90 research outputs found

    The non-destructive study of museums objects by means of neutrons imaging methods and results of investigations

    Get PDF
    Based on experience from many kinds of investigations with neutron imaging methods (radiography, tomography, time-dependent studies) and in comparison to conventional X-ray methods, the authors discuss the potential of future improved studies for cultural-heritage purposes. Whereas the focus of the paper is on the imaging aspect, other established techniques as neutron activation analysis (NAA), prompt gamma activation analysis (PGAA), neutron-induced autoradiography and neutron scattering are mentioned too. Although a great potential for studies similar to those described in the paper exists, a considerable effort is needed to define the best-suited methods for the dedicated cultural historical request. A real barrier between the experts at large research facilities (as, e.g., neutron sources are) and the partners from the museums side has to be overcome in order to solve the problems. A joint European approach will help in this respect

    Within-ring movement of free water in dehydrating Norway spruce sapwood visualized by neutron radiography

    Get PDF
    This study is a first approach to visualize moisture distribution and movement between annual rings during sapwood drying by neutron imaging (NI). While Norway spruce [Picea abies (L.) Karst.] sapwood beams were allowed to dehydrate on a balance at ambient conditions, NI was performed in 1-10 min time steps. From NI raw files, radial dimensional changes were calculated during dehydration and transmission profiles were drawn for different relative moisture content (MC) steps from full saturation until equilibrium moisture content. The NI technique proved to be a useful tool to visualize the movement of free water within, and between, annual rings. Removal of free water in the middle part of the wood beam did not proceed continuously from the surface to the central part, but was strongly influenced by wood anatomy. Water is removed from earlywood during early stages of dehydration and later, at higher moisture loss (<50% MC), from the main latewood parts. It is therefore concluded that the radial dimensional changes measured at moderate moisture loss are not only caused by cell wall shrinkage of the outer wood parts located beneath the wood surface, but a result of elastic deformation of earlywood tracheids under the influence of negative hydrostatic pressure

    Neutronenradiographische Untersuchungen der kleinräumig heterogenen Wasserbewegung in kohlehaltigen Kippböden

    Get PDF
    Böden, die sich aus Abraum des Braunkohletagebaus entwickeln, weisen u.a. durch Sedimentmischungen eine starke Heterogenität auf. Die Wasserbewegung in diesen Kippböden ist komplex; sie scheint vornehmlich entlang von präferentiellen Fließbahnen statt zu finden. Um diese Fließbahnen experimentell zu erfassen und zu quantifizieren wurden Fließexperimente an ungestört entnommen Bodenproben durchgeführt, und mit Hilfe der Neutronen-radiographie (PSI Villingen) visualisiert. Exemplarisch werden Infiltrationsvorgänge an vier 2D-Radiographiesequenzen bei zwei verschiedenen Wasserspannungen gezeigt. Des Weiteren wurde ein Multistep-In-Outflow-Experiment durchgeführt um 3D-Wasserverteilungen während der stationären Phasen zu visualisieren, installierte Tensiometer zeichneten den Verlauf der Wasserspannungen während der instationären Phasen auf. Die Ergebnisse zeigen, dass unter den Versuchsbedingungen nahe Wassersätti-gung die Wasserbewegung vornehmlich in der Sand-Kohlestaub-Matrix stattfindet. Die porösen kohligen Fragmente werden dabei teilweise umflossen

    Water flow between soil aggregates

    Get PDF
    Aggregated soils are structured systems susceptible to non-uniform flow. The hydraulic properties depend on the aggregate fabric and the way the aggregates are assembled. We examined the hydraulic behavior of an aggregate packing. We focused on conditions when water mostly flows through the aggregates, leaving the inter-aggregate pore space air-filled. The aggregates were packed in 3mm thick slabs forming a quasi two-dimensional bedding. The larger aggregates were wetted with water and embedded in smaller aggregates equilibrated at a lower water content. The water exchange between wet and drier aggregates was monitored by neutron radiography. The three-dimensional arrangement of the aggregates was reconstructed by neutron tomography. The water flow turned out to be controlled by the contacts between aggregates, bottle-necks that slow down the flow. The bottle-neck effect is due to the narrow flow cross section of the contacts. The water exchange was simulated by considering the contact area between aggregates as the key parameter. In order to match the observed water flow, the contact area must be reduced by one to two orders of magnitude relative to that obtained from image analysis. The narrowness of the contacts is due to air-filled voids within the contact

    Water flow between soil aggregates

    Get PDF
    Aggregated soils are structured systems susceptible to non-uniform flow. The hydraulic properties depend on the aggregate fabric and the way the aggregates are assembled. We examined the hydraulic behavior of an aggregate packing. We focused on conditions when water mostly flows through the aggregates, leaving the inter-aggregate pore space air-filled. The aggregates were packed in 3mm thick slabs forming a quasi two-dimensional bedding. The larger aggregates were wetted with water and embedded in smaller aggregates equilibrated at a lower water content. The water exchange between wet and drier aggregates was monitored by neutron radiography. The three-dimensional arrangement of the aggregates was reconstructed by neutron tomography. The water flow turned out to be controlled by the contacts between aggregates, bottle-necks that slow down the flow. The bottle-neck effect is due to the narrow flow cross section of the contacts. The water exchange was simulated by considering the contact area between aggregates as the key parameter. In order to match the observed water flow, the contact area must be reduced by one to two orders of magnitude relative to that obtained from image analysis. The narrowness of the contacts is due to air-filled voids within the contact

    New insights into early bronze age damascene technique north of the alps

    Get PDF
    Damascening, defined in this context as the inlay of one metal into a different metal base, is a rare decorative technique in the Early Bronze Age, known only from seven bronze artefacts found north of the Alps. This paper reports on the first thorough scientific examination of one such find, the axe from Thun-Renzenbühl grave no. 1. This interdisciplinary project involving several institutions in Germany and Switzerland investigated the axe by means of neutron radiographic imaging and X-ray microprobe methods, supported by microscopic examination. The result is an attempt to reconstruct the fabrication and decoration process and to reconsider the enigmatic question of the origins of the damascene technique north of the Alp

    Simulation-Based Computation of Information Rates for Channels With Memory

    Full text link

    Belief Propagation and Loop Series on Planar Graphs

    Full text link
    We discuss a generic model of Bayesian inference with binary variables defined on edges of a planar graph. The Loop Calculus approach of [1, 2] is used to evaluate the resulting series expansion for the partition function. We show that, for planar graphs, truncating the series at single-connected loops reduces, via a map reminiscent of the Fisher transformation [3], to evaluating the partition function of the dimer matching model on an auxiliary planar graph. Thus, the truncated series can be easily re-summed, using the Pfaffian formula of Kasteleyn [4]. This allows to identify a big class of computationally tractable planar models reducible to a dimer model via the Belief Propagation (gauge) transformation. The Pfaffian representation can also be extended to the full Loop Series, in which case the expansion becomes a sum of Pfaffian contributions, each associated with dimer matchings on an extension to a subgraph of the original graph. Algorithmic consequences of the Pfaffian representation, as well as relations to quantum and non-planar models, are discussed.Comment: Accepted for publication in Journal of Statistical Mechanics: theory and experimen

    Multicentre multi-device hybrid imaging study of coronary artery disease: results from the EValuation of INtegrated Cardiac Imaging for the Detection and Characterization of Ischaemic Heart Disease (EVINCI) hybrid imaging population

    Get PDF
    AIMS: Hybrid imaging provides a non-invasive assessment of coronary anatomy and myocardial perfusion. We sought to evaluate the added clinical value of hybrid imaging in a multi-centre multi-vendor setting. METHODS AND RESULTS: Fourteen centres enrolled 252 patients with stable angina and intermediate (20-90%) pre-test likelihood of coronary artery disease (CAD) who underwent myocardial perfusion scintigraphy (MPS), CT coronary angiography (CTCA), and quantitative coronary angiography (QCA) with fractional flow reserve (FFR). Hybrid MPS/CTCA images were obtained by 3D image fusion. Blinded core-lab analyses were performed for CTCA, MPS, QCA and hybrid datasets. Hemodynamically significant CAD was ruled-in non-invasively in the presence of a matched finding (myocardial perfusion defect co-localized with stenosed coronary artery) and ruled-out with normal findings (both CTCA and MPS normal). Overall prevalence of significant CAD on QCA (&gt;70% stenosis or 30-70% with FFR 640.80) was 37%. Of 1004 pathological myocardial segments on MPS, 246 (25%) were reclassified from their standard coronary distribution to another territory by hybrid imaging. In this respect, in 45/252 (18%) patients, hybrid imaging reassigned an entire perfusion defect to another coronary territory, changing the final diagnosis in 42% of the cases. Hybrid imaging allowed non-invasive CAD rule-out in 41%, and rule-in in 24% of patients, with a negative and positive predictive value of 88% and 87%, respectively. CONCLUSION: In patients at intermediate risk of CAD, hybrid imaging allows non-invasive co-localization of myocardial perfusion defects and subtending coronary arteries, impacting clinical decision-making in almost one every five subjects
    corecore