9,670 research outputs found
Memristive switching of MgO based magnetic tunnel junctions
Here we demonstrate that both, tunnel magneto resistance (TMR) and resistive
switching (RS), can be observed simultaneously in nano-scale magnetic tunnel
junctions. The devices show bipolar RS of 6 % and TMR ratios of about 100 %.
For each magnetic state, multiple resistive sates are created depending on the
bias history which provides a method for multi-bit data storage and logic. The
electronic transport measurements are discussed in the framework of a
memristive system. Differently prepared MgO barriers are compared to gain
insight into the switching mechanism
Anomalous Hall effect in the Co-based Heusler compounds CoFeSi and CoFeAl
The anomalous Hall effect (AHE) in the Heusler compounds CoFeSi and
CoFeAl is studied in dependence of the annealing temperature to achieve a
general comprehension of its origin. We have demonstrated that the crystal
quality affected by annealing processes is a significant control parameter to
tune the electrical resistivity as well as the anomalous Hall
resistivity . Analyzing the scaling behavior of in
terms of points to a temperature-dependent skew scattering as the
dominant mechanism in both Heusler compounds
Magnetic properties of antiferromagnetically coupled CoFeB/Ru/CoFeB
This work reports on the thermal stability of two amorphous CoFeB layers
coupled antiferromagnetically via a thin Ru interlayer. The saturation field of
the artificial ferrimagnet which is determined by the coupling, J, is almost
independent on the annealing temperature up to more than 300 degree C. An
annealing at more than 325 degree C significantly increases the coercivity, Hc,
indicating the onset of crystallization.Comment: 4 pages, 3 figure
Low frequency noise due to magnetic inhomogeneities in submicron FeCoB/MgO/FeCoB magnetic tunnel junctions
We report on room temperature low frequency noise due to magnetic
inhomogeneities/domain walls (MI/DWs) in elliptic submicron FeCoB/MgO/FeCoB
magnetic tunnel junctions with an area between 0.0245 and 0.0675{\mu}m2. In the
smaller area junctions we found an unexpected random telegraph noise (RTN1),
deeply in the parallel state, possibly due to stray field induced MI/DWs in the
hard layer. The second noise source (RTN2) is observed in the antiparallel
state for the largest junctions. Strong asymmetry of RTN2 and of related
resistance steps with current indicate spin torque acting on the MI/DWs in the
soft layer at current densities below 5x10^5 A/cm2.Comment: 12 pages, 4 figure
Fermionic functional renormalization group for first-order phase transitions: a mean-field model
First-order phase transitions in many-fermion systems are not detected in the
susceptibility analysis of common renormalization-group (RG) approaches. Here
we introduce a counterterm technique within the functional
renormalization-group (fRG) formalism which allows access to all stable and
metastable configurations. It becomes possible to study symmetry-broken states
which occur through first-order transitions as well as hysteresis phenomena.
For continuous transitions, the standard results are reproduced. As an example,
we study discrete-symmetry breaking in a mean-field model for a commensurate
charge-density wave. An additional benefit of the approach is that away from
the critical temperature for the breaking of discrete symmetries large
interactions can be avoided at all RG scales.Comment: 17 pages, 8 figures. v2 corrects typos, adds references and a
discussion of the literatur
Resonance magneto-resistance in double barrier structure with spin-valve
The conductance and tunnel magneto-resistance (TMR) of the double barrier
magnetic tunnel junction with spin-valve sandwich (F/P/F) inserted between two
insulating barrier, are theoretically investigated. It is shown, that resonant
tunnelling, due to the quantum well states of the electron confined between two
barriers, sharply depends on the mutual orientation of the magnetizations of
ferromagnetic layers F. The calculated optimistic value of TMR exceeds 2000% .Comment: 3 pages, 4 figure
Influence of chemical and magnetic interface properties of Co-Fe-B / MgO / Co-Fe-B tunnel junctions on the annealing temperature dependence of the magnetoresistance
The knowledge of chemical and magnetic conditions at the Co40Fe40B20 / MgO
interface is important to interpret the strong annealing temperature dependence
of tunnel magnetoresistance of Co-Fe-B / MgO / Co-Fe-B magnetic tunnel
junctions, which increases with annealing temperature from 20% after annealing
at 200C up to a maximum value of 112% after annealing at 350C. While the well
defined nearest neighbor ordering indicating crystallinity of the MgO barrier
does not change by the annealing, a small amount of interfacial Fe-O at the
lower Co-Fe-B / MgO interface is found in the as grown samples, which is
completely reduced after annealing at 275C. This is accompanied by a
simultaneous increase of the Fe magnetic moment and the tunnel
magnetoresistance. However, the TMR of the MgO based junctions increases
further for higher annealing temperature which can not be caused by Fe-O
reduction. The occurrence of an x-ray absorption near-edge structure above the
Fe and Co L-edges after annealing at 350C indicates the recrystallization of
the Co-Fe-B electrode. This is prerequisite for coherent tunneling and has been
suggested to be responsible for the further increase of the TMR above 275C.
Simultaneously, the B concentration in the Co-Fe-B decreases with increasing
annealing temperature, at least some of the B diffuses towards or into the MgO
barrier and forms a B2O3 oxide
Antiferromagnetically coupled CoFeB/Ru/CoFeB trilayers
This work reports on the magnetic interlayer coupling between two amorphous
CoFeB layers, separated by a thin Ru spacer. We observe an antiferromagnetic
coupling which oscillates as a function of the Ru thickness x, with the second
antiferromagnetic maximum found for x=1.0 to 1.1 nm. We have studied the
switching of a CoFeB/Ru/CoFeB trilayer for a Ru thickness of 1.1 nm and found
that the coercivity depends on the net magnetic moment, i.e. the thickness
difference of the two CoFeB layers. The antiferromagnetic coupling is almost
independent on the annealing temperatures up to 300 degree C while an annealing
at 350 degree C reduces the coupling and increases the coercivity, indicating
the onset of crystallization. Used as a soft electrode in a magnetic tunnel
junction, a high tunneling magnetoresistance of about 50%, a well defined
plateau and a rectangular switching behavior is achieved.Comment: 3 pages, 3 figure
Slice Energy in Higher Order Gravity Theories and Conformal Transformations
We study the generic transport of slice energy between the scalar field
generated by the conformal transformation of higher-order gravity theories and
the matter component. We give precise relations for this exchange in the cases
of dust and perfect fluids. We show that, unless we are in a stationary
spacetime where slice energy is always conserved, in non-stationary situations
contributions to the total slice energy depend on whether or not test matter
follows geodesics in both frame representations of the dynamics, that is on
whether or not the two conformally related frames are physically
indistinguishable.Comment: 18 pages, references added, remark added in last Section related to
the choice of physical frame, various other improvements, final version to
appear in Gravitation and Cosmolog
- …