Development of single-cell protectors for sealed silver-zinc cells

Three design approaches to cell-level protection were developed, fabricated, and tested. These systems are referred to as the single-cell protector (SCP), multiplexed-cell protector(MCP). To evaluate the systems 18-cell battery packs without cell level control were subjected to cycle life test. A total of five batteries were subjected to simulate synchronous orbit cycling at 40% depth of discharge at 22C. Batteries without cell-level protection failed between 345 and 255 cycles. Cell failure in the cell level protected batteries occurred between 412 and 540. It was determined that the cell-level monitoring and protection is necessary to attain the long cycle life of a AgZn battery. The best method of providing control and protection of the AgZn cells depends on the specific application and capability of the user

Ricci-flat deformation of orbifolds and localized tachyonic modes

We study Ricci-flat deformations of orbifolds in type II theory. We obtain a simple formula for mass corrections to the twisted modes due to the deformations, and apply it to originally tachyonic and massless states in several examples. In the case of supersymmetric orbifolds, we find that tachyonic states appear when the deformation breaks all the supersymmetries. We also study nonsupersymmetric orbifolds C^2/Z_{2N(2N+1)}, which is T-dual to N type 0 NS5-branes. For N>=2, we compute mass corrections for states, which have string scale tachyonic masses. We find that the corrected masses coincide to ones obtained by solving the wave equation for the tachyon field in the smeared type 0 NS5-brane background geometry. For N=1, we show that the unstable mode representing the bubble creation is the unique tachyonic mode.Comment: 20 pages, minor collection

A non-linear numerical model for stratified Tsunami waves and its application

A non-linear numerical model is developed for the computation of water level and discharge for the propagation of a unidirectional two-layered tsunami wave. Four governing equations, two for each layer, are derived from Euler’s equations of motion and continuity, assuming a long wave approximation, negligible friction and no interfacial mixing. A numerical model is developed using a staggered Leap-Frog scheme. The developed non- linear model is compared with an existing validated linear model developed earlier by the author for different non-dimensional wave amplitudes. The significance of non-linear terms is discussed. It is found that for simulations of the interface wave amplitude, the effect of non-linear terms is not significant. However, for the simulation of the top surface, the effect of non-linear terms is significant for higher wave amplitudes, and insignificant for lower wave amplitudes. Developed non-linear numerical model is used for the case of a progressive internal wave in an inclined bay. It is found that the effect of an adverse bottom slipe towards the direction of wave propagation is to amplify the wave. This amplification depends on the steepness of slope as well as the ratio of densities of upper layer fluid to lower layer fluid (α). Amplification increases with slope. For higher values of α, amplification of the top and interface surface decreases, which is reasonable. It is also found that even for a 4 percent density difference between upper layer and lower layer, amplification of the top surface will be twenty times higher than amplification in the non-stratified case. The model can be applied confidently to simulate the basic features of different practical problems, similar to those investigated in this study

Polynuclear growth model, GOE2^2 and random matrix with deterministic source

We present a random matrix interpretation of the distribution functions which have appeared in the study of the one-dimensional polynuclear growth (PNG) model with external sources. It is shown that the distribution, GOE$^2$, which is defined as the square of the GOE Tracy-Widom distribution, can be obtained as the scaled largest eigenvalue distribution of a special case of a random matrix model with a deterministic source, which have been studied in a different context previously. Compared to the original interpretation of the GOE$^2$ as ``the square of GOE'', ours has an advantage that it can also describe the transition from the GUE Tracy-Widom distribution to the GOE$^2$. We further demonstrate that our random matrix interpretation can be obtained naturally by noting the similarity of the topology between a certain non-colliding Brownian motion model and the multi-layer PNG model with an external source. This provides us with a multi-matrix model interpretation of the multi-point height distributions of the PNG model with an external source.Comment: 27pages, 4 figure

Supergiant Barocaloric Effects in Acetoxy Silicone Rubber over a Wide Temperature Range: Great Potential for Solid-state Cooling

Solid-state cooling based on caloric effects is considered a viable alternative to replace the conventional vapor-compression refrigeration systems. Regarding barocaloric materials, recent results show that elastomers are promising candidates for cooling applications around room-temperature. In the present paper, we report supergiant barocaloric effects observed in acetoxy silicone rubber - a very popular, low-cost and environmentally friendly elastomer. Huge values of adiabatic temperature change and reversible isothermal entropy change were obtained upon moderate applied pressures and relatively low strains. These huge barocaloric changes are associated both to the polymer chains rearrangements induced by confined compression and to the first-order structural transition. The results are comparable to the best barocaloric materials reported so far, opening encouraging prospects for the application of elastomers in near future solid-state cooling devices.Comment: 19 pages, 7 figures, 2 table

Earth Pressure on Retaining Walls and Buried Pipe

This paper describes the results of earth pressure measurements buried pipes. Conventional earth pressure gauges fixed on the walls were type earth pressure gauges which covers the whole wall surface were used components of the resultant earth pressures were measured

Development of single cell protectors for sealed silver-zinc cells, phase 1

A single cell protector (SCP) assembly capable of protecting a single silver-zinc (Ag Zn) battery cell was designed, fabricated, and tested. The SCP provides cell-level protection against overcharge and overdischarge by a bypass circuit. The bypass circuit consists of a magnetic-latching relay that is controlled by the high and low-voltage limit comparators. Although designed specifically for secondary Ag-Zn cells, the SCP is flexible enough to be adapted to other rechargeable cells. Eighteen SCPs were used in life testing of an 18-cell battery. The cells were sealed Ag-Zn system with inorganic separators. For comparison, another 18-cell battery was subjected to identical life test conditions, but with battery-level protection rather than cell-level. An alternative approach to the SCP design in the form of a microprocessor-based system was conceptually designed. The comparison of SCP and microprocessor approaches is also presented and a preferred approach for Ag-Zn battery protection is discussed

Bioaccumulation surveillance in Milford Haven Waterway

Biomonitoring of contaminants (metals, organotins, PAHs, PCBs) was carried out along the Milford Haven Waterway (MHW) and at a reference site in the Tywi Estuary during 2007-2008. The species used as bioindicators encompass a variety of uptake routes - Fucus vesiculosus (dissolved contaminants); Littorina littorea (grazer); Mytilus edulis and Cerastoderma edule (suspension feeders); and Nereis diversicolor (omnivore which often reflects contaminants in sediment). Differences in feeding strategy and habitat preference have subtle implications for bioaccumulation trends though, with few exceptions, contaminant body burdens in Milford Haven (MH) were higher than those at the Tywi reference site, reflecting inputs. Elevated concentrations of metals were occasionally observed at individual MH sites, whilst As and Se (molluscs and seaweed) were, for much of MHW, consistently at the higher end of the UK range. However, for the majority of metals, distributions in MH biota were not exceptional by UK standards. Several metal-species combinations indicated increases in bioavailability at upstream sites, which may reflect the influence of geogenic or other land-based sources – perhaps enhanced by lower salinity (greater proportions of more bioavailable forms). TBT levels in MH mussels were below OSPAR toxicity thresholds and in the Tywi were close to zero. Phenyltins were not accumulated appreciably in Mytilus, whereas some Nereis populations may have been subjected to localized (historical) sources. PAHs in Nereis tended to be evenly distributed across most sites, but with somewhat higher values at Dale for acenaphthene, fluoranthene, pyrene, benzo(a)anthracene and chrysene; naphthalenes tended to be enriched further upstream in the mid-upper Haven (a pattern seen in mussels for most PAHs). Whilst concentrations in MH mussels were mostly above reference site and OSPAR backgrounds, it is unlikely that ecotoxicological guidelines would be exceeded. PCBs in mussels were between upper and lower OSPAR guidelines and were unusual in their distribution in that highest levels occurred at the mouth of MH. Condition indices (CI) of bivalves (mussels and cockles) were highest at the Tywi reference site and at the seaward end of MH, decreasing upstream along the Waterway. There were a number of significant (negative) relationships between CI and body burdens and multivariate analysis indicated that a combination of contaminants could influence the pattern in condition (and sub-lethal responses such as MT and TOSC) across sites. Cause and effect needs to be tested more rigorously in future assessments