Robust Digital Predistortion in Saturation Region of Power Amplifiers

This paper proposes a digital predistortion (DPD) technique to improve linearization performance when the power amplifier (PA) is driven near the saturation region. The PA is a non-linear device in general, and the nonlinear distortion becomes severer as the output power increases. However, the PA’s power efficiency increases as the PA output power increases. The nonlinearity results in spectral regrowth, which leads to adjacent channel interference, and degrades the transmit signal quality. According to our simulation, the linearization performance of DPD is degraded abruptly when the PA operates in its saturation region. To relieve this problem, we propose an improved DPD technique. The proposed technique performs on/off control of the adaptive algorithm based on the magnitude of the transmitted signal. Specifically, the adaptation normally works for small and medium signals while it stops for large signals. Therefore, harmful coefficient updates by saturated signals can be avoided. A computer simulation shows that the proposed method can improve the linearization performance compared with the conventional DPD method in highly driven PAs

A Polynomial Digital Pre-Distortion Technique Based on Iterative Architecture

A digital predistortion (DPD) technique based on an iterative adaptation structure is proposed for linearizing power amplifiers (PAs). To obtain proper DPD parameters, a feedback path that converts the PA’s output to a baseband signal is required, and memory is also needed to store the baseband feedback signals. DPD parameters are usually found by an adaptive algorithm by using the transmitted signals and the corresponding feedback signals. However, for the adaptive algorithm to converge to a reliable solution, long feedback samples are required, which increases hardware complexity and cost. Considering that the convergence time of the adaptive algorithm highly depends on the initial condition, we propose a DPD technique that requires relatively shorter feedback samples. Specifically, the proposed DPD iteratively utilizes the short feedback samples in memory while keeping and using the DPD parameters found at the former iteration as the initial condition at the next iteration. Computer simulation shows that the proposed technique performs better than the conventional technique, as the former requires much shorter feedback memory than the latter

MOMENT RESISTANCE PERFORMANCE OF LARCH LAMINATED TIMBER BEAM-COLUMN JOINTS REINFORCED WITH CFRP

This study evaluates the moment resisting capacity of the drift pin larch beam-column joint with slotted-in steel plates of larch laminated timber. It is reinforced with carbon fiber reinforced plastic (CFRP) to suppress the brittle fracture of the beam-column joint and improve the joint capacity using larch laminated timber, a wood material manufactured by multi-layering of timber as a structural member of heavy timber.The average maximum moment capacity of the control specimen was 16.9 kN·m and the average maximum moments of the Type-A (volume ratio of joint reinforced with CFRP: 3.6%) and Type-B (volume ratio of joint reinforced with CFRP: 5.4%) were increased by 46% and 62%, respectively, compared to that of the control specimen. The capacity of the joint, such as the average yield capacity, ultimate moment capacity, and ductility ratio, of the control, Type-A, and Type-B specimens increased as the reinforcement ratio of the CFRP increased. For the failure mode of the control specimen, splitting failure occurred in both the column and beam members in the end distance direction. However, the splitting failure did not occur in the beam member due to the improvement of the joint and ductility of the specimens reinforced with the CFRP. The Type-A specimen had improved joint capacity and ductility compared to the control specimen; however, brittle failure occurred owing to the external force exceeding the joint capacity. However, in some of the Type-B specimens, the splitting failure did not occur in the column and beam members due to the CFRP reinforcement. Particularly, the Type-B3 specimen exhibited ductility

Properties of oriented strand board made from Betung bamboo (Dendrocalamus asper (Schultes.f) Backer ex Heyne)

Bamboo has gained increasing attention as an alternative raw material for use in the manufacture of composite boards. Three-layer OSBs were made using Betung bamboo (Dendrocalamus asper (Schultes.f) Backer ex Heyne) strands to evaluate the effects of strand length and pre-treatment techniques on the physical, mechanical, and durability properties. Three different strand lengths, namely 50, 60, and 70 mm, were prepared. Prior to the manufacture into OSB, the strands were immersed in cold water for 24 h and in 6% acetic anhydrides solution for 48 h. The OSBs were fabricated using 5% MDI resin based on the strand dry weight. The results indicated that MOR and MOE values in perpendicular to the grain direction were much influenced by strand length. The dimensional stability of OSB was slightly improved by immersing the strands in acetic anhydride solution. Immersing strands in cold water and acetic anhydride solution improved the resistance of OSB against subterranean termite (Macrotermes gylvus) attack under the adopted experimental condition. All OSB parameters manufactured in this experiment were better than the minimum requirement of CSA 0437.0 (Grade O–2) standard

Use of Nafamostat Mesilate as an Anticoagulant during Extracorporeal Membrane Oxygenation

Although the incidence of bleeding complications during extracorporeal membrane oxygenator (ECMO) support has decreased in various trials, bleeding is still the most fatal complication. We investigated the ideal dosage and efficacy of nafamostat mesilate for use with ECMO in patients with acute cardiac or respiratory failure. We assessed 73 consecutive patients who received ECMO due to acute cardiac or respiratory failure between January 2006 and December 2009. To evaluate the efficacy of nafamostat mesilate, we divided the patients into 2 groups according to the anticoagulants used during ECMO support. All patients of nafamostat mesilate group were male with a mean age of 49.2 yr. Six, 3, 5, and 3 patients were diagnosed with acute myocardial infarction, cardiac arrest, septic shock, and acute respiratory distress syndrome, respectively. The mean dosage of nafamostat mesilate was 0.64 mg/kg/hr, and the mean duration of ECMO was 270.7 hr. The daily volume of transfused packed red blood cells, fresh frozen plasma, and cryoprecipitate and the number of complications related to hemorrhage and thrombosis was lower in the nafamostat mesilate group than in the heparin group. Nafamostat mesilate should be considered as an alternative anticoagulant to heparin to reduce bleeding complications during ECMO

Transcriptional activation of hypoxia-inducible factor-1 (HIF-1) in myeloid cells promotes angiogenesis through VEGF and S100A8

Emerging evidence indicates that myeloid cells are essential for promoting new blood vessel formation by secreting various angiogenic factors. Given that hypoxia-inducible factor (HIF) is a critical regulator for angiogenesis, we questioned whether HIF in myeloid cells also plays a role in promoting angiogenesis. To address this question, we generated a unique strain of myeloid-specific knockout mice targeting HIF pathways using human S100A8 as a myeloid-specific promoter. We observed that mutant mice where HIF-1 is transcriptionally activated in myeloid cells (by deletion of the von Hippel-Lindau gene) resulted in erythema, enhanced neovascularization in matrigel plugs, and increased production of vascular endothelial growth factor (VEGF) in the bone marrow, all of which were completely abrogated by either genetic or pharmacological inactivation of HIF-1. We further found that monocytes were the major effector producing VEGF and S100A8 proteins driving neovascularization in matrigel. Moreover, by using a mouse model of hindlimb ischemia we observed significantly improved blood flow in mice intramuscularly injected with HIF-1-activated monocytes. This study therefore demonstrates that HIF-1 activation in myeloid cells promotes angiogenesis through VEGF and S100A8 and that this may become an attractive therapeutic strategy to treat diseases with vascular defects.X1137Ysciescopu

Use of Nafamostat Mesilate as an Anticoagulant during Extracorporeal Membrane Oxygenation

Although the incidence of bleeding complications during extracorporeal membrane oxygenator (ECMO) support has decreased in various trials, bleeding is still the most fatal complication. We investigated the ideal dosage and efficacy of nafamostat mesilate for use with ECMO in patients with acute cardiac or respiratory failure. We assessed 73 consecutive patients who received ECMO due to acute cardiac or respiratory failure between January 2006 and December 2009. To evaluate the efficacy of nafamostat mesilate, we divided the patients into 2 groups according to the anticoagulants used during ECMO support. All patients of nafamostat mesilate group were male with a mean age of 49.2 yr. Six, 3, 5, and 3 patients were diagnosed with acute myocardial infarction, cardiac arrest, septic shock, and acute respiratory distress syndrome, respectively. The mean dosage of nafamostat mesilate was 0.64 mg/kg/hr, and the mean duration of ECMO was 270.7 hr. The daily volume of transfused packed red blood cells, fresh frozen plasma, and cryoprecipitate and the number of complications related to hemorrhage and thrombosis was lower in the nafamostat mesilate group than in the heparin group. Nafamostat mesilate should be considered as an alternative anticoagulant to heparin to reduce bleeding complications during ECMO

Unilateral Pulmonary Edema: A Rare Initial Presentation of Cardiogenic Shock due to Acute Myocardial Infarction

Cardiogenic unilateral pulmonary edema (UPE) is a rare clinical entity that is often misdiagnosed at first. Most cases of cardiogenic UPE occur in the right upper lobe and are caused by severe mitral regurgitation (MR). We present an unusual case of right-sided UPE in a patient with cardiogenic shock due to acute myocardial infarction (AMI) without severe MR. The patient was successfully treated by percutaneous coronary intervention and medical therapy for heart failure. Follow-up chest Radiography showed complete resolution of the UPE. This case reminds us that AMI can present as UPE even in patients without severe MR or any preexisting pulmonary disease affecting the vasculature or parenchyma of the lung