Indium joints for cryogenic gravitational wave detectors

A viable technique for the preparation of highly thermal conductive joints between sapphire components in gravitational wave detectors is presented. The mechanical loss of such a joint was determined to be as low as 2 × 10−3 at 20 K and 2 × 10−2 at 300 K. The thermal noise performance of a typical joint is compared to the requirements of the Japanese gravitational wave detector, KAGRA. It is shown that using such an indium joint in the suspension system allows it to operate with low thermal noise. Additionally, results on the maximum amount of heat which can be extracted via indium joints are presented. It is found that sapphire parts, joined by means of indium, are able to remove the residual heat load in the mirrors of KAGRA

High prevalence of bronchiectasis is linked to HTLV-1-associated inflammatory disease.

BACKGROUND: Human T-lymphotropic virus type 1 (HTLV-1), a retrovirus, is the causative agent of HTLV-1-associated myelopathy/tropical spastic paraparesis (HAM/TSP) and adult T-cell leukaemia/lymphoma (ATLL). The reported association with pulmonary disease such as bronchiectasis is less certain. METHODS: A retrospective case review of a HTLV-1 seropositive cohort attending a national referral centre. The cohort was categorised into HTLV-1 symptomatic patients (SPs) (ATLL, HAM/TSP, Strongyloidiasis and HTLV associated inflammatory disease (HAID)) and HTLV-1 asymptomatic carriers (ACs). The cohort was reviewed for diagnosis of bronchiectasis. RESULT: 34/246 ACs and 30/167 SPs had been investigated for respiratory symptoms by computer tomography (CT) with productive cough +/- recurrent chest infections the predominant indications. Bronchiectasis was diagnosed in one AC (1/246) and 13 SPs (2 HAID, 1 ATLL, 10 HAM/TSP) (13/167, RR 19.2 95 % CI 2.5-14.5, p = 0.004) with high resolution CT. In the multivariate analysis ethnicity (p = 0.02) and disease state (p < 0.001) were independent predictors for bronchiectasis. The relative risk of bronchiectasis in SPs was 19.2 (95 % CI 2.5-14.5, p = 0.004) and in HAM/TSP patients compared with all other categories 8.4 (95 % CI 2.7-26.1, p = 0.0002). Subjects not of African/Afro-Caribbean ethnicity had an increased prevalence of bronchiectasis (RR 3.45 95 % 1.2-9.7, p = 0.02). CONCLUSIONS: Bronchiectasis was common in the cohort (3.4 %). Risk factors were a prior diagnosis of HAM/TSP and ethnicity but not HTLV-1 viral load, age and gender. The spectrum of HTLV-associated disease should now include bronchiectasis and HTLV serology should be considered in patients with unexplained bronchiectasis

Understanding consumer demand for new transport technologies and services, and implications for the future of mobility

The transport sector is witnessing unprecedented levels of disruption. Privately owned cars that operate on internal combustion engines have been the dominant modes of passenger transport for much of the last century. However, recent advances in transport technologies and services, such as the development of autonomous vehicles, the emergence of shared mobility services, and the commercialization of alternative fuel vehicle technologies, promise to revolutionise how humans travel. The implications are profound: some have predicted the end of private car dependent Western societies, others have portended greater suburbanization than has ever been observed before. If transport systems are to fulfil current and future needs of different subpopulations, and satisfy short and long-term societal objectives, it is imperative that we comprehend the many factors that shape individual behaviour. This chapter introduces the technologies and services most likely to disrupt prevailing practices in the transport sector. We review past studies that have examined current and future demand for these new technologies and services, and their likely short and long-term impacts on extant mobility patterns. We conclude with a summary of what these new technologies and services might mean for the future of mobility.Comment: 15 pages, 0 figures, book chapte

Energy performance contracting (EPC): a suitable mechanism for achieving energy savings in housing cooperatives? Results from a Norwegian pilot project

The barriers to energy savings in institutions and private homes are well known and include people’s lack of interest, awareness, knowledge and human and financial capacity. Experiences made in several countries show that EPC—energy performance contracting—may be used for overcoming many of these barriers. A typical EPC project is delivered by an energy service company (ESCO) and the contract is accompanied with a guarantee for energy savings. EPC is increasingly taken in use in the professional market (firms and the public sector), but is less common in the residential sector market. It has been suggested that there are several barriers for using EPC in the domestic sector such as the uncertainty involved in estimating forthcoming reductions in private consumption. In this paper, we present the results from a pilot project on the use of EPC in a housing cooperative in Oslo. The project was initiated and observed by the researchers. The research followed a transdisciplinary methodology in that it was conducted by both researcher and practitioner (co-authors) in close collaboration with members of the housing cooperative and the ESCOs, who also contributed to the interpretation of results. We document the process in terms of why the Board decided to join the EPC pilot, the call for offers from ESCOs who guaranteed that purchased annual energy would be reduced by one third, the responses to and negotiations of the offer from the ESCO who became contracted in the initial phase and up to the moment when the General Assembly finally decided to not invest in the proposed energy saving measures. We find that the residents not only had limited interest in energy savings but also lacked confidence in the EPC process. This contributed to the outcome. We discuss the findings in relation to the barriers to using EPC among housing cooperatives. We highlight the need for more knowledge about the client side for understanding how barriers may be overcome. Three specific recommendations for how EPC may successfully be employed among housing cooperatives are suggested as follows: (i) include refurbishment and not only energy savings in the EPC, (ii) identify the residents’ needs in an early phase and (iii) communicate the EPC principle to the residents throughout the process

Strangelet search at RHIC

Two position sensitive Shower Maximum Detector (SMDs) for Zero-Degree Calorimeters (ZDCs) were installed by STAR before run 2004 at both upstream and downstream from the interaction point along the beam axis where particles with small rigidity are swept away by strong magnetic field. The ZDC-SMDs provides information about neutral energy deposition as a function of transverse position in ZDCs. We report the preliminary results of strangelet search from a triggered data-set sampling 100 million Au+Au collisions at top RHIC energy.Comment: Strange Quark Matter 2004 conference proceedin

Correlations in STAR: interferometry and event structure

STAR observes a complex picture of RHIC collisions where correlation effects of different origins -- initial state geometry, semi-hard scattering, hadronization, as well as final state interactions such as quantum intensity interference -- coexist. Presenting the measurements of flow, mini-jet deformation, modified hadronization, and the Hanbury Brown and Twiss effect, we trace the history of the system from the initial to the final state. The resulting picture is discussed in the context of identifying the relevant degrees of freedom and the likely equilibration mechanism.Comment: 8 pages, 6 figures, plenary talk at the 5th International Conference on Physics and Astrophysics of Quark Gluon Plasma, to appear in Journal of Physics G (http://www.iop.org

Design of Experiments for Screening

The aim of this paper is to review methods of designing screening experiments, ranging from designs originally developed for physical experiments to those especially tailored to experiments on numerical models. The strengths and weaknesses of the various designs for screening variables in numerical models are discussed. First, classes of factorial designs for experiments to estimate main effects and interactions through a linear statistical model are described, specifically regular and nonregular fractional factorial designs, supersaturated designs and systematic fractional replicate designs. Generic issues of aliasing, bias and cancellation of factorial effects are discussed. Second, group screening experiments are considered including factorial group screening and sequential bifurcation. Third, random sampling plans are discussed including Latin hypercube sampling and sampling plans to estimate elementary effects. Fourth, a variety of modelling methods commonly employed with screening designs are briefly described. Finally, a novel study demonstrates six screening methods on two frequently-used exemplars, and their performances are compared

Examining the spatiotemporal disruption to gaze when using a myoelectric prosthetic hand

The aim of this study was to provide a detailed account of the spatial and temporal disruptions to eye-hand coordination when using a prosthetic hand during a sequential fine motor skill. Twenty-one abled-bodied participants performed 15 trials of the ‘picking up coins’ task derived from the Southampton Hand Assessment Procedure (SHAP) with their anatomic hand and with a prosthesis simulator while wearing eye-tracking equipment. Gaze behaviour results revealed that when using the prosthesis, performance detriments were accompanied by significantly greater hand-focused gaze and a significantly longer time to disengage gaze from manipulations to plan upcoming movements. Our findings highlight key metrics that distinguish disruptions to eye-hand coordination that might have implications for the training of prosthesis use