were manufactured by different grinding and lopping procedures known to give significant differences in crank shaft bearing life. It was found that three parameters (RMS roughness, skewness, and kurtosis) are necessary to adequately distinguish the character of these surfaces. Every surface specimen has a set of values for these three parameters. They can be regarded as a set coordinate in a space constituted by three characteristics axes. The various journal surfaces can be classified along with the determination of a proper wavelength cutoff (0.25 mm) by using a method of separated subspace. The finite radius of the stylus used for profile tracing gives an inherent measurement error as it passes over the fine structure of the surface. A mathematical model is derived to compensate for this error

Aggregation of frictional particles due to capillary attraction

Capillary attraction between identical millimeter sized spheres floating at a liquid-air interface and the resulting aggregation is investigated at low Reynolds number. We show that the measured capillary forces between two spheres as a function of distance can be described by expressions obtained using the Nicolson approximation at low Bond numbers for far greater particle sizes than previously assumed. We find that viscous hydrodynamics interactions between the spheres needs to be included to describe the dynamics close to contact. We then consider the aggregates formed when a third sphere is added after the initial two spheres are already in contact. In this case, we find that linear superposition of capillary forces describes the observed approach qualitatively but not quantitatively. Further, we observe an angular dependence of the structure due to a rapid decrease of capillary force with distance of separation which has a tendency to align the particles before contact. When the three particles come in contact, they may preserve their shape or rearrange to form an equilateral triangle cluster - the lowest energy state - depending on the competition between attraction between particles and friction. Using these observations, we demonstrate that a linear particle chain can be built from frictional particles with capillary attraction.Comment: accepted for Physical Review

Meta-analysis of randomized trials on the association of prophylactic acyclovir and HIV-1 viral load in individuals coinfected with herpes simplex virus-2

To summarize the randomized evidence regarding the association between acyclovir use and HIV-1 replication as measured by plasma HIV-1 RNA viral load among individuals coinfected with herpes simplex virus (HSV)-2

Association Between Unprotected Ultraviolet Radiation Exposure and Recurrence of Ocular Herpes Simplex Virus

Studies have suggested that exposure to ultraviolet (UV) light may increase risk of herpes simplex virus (HSV) recurrence. Between 1993 and 1997, the Herpetic Eye Disease Study (HEDS) randomized 703 participants with ocular HSV to receipt of acyclovir or placebo for prevention of ocular HSV recurrence. Of these, 308 HEDS participants (48% female and 85% white; median age, 49 years) were included in a nested study of exposures thought to cause recurrence and were followed for up to 15 months. We matched weekly UV index values from the National Oceanic and Atmospheric Administration to each participant's study center and used marginal structural Cox models to account for time-varying psychological stress and contact lens use and selection bias from dropout. There were 44 recurrences of ocular HSV, yielding an incidence of 4.3 events per 1,000 person-weeks. Weighted hazard ratios comparing persons with ≥8 hours of time outdoors to those with less exposure were 0.84 (95% confidence interval (CI): 0.27, 2.63) and 3.10 (95% CI: 1.14, 8.48) for weeks with a UV index of <4 and ≥4, respectively (ratio of hazard ratios = 3.68, 95% CI: 0.43, 31.4). Though results were imprecise, when the UV index was higher (i.e., ≥4), spending 8 or more hours per week outdoors was associated with increased risk of ocular HSV recurrence

Wear behaviour of cast aluminium silicon (Al-Si) alloy in dot 4 brake fluid

Abstract : The frictional sliding behaviour of cast Al-Si alloy was investigated with and without DOT 4 hydraulic brake fluid lubrication/environments. Cast Al-Si specimen was produced from wrought alloy and the specimen surface was metallurgically prepared. The as- cast product was characterized with aid of micro-hardness tester, the chemical composition was analysed by X-ray fluorescence (XRF), while X-ray diffraction (XRD) was used to identify phases present, microstructures and surface examinations were done on a high resolution metallurgical Optical Microscope. The properties of the polished and worn sample surfaces were examined by Scanning electron microscope (SEM) equipped with Energy dispersive X- ray (EDS) facilities. A 6mm diameter alumina ball under varying normal loads (3-10 N) was rubbed against the surface of the cast Al-Si coupon specimen. The dry and wet sliding wear behaviour was assessed based on the CoF-sliding time behaviour. From the results, the average CoF values of 0.9064 for dry and 0.2038 for wet contacts were obtained. Comparatively, 1.03E-06 and 4.21E-07 minimum wear intensities; and 467290 and 132170 wear resistances were obtained for dry and wet contacts respectively. Behaviour of cast Al-Si in DOT4 were compared with its performance in DOT3 regarding the hydraulic brake system application

Health Insurance Type and Control of Hypertension Among US Women Living With and Without HIV Infection in the Women’s Interagency HIV Study

BACKGROUND: Health care access is an important determinant of health. We assessed the effect of health insurance status and type on blood pressure control among US women living with (WLWH) and without HIV. METHODS: We used longitudinal cohort data from the Women's Interagency HIV Study (WIHS). WIHS participants were included at their first study visit since 2001 with incident uncontrolled blood pressure (BP) (i.e., BP ≥140/90 and at which BP at the prior visit was controlled (i.e., <135/85). We assessed time to regained BP control using inverse Kaplan-Meier curves and Cox proportional hazard models. Confounding and selection bias were accounted for using inverse probability-of-exposure-and-censoring weights. RESULTS: Most of the 1,130 WLWH and 422 HIV-uninfected WIHS participants who had an elevated systolic or diastolic measurement were insured via Medicaid, were African-American, and had a yearly income ≤$12,000. Among participants living with HIV, comparing the uninsured to those with Medicaid yielded an 18-month BP control risk difference of 0.16 (95% CI: 0.10, 0.23). This translates into a number-needed-to-treat (or insure) of 6; to reduce the caseload of WLWH with uncontrolled BP by one case, five individuals without insurance would need to be insured via Medicaid. Blood pressure control was similar among WLWH with private insurance and Medicaid. There were no differences observed by health insurance status on 18-month risk of BP control among the HIV-uninfected participants. CONCLUSIONS: These results underscore the importance of health insurance for hypertension control-especially for people living with HIV

Impact of Health Insurance, ADAP, and Income on HIV Viral Suppression Among US Women in the Womenʼs Interagency HIV Study, 2006–2009

Implementation of the Affordable Care Act motivates assessment of health insurance and supplementary programs, such as the AIDS Drug Assistance Program (ADAP) on health outcomes of HIV-infected people in the United States. We assessed the effects of health insurance, ADAP, and income on HIV viral load suppression

How being appreciative creates change – theory in practice from health and social care in Scotland

This paper develops understanding of appreciative action research that generates curiosity and motivation as a better platform for collaborative change. Blending theory and practice it draws on the example of the My Home Life leadership programme in Scotland that explores the concepts and approaches of ‘Caring Conversations’ and ‘playful provocation’ in care homes for older people. The paper shows how they expand notions of appreciation and help people to deepen inquiry, explore values, acknowledge and express emotion without dispute or judgement, articulate tacit knowledge and give voice to things previously thought to be ‘unsayable’. We explore how these generative approaches act as a powerful positive ‘disruption’ that brings existing relationships to life, supports a positive attitude to risk-taking and helps to devise new approaches to the local design and testing of approaches to problems. Ultimately these approaches play an important part in developing understanding of how to do appreciative action research to enhance relationships and more strengths or assets-based and collaborative ways of working and so, to develop new possibilities for changing social systems and a more future-making orientation to action research

Theory of differential inclusions and its application in mechanics

The following chapter deals with systems of differential equations with discontinuous right-hand sides. The key question is how to define the solutions of such systems. The most adequate approach is to treat discontinuous systems as systems with multivalued right-hand sides (differential inclusions). In this work three well-known definitions of solution of discontinuous system are considered. We will demonstrate the difference between these definitions and their application to different mechanical problems. Mathematical models of drilling systems with discontinuous friction torque characteristics are considered. Here, opposite to classical Coulomb symmetric friction law, the friction torque characteristic is asymmetrical. Problem of sudden load change is studied. Analytical methods of investigation of systems with such asymmetrical friction based on the use of Lyapunov functions are demonstrated. The Watt governor and Chua system are considered to show different aspects of computer modeling of discontinuous systems