Electrostatically controlled heat shutter

A heat transfer assembly for conducting thermal energy is described. The assembly includes a hermetically sealed container enclosing a quantity of inert gas such as nitrogen. Two opposed walls of the container have high thermal conducting characteristics while the connecting walls have low thermal conducting characteristics. Electrodes are positioned adjacent to the high thermal conducing walls and biased relative to the conducting walls to a corona potential for creating an ionic gas wind which must contact the conducting walls to be neutralized. The contact of the gas molecules permits the maximum thermal energy transfer between the walls. Baffles can be positioned adjacent to the electrodes to regulate gas flow between the high thermal conducting surfaces

Heated bimetal strip prevents damage of bearings by vibration

Strip of bimetal is shaped as split ring; when properly fabricated from thin sheet, width of strip increases when it is heated. When width of strip increases, outer races are forced apart, thus pressing balls tightly against inner races. Strip applies axial load to bearing, amount of load being function of temperature to which strip is heated

Using CMOS Sensors in a Cellphone for Gamma Detection and Classification

The CMOS camera found in many cellphones is sensitive to ionized electrons. Gamma rays penetrate into the phone and produce ionized electrons that are then detected by the camera. Thermal noise and other noise needs to be removed on the phone, which requires an algorithm that has relatively low memory and computational requirements. The continuous high-delta algorithm described fits those requirements. Only a small fraction of the energy of even the electron is deposited in the camera sensor, so direct methods of measuring the energy cannot be used. The fraction of groups of lit up pixels that are lines is correlated with the energy of the gamma rays. This correlation under certain conditions allows limited low resolution energy resolution to be performed

Ultrasonic scanner for footprint identification

Scanner includes transducer, acoustical drive, acoustical receiver, X and Y position indicators, and cathode-ray tube. Transducer sends ultrasonic pulses into shoe sole or shoeprint. Reflected signals are picked up by acoustic receiver and fed to cathode-ray tube. Resulting display intensity is directly proportional to reflected signal magnitude

Photography equipment and techniques. A survey of NASA developments

The Apollo program has been the most complex exploration ever attempted by man, requiring extensive research, development, and engineering in most of the sciences before the leap through space could begin. Photography has been used at each step of the way to document the efforts and activities, isolate mistakes, reveal new phenomena, and to record much that cannot be seen by the human eye. At the same time, the capabilities of photography were extended because of the need of meeting space requirements. The results of this work have been applied to community planning and ecology, for example, as well as to space and engineering. Special uses of standard equipment, modifications and new designs, as well as film combinations that indicate actual or potential ecological problems are described

Electrothermal linear actuator

Converting electric power into powerful linear thrust without generation of magnetic fields is accomplished with an electrothermal linear actuator. When treated by an energized filament, a stack of bimetallic washers expands and drives the end of the shaft upward

Who Speaks for Me?: Addressing Variability in Informed Consent Practices for Minimal Risk Research Involving Foster Youth

Background: Youth in protective custody (i.e., foster care) are at higher risk for poorer physical and mental health outcomes compared with those who are not. These differences may be due in part to the lack of research on the population to create evidence-based recommendations for health care delivery. A potential contributor to this lack of research is difficulties in obtaining informed consent for empirical studies in this population. The objective of this study was to describe the approaches to obtaining informed consent in minimal risk studies of foster youth and provide recommendations for future requirements. Methods: We conducted a systematic review of the literature to characterize the informed consent approaches in published minimal risk research involving youth in foster care. We searched PubMed, CINAHL, PsychINFO, Embase, ERIC, Scopus, and EBMR. Inclusion criteria were: studies conducted in the United States, included current foster youth, minimal risk, peer reviewed, and published in English. Full text was reviewed, and individuals required to consent and assent were extracted. Results: Forty-nine publications from 33 studies were identified. Studies required 0 to 3 individuals to consent. Individuals required to give consent included case workers (16, 48%), foster caregivers (12, 36%), biological parents (7, 21%), judges (5, 15%), and guardian ad litems (2, 6%). Twenty-nine (88%) studies required the youth’s assent. The studies used 14 different combinations of individuals. One (3%) study utilized a waiver of consent. Conclusions: There is no consistent approach for obtaining informed consent for foster youth to participate in minimal risk research. Consent should ideally involve individuals with legal authority and knowledge of the individual youth’s interests and should not be burdensome. Consensus regarding consent requirements may facilitate research involving foster youth

The Ursinus Weekly, January 17, 1916

Varsity triumphs over Moravian • Condensed news from the seminary • National campaign for colleges • Professor Jolls visits Millville, New Jersey • Zwinglian prize essay: Nature\u27s university • Among the colleges • Inter-group basketball • Literary societies • Alumnus makes good • Among the indisposed • Reserves defeated at Phoenixville • College directoryhttps://digitalcommons.ursinus.edu/weekly/2613/thumbnail.jp