386 research outputs found
Recommended from our members
Development and Validation of a Thermo-Economic Model for Design Optimisation and Off-Design Performance Evaluation of a Pure Solar Microturbine
The aim of this paper is to present a thermo-economic model of a microturbine for solar dish applications, which demonstrates the applicability and accuracy of the model for off-design performance evaluation and techno-economic optimisation purposes. The model is built using an object-oriented programming approach. Each component is represented using a class made of functions that perform a one-dimensional physical design, off-design performance analysis and the component cost evaluation. Compressor, recuperator, receiver and turbine models are presented and validated against experimental data available in literature, and each demonstrated good accuracy for a wide range of operating conditions. A 7-kWe microturbine and solar irradiation data available for Rome between 2004 and 2005 were considered as a case study, and the thermo-economic analysis of the plant was performed to estimate the levelised cost of electricity based on the annual performance of the plant. The overall energy produced by the plant is 10,682 kWh, the capital cost has been estimated to be EUR 27,051 and, consequently, the specific cost of the plant, defined as the ratio between the cost of components and output power in design condition, has been estimated to be around EUR 3980/kWe. Results from the levelised cost of electricity (LCOE) analysis demonstrate a levelised cost of electricity of EUR 22.81/kWh considering a plant lifetime of 25 years. The results of the present case study have been compared with the results from IPSEpro 7 where the same component characteristic maps and operational strategy were considered. This comparison was aimed to verify the component matching procedure adopted for the present model. A plant sizing optimisation was then performed to determine the plant size which minimises the levelised cost of electricity. The design space of the optimisation variable is limited to the values 0.07–0.16 kg/s. Results of the optimisation demonstrate a minimum LCOE of 21.5 [EUR/kWh] for a design point mass flow rate of about 0.11 kg/s. This corresponds to an overall cost of the plant of around EUR 32,600, with a dish diameter of 9.4 m and an annual electricity production of 13,700 [kWh]
The role of General Relativity in the evolution of Low Mass X-ray Binaries
We study the evolution of Low Mass X-ray Binaries (LMXBs) and of millisecond
binary radio pulsars (MSPs), with numerical simulations that keep into account
the evolution of the companion, of the binary system and of the neutron star.
According to general relativity, when energy is released, the system loses
gravitational mass. Moreover, the neutron star can collapse to a black hole if
its mass exceeds a critical limit, that depends on the equation of state. These
facts have some interesting consequences: 1) In a MSP the mass-energy is lost
with a specific angular momentum that is smaller than the one of the system,
resulting in a positive contribution to the orbital period derivative. If this
contribution is dominant and can be measured, we can extract information about
the moment of inertia of the neutron star, since the energy loss rate depends
on it. Such a measurement can therefore help to put constraints on the equation
of state of ultradense matter. 2) In LMXBs below the bifurcation period (\sim
18 h), the neutron star survives the period gap only if its mass is smaller
than the maximum non-rotating mass when the companion becomes fully convective
and accretion pauses. Therefore short period (P < 2h) millisecond X-ray pulsar
like SAX J1808.4-3658 can be formed only if either a large part of the
accreting matter has been ejected from the system, or the equation of state of
ultradense matter is very stiff. 3) In Low Mass X-ray binaries above the
bifurcation period, the mass-energy loss lowers the mass transfer rate. As side
effect, the inner core of the companion star becomes 1% bigger than in a system
with a non-collapsed primary. Due to this difference, the final orbital period
of the system becomes 20% larger than what is obtained if the mass-energy loss
effect is not taken into account.Comment: 7 pages, 3 figures, accepted by the MNRA
Recommended from our members
Reducing Levelised Cost of Energy and Environmental Impact of a Hybrid Microturbine-Based Concentrated Solar Power Plant
A multi-objective optimisation of a hybrid solar dish power plant aiming to minimise the levelised cost of energy while keeping emissions as low as possible is presented in this paper. The analysis was carried out for both regenerative Brayton-Joule regenerative cycle and inter-cooled and re-heated regenerative cycle using an analysis tool developed during this research and validated against available experimental data. The plant optimisation was performed using a fast and computationally efficient optimisation technique called “response surface optimisation”, which generates an approximated function (or response surface) that can be used to find a set of thermodynamic parameters that maximise the plant efficiency while minimising emissions. A Design of Experiment (DOE) Latin hypercube technique was used to generate the training database and a one-dimensional model were used to evaluate the output variables for each point of the database. The DOE was then coupled to a Second Order Polynomial regression technique to approximate the behaviour of the system in the design space. A genetic algorithm was then applied in order to find a high performance arrangement. Results show a good trade-off between emissions and levelised cost of energy for both plant layouts. The first arrangment shows a minimum levelised cost of energy in the range between 38.5 and 38.8 €cts/kWh with an electrical power production of about 8kW. The second showed a LCOE in the range between 50.5 and 51 €cts/kWh and a net electrical power output of 16 kW
Recommended from our members
Multi-Objective Optimisation of A Centrifugal Compressor for a Micro Gas Turbine Operated by Concentrated Solar Power
Solar powered micro-gas turbines (MGTs) are required to work over a wide range of operating conditions due to the fluctuations in the solar insulation. This means that the compressor has to perform efficiently over a wider range than in conventional MGTs. To be able to extend the efficient operating range of a compressor at the design stage, both impeller blades and diffuser passage need to be optimised. Vaneless diffusers could offer more flexibility to extend the operating range than typical diffuser vanes. This paper presents a methodology for the design and optimisation of a centrifugal compressor for a 6 kW micro-gas turbine intended for operation using a Concentrated Solar Power (CSP) system using a parabolic dish concentrator. Preliminary design parameters were obtained from the overall system specifications and detailed cycle analysis combined with practical constraints. The compressor’s geometry optimisation has been performed using a fast and computationally efficient method, which involves the Latin hypercube Design of Experiment (DoE) technique coupled with the response surface method (RSM) in order to build a regression model through CFD simulations. Three different RSM techniques were compared with the aim to choose the most suitable technique for this specific application and then a genetic algorithm was applied. The CFD analysis for the optimised compressor showed that the high efficiency operating range has increased compared to the baseline design. Cycle analysis for the plant has been performed in order to evaluate the effect of the new compressor design on the system performance. The simulations demonstrated that the operating range of the plant was increased by over 30%
Chandra Observation of the Dipping Source XB 1254-690
We present the results of a 53 ks long Chandra observation of the dipping
source XB 1254--690. During the observation neither bursts or dips were
observed. From the zero-order image we estimated the precise X-ray coordinates
of the source with a 90% uncertainty of 0.6\arcsec. Since the lightcurve did
not show any significant variability, we extracted the spectrum corresponding
to the whole observation. We confirmed the presence of the \ion{Fe}{xxvi}
K absorption lines with a larger accuracy with respect to the previous
XMM EPIC pn observation. Assuming that the line width were due to a bulk motion
or a turbulence associated to the coronal activity, we estimate that the lines
were produced in a photoionized absorber between the coronal radius and the
outer edge of the accretion disk.Comment: 8 pages, 10 figs, accepted by A&A on 6 December 200
A self-consistent approach to the reflection component in 4U 1705-44
High-resolution spectroscopy has recently revealed in many neutron-star Low-Mass X-ray binaries that the shape of the broad iron line observed in the 6.4-6.97 keV range is consistently well fitted by a relativistically smeared line profile. We show here spectral fitting results using a newly developed self-consistent reflection model on XMM-Newton data of the LMXB 4U 1705-44 during a period when the source was in a bright soft state. This reflection model adopts a blackbody prescription for the shape of the impinging radiation field, that we physically associate with the boundary layer emission. \ua9 2010 American Institute of Physics
The BeppoSAX 0.1 - 100 keV Spectrum of the X-ray Pulsar 4U 1538-52
We report the results of temporal and spectral analysis performed on the X-ray pulsar 4U 1538-52 observed by BeppoSAX. We obtained a new estimate of the spin period of the neutron star P=528.24 \pm 0.01 s (corrected for the orbital motion of the X-ray source): the source is still in the spin-up state, as since 1988. The pulse profile is double peaked, although significant variations of the relative intensity of the peaks with energy are present. The broad band (0.12-100 keV) out-of-eclipse spectrum is well described by an absorbed power law modified by a high energy cutoff at \sim 16 keV (e-folding energy \sim 10 keV) plus an iron emission line at \sim 6.4 keV. A cyclotron line at \sim 21 keV is present. The width of the line is consistent with thermal Doppler broadening at the temperature of the exponential cutoff. We searched for the presence of the second harmonic, previously reported for this source. We found no evidence of lines at \sim 42 keV, although an absorption feature at 51 keV seems to be present (at 99% confidence level). A soft excess, modelled by a blackbody with a temperature of \sim 0.08 keV could be present, probably emitted by the matter at the magnetosphere. We also performed a spectral analysis during the X-ray eclipse. The spectral evolution during the eclipse can be well described by a progressive covering of the primary Comptonization spectrum that is scattered into the line of sight. During the deep eclipse this spectrum also softens, suggesting that the dust-scattered component becomes important. An alternative, more complex model, with an emission iron line and scattered components (as the one that has been used to fit the eclipse of Centaurus X-3), also gives a good fit of the deep-eclipse data
SAX J1808.4-3658, an accreting millisecond pulsar shining in gamma rays?
We report the detection of a possible gamma-ray counterpart of the accreting
millisecond pulsar SAX J1808.4-3658. The analysis of ~6 years of data from the
Large Area Telescope on board the Fermi Gamma-ray Space Telescope (Fermi-LAT)
within a region of 15deg radius around the position of the pulsar reveals a
point gamma-ray source detected at a significance of ~6 sigma (Test Statistic
TS = 32), with position compatible with that of SAX J1808.4-3658 within 95%
Confidence Level. The energy flux in the energy range between 0.6 GeV and 10
GeV amounts to (2.1 +- 0.5) x 10-12 erg cm-2 s-1 and the spectrum is
well-represented by a power-law function with photon index 2.1 +- 0.1. We
searched for significant variation of the flux at the spin frequency of the
pulsar and for orbital modulation, taking into account the trials due to the
uncertainties in the position, the orbital motion of the pulsar and the
intrinsic evolution of the pulsar spin. No significant deviation from a
constant flux at any time scale was found, preventing a firm identification via
time variability. Nonetheless, the association of the LAT source as the
gamma-ray counterpart of SAX J1808.4-3658 would match the emission expected
from the millisecond pulsar, if it switches on as a rotation-powered source
during X-ray quiescence.Comment: 8 pages, 4 figures, accepted by MNRA
Chandra Observation of the Big Dipper X 1624-490
We present the results of a 73 ks long Chandra observation of the dipping source X 1624-490. During the observation a complex dip lasting 4 hours is observed. We analyse the persistent emission detecting, for the first time in the 1st-order spectra of X 1624-490, an absorption line associated to \ion{Ca}{xx}. We confirm the presence of the \ion{Fe}{xxv} K and \ion{Fe}{xxvi} K absorption lines with a larger accuracy with respect to a previous XMM observation. Assuming that the line widths are due to a bulk motion or a turbulence associated to the coronal activity, we estimate that the lines have been produced in a photoionized absorber between the coronal radius and the outer edge of the accretion disk
An XMM-Newton and INTEGRAL view on the hard state of EXO 1745-248 during its 2015 outburst
CONTEXT - Transient low-mass X-ray binaries (LMXBs) often show outbursts
lasting typically a few-weeks and characterized by a high X-ray luminosity
( erg/sec), while for most of the time they are
found in X-ray quiescence ( erg/sec). EXO 1745-248
is one of them. AIMS - The broad-band coverage, and the sensitivity of
instrument on board of {\xmm} and {\igr}, offers the opportunity to
characterize the hard X-ray spectrum during {\exo} outburst. METHODS - In this
paper we report on quasi-simultaneous {\xmm} and {\igr} observations of the
X-ray transient {\exo} located in the globular cluster Terzan 5, performed ten
days after the beginning of the outburst (on 2015 March 16th) shown by the
source between March and June 2015. The source was caught in a hard state,
emitting a 0.8-100 keV luminosity of ~{\lumcgs}. RESULTS - The
spectral continuum was dominated by thermal Comptonization of seed photons with
temperature keV, by a cloud with moderate optical depth
and electron temperature keV. A weaker soft
thermal component at temperature --0.7 keV and compatible
with a fraction of the neutron star radius was also detected. A rich emission
line spectrum was observed by the EPIC-pn on-board {\xmm}; features at energies
compatible with K- transitions of ionized sulfur, argon, calcium and
iron were detected, with a broadness compatible with either thermal Compton
broadening or Doppler broadening in the inner parts of an accretion disk
truncated at gravitational radii from the neutron star. Strikingly, at
least one narrow emission line ascribed to neutral or mildly ionized iron is
needed to model the prominent emission complex detected between 5.5 and 7.5
keV. (Abridged)Comment: 14 pages, 6 figure, 2 tables. Accepted for publication on A&A
(21/03/2017
- …