Preparation of Microcrystals of Piroxicam Monohydrate by Antisolvent Precipitation via Microfabricated Metallic Membranes with Ordered Pore Arrays

Microcrystals of piroxicam (PRX) monohydrate with a narrow size distribution were prepared from acetone/PRX solutions by antisolvent crystallization via metallic membranes with ordered pore arrays. Crystallization was achieved by controlled addition of the feed solution through the membrane pores into a well-stirred antisolvent. A complete transformation of an anhydrous form I into a monohydrate form of PRX was confirmed by Raman spectroscopy and differential scanning calorimetry. The size of the crystals was 7–34 μm and was controlled by the PRX concentration in the feed solution (15–25 g L¯¹), antisolvent/solvent volume ratio (5–30), and type of antisolvent (Milli-Q water or 0.1–0.5 wt % aqueous solutions of hydroxypropyl methyl cellulose (HPMC), poly(vinyl alcohol) or Pluronic P-123). The smallest crystals were obtained by injecting 25 g L¯¹ PRX solution through a stainless-steel membrane with a pore size of 10 μm into a 0.06 wt % HPMC solution stirred at 1500 rpm using an antisolvent/solvent ratio of 20. HPMC provided better steric stabilization of microcrystals against agglomeration than poly(vinyl alcohol) and Pluronic P-123, due to hydrogen bonding interactions with PRX and water. A continuous production of large PRX monohydrate microcrystals with a volume-weighted mean diameter above 75 μm was achieved in a continuous stirred membrane crystallizer. Rapid pouring of Milli-Q water into the feed solution resulted in a mixture of highly polydispersed prism-shaped and needle-shaped crystals

Continuous Membrane Emulsification with Pulsed (Oscillatory) Flow

This document is the Accepted Manuscript version of a Published Work that appeared in final form in Industrial and Engineering Chemistry Research, copyright © American Chemical Society after peer review and technical editing by the publisher. To access the final edited and published work see: http://dx.doi.org/10.1021/ie3020457Tubular micrometer pore sized sieve type membranes with internal diameter of 14 mm and length of 60 mm containing uniform pores of diameter 10 and 20 μm were used to generate emulsions of sunflower oil dispersed in water and stabilized by Tween 20 using oscillatory flow of the continuous phase. Drop diameters between 30 and 300 μm could be produced, in a controllable way and with span values of down to 0.4. By using pulsed flow it was possible to provide dispersed phase concentrations of up to 45% v/v in a single pass over the membrane, that is, without the need to recirculate the continuous phase through the membrane tube. It was possible to correlate the drop size produced with the shear conditions at the membrane surface using the wave shear stress equation. The oscillatory Reynolds number indicated flow varying from laminar to substantially turbulent, but the change in flow conditions did not show a notable influence on the drop diameters produced, over what is predicted by the varying wall shear stress applied to the wave equation. However, the 20 μm pore sized sieve type membrane appeared to allow the passage of the pressure pulse through the membrane pores, under certain operating conditions, which did lead to finer drop sizes produced than would be predicted. These through-membrane pulsations could be suppressed by changes in operating conditions: a higher dispersed phase injection rate or more viscous continuous phase, and they did not occur under similar operating conditions used with the 10 μm pore sized sieve type of membrane. Generating emulsions of this size using pulsed continuous phase flow provides opportunities for combining drop generation at high dispersed phase concentration, by membrane emulsification, with downstream processing such as reaction in plug flow reactors

The activity of signal crayfish (Pacifastacus leniusculus) in relation to thermal and hydraulic dynamics of an alluvial stream, UK

Signal crayfish (Pacifastacus leniusculus) are an invasive species of global significance because of their detrimental impacts on freshwater environments and native organisms. The movement of signal crayfish was continuously monitored for 150-days through a 20-m reach of an alluvial stream in the UK. Passive integrated transponder-tags were attached to crayfish, allowing their location to be monitored relative to 16 antennae which were buried beneath the river bed. The activity of crayfish was related to water depth and temperature, which were continuously monitored within the instrumented reach. Crayfish were highly nocturnal, with less than 6% of movements recorded during daylight hours. Activity declined from September and was minimal in November when water temperature was low and flow depth was high. However, relations between environmental parameters and crayfish activity had poor explanatory power which may partly reflect biological processes not accounted for in this study. Water depth and temperature had a limiting relationship with crayfish activity, quantified using quantile regression. The results extend existing data on signal crayfish nocturnalism and demonstrate that, although signal crayfish can tolerate a range of flows, activity becomes limited as water temperature declines seasonally and when water depth remains high in autumn and winter months

Invaders in hot water: a simple decontamination method to prevent the accidental spread of aquatic invasive non-native species.

Watersports equipment can act as a vector for the introduction and spread of invasive non native species (INNS) in freshwater environments. To support advice given to recreational water users under the UK Government’s Check Clean Dry biosecurity campaign and ensure its effectiveness at killing a range of aquatic INNS, we conducted a survival experiment on seven INNS which pose a high risk to UK freshwaters. The efficacy of exposure to hot water (45 °C, 15 min) was tested as a method by which waters users could ‘clean’ their equipment and was compared to drying and a control group (no treatment). Hot water had caused 99 % mortality across all species 1 h after treatment and was more effective than drying at all time points (1 h: χ2 = 117.24, p < 0.001; 1 day χ2 = 95.68, p < 0.001; 8 days χ2 = 12.16, p < 0.001 and 16 days χ2 = 7.58, p < 0.001). Drying caused significantly higher mortality than the control (no action) from day 4 (χ2 = 8.49, p < 0.01) onwards. In the absence of hot water or drying, 6/7 of these species survived for 16 days, highlighting the importance of good biosecurity practice to reduce the risk of accidental spread. In an additional experiment the minimum lethal temperature and exposure time in hot water to cause 100 % mortality in American signal crayfish (Pacifastacus leniusculus), was determined to be 5 min at 40 °C. Hot water provides a simple, rapid and effective method to clean equipment. We recommend that it is advocated in future biosecurity awareness campaigns

Diversity of Tanaidacea (Crustacea: Peracarida) in the World's Oceans – How Far Have We Come?

Tanaidaceans are small peracarid crustaceans which occur in all marine habitats, over the full range of depths, and rarely into fresh waters. Yet they have no obligate dispersive phase in their life-cycle. Populations are thus inevitably isolated, and allopatric speciation and high regional diversity are inevitable; cosmopolitan distributions are considered to be unlikely or non-existent. Options for passive dispersion are discussed. Tanaidaceans appear to have first evolved in shallow waters, the region of greatest diversification of the Apseudomorpha and some tanaidomorph families, while in deeper waters the apseudomorphs have subsequently evolved two or three distinct phyletic lines. The Neotanaidomorpha has evolved separately and diversified globally in deep waters, and the Tanaidomorpha has undergone the greatest evolution, diversification and adaptation, to the point where some of the deep-water taxa are recolonizing shallow waters. Analysis of their geographic distribution shows some level of regional isolation, but suffers from inclusion of polyphyletic taxa and a general lack of data, particularly for deep waters. It is concluded that the diversity of the tanaidomorphs in deeper waters and in certain ocean regions remains to be discovered; that the smaller taxa are largely understudied; and that numerous cryptic species remain to be distinguished. Thus the number of species currently recognized is likely to be an order of magnitude too low, and globally the Tanaidacea potentially rival the Amphipoda and Isopoda in diversity