Bonded Invar Clip Removal Using Foil Heaters

A new process uses local heating and temperature monitoring to soften the adhesive under Invar clips enough that they can be removed without damaging the composite underneath or other nearby bonds. Two 1x1 in. (approx.2.5x2.5 cm), 10-W/sq in. (approx.1.6-W/sq cm), 80-ohm resistive foil Kapton foil heaters, with pressure-sensitive acrylic adhesive backing, are wired in parallel to a 50-V, 1-A limited power supply. At 1 A, 40 W are applied to the heater pair. The temperature is monitored in the clip radius and inside the tube, using a dual thermocouple readout. Several layers of aluminum foil are used to speed the heat up, allowing clips to be removed in less than five minutes. The very local heating via the foil heaters allows good access for clip removal and protects all underlying and adjacent materials

Implications of using 2 m versus 30 m spatial resolution data for suburban residential land change modeling

This study assesses the advantages and disadvantages of using 2 m spatial resolution data versus 30 m resolution data for a simulation model of land-use and land-cover change (LUCC). The model projects LUCC from 2005 to 2055 in the town of Lynnfield, Massachusetts, USA. This article describes four scenario storylines and then projects land-use and land-cover under each of the four scenarios with 2 m data and again with 30 m data. The disagreement between the 2 m output and its corresponding 30 m output ranges between 5.7% and 11.0% of the town. The disagreement due to allocation over small distances is greater than the disagreement due to the quantity of new residential growth. The projected quantities of new residential land-use in 2055 differ between the two resolutions by 1% of the town, whereas the visual differences in the spatial allocations are distinct and substantial. The results for this case study show that 30 m resolution data provides several practical and theoretical advantages over 2 m resolution data, due mainly to the fact that the 30 m resolution data match more closely the size of the patches of change

Magnetization of small lead particles

The magnetization of an ensemble of isolated lead grains of sizes ranging from below 6 nm to 1000 nm is measured. A sharp disappearance of Meissner effect with lowering of the grain size is observed for the smaller grains. This is a direct observation by magnetization measurement of the occurrence of a critical particle size for superconductivity, which is consistent with Anderson's criterion.Comment: 7 pages, 5 figures, Submitted to PR

Ultrafast relaxation dynamics of optically excited electrons in Ni3-

Photon-induced ultrafast energy dissipation in small isolated Ni-3(-) has been studied by two-color pump-probe photoelectron spectroscopy. The time-resolved photoelectron spectra clearly trace the path from a single-electron excitation to a thermalized cluster via both inelastic electron-electron scattering and electron-vibrational coupling. The relatively short electron-electron-scattering time of 215 fs results from the narrow energy spread of the partially filled d levels in this transition-metal cluster. The relaxation dynamics is discussed in view of the cluster size and in comparison to the totally different relaxation behavior of s/p-metal clusters

Inertial currents in isotropic plasma

The magnetospheric convection electric field contributes to Birkeland currents. The effects of the field are to polarize the plasma by displacing the bounce paths of the ions from those of electrons, to redistribute the pressure so that it is not constant along magnetic field lines, and to enhance the pressure gradient by the gradient of the bulk speed. Changes in the polarization charge during the convection of the plasma are neutralized by electrons in the form of field-aligned currents that close through the ionosphere. The pressure drives field-aligned currents through its gradient in the same manner as in quasi-static plasmas, but with modifications that are important if the bulk speed is of the order of the ion thermal speed; the variations in the pressure along field lines are maintained by a weak parallel potential drop. These effects are described in terms of the field-aligned currents in steady state, isotropic, MHD plasma. Solutions are developed by taking the MHD limit ot two-fluid solutions and illustrated in the special case of Maxwellian plasma for which the temperature is constant along magnetic field lines. The expression for the Birkeland current density is a generalization of Vasyliunas' expression for the field-aligned current density in quasi-static plasma and provides a unifying expression when both pressure gradients and ion inertia operate simultaneously as sources of field-aligned currents. It contains a full account of different aspects of the ion flow (parallel and perpendicular velocity and vorticity) that contribute to the currents. Contributions of ion inertia to field-aligned currents will occur in regions of strong velocity shear, electric field reversal, or large gradients in the parallel velocity or number density, and may be important in the low-latitude boundary layer, plasma sheet boundary layer, and the inner edge region of the plasma sheet

Laser pump X ray probe experiments with electrons ejected from a Cu 111 target space charge acceleration

A comprehensive investigation of the emission characteristics for electrons induced by X rays of a few hundred eV at grazing incidence angles on an atomically clean Cu 111 sample during laser excitation is presented. Electron energy spectra due to intense infrared laser irradiation are investigated at the BESSY II slicing facility. Furthermore, the influence of the corresponding high degree of target excitation high peak current of photoemission on the properties of Auger and photoelectrons liberated by a probe X ray beam is investigated in time resolved pump and probe measurements. Strong electron energy shifts have been found and assigned to space charge acceleration. The variation of the shift with laser power and electron energy is investigated and discussed on the basis of experimental as well as new theoretical result

Creating spatially-explicit lawn maps without classifying remotely-sensed imagery: The case of suburban Boston, Massachusetts, USA

Residential lawns are a dominant and growing feature of US residential landscapes, and the resource-intensive management of this landscape feature presents major potential risks to both humans and the environment. In recent years, scientists and policymakers have been increasingly calling for large-extent measures of lawns and other similar landscape features. Unfortunately, the production of such datasets using traditional, remotely sensed measurement approaches can be prohibitively expensive and time consuming. This study uses two statistical prediction methods to extrapolate the quantity and spatial distribution of residential lawns from a sample of mapped lawns in a large study area in suburban Boston, Massachusetts. The goal is to find an inexpensive, broad-coverage dataset that will provide useable estimates of landscape features in places where we do not have direct measurements of those landscape features. The first estimation method uses OLS regression in conjunction with the sample of mapped lawns and freely available US Census data representing theoretically informed social driver variables. The second, simpler, and less computationally intensive estimation method allocates the mean of the sample of mapped lawns uniformly across the study area. Both estimation methods are performed 1000 times in a Monte Carlo framework where the sample is drawn randomly each realization, to assess the sensitivity of the prediction results to the selection of CBGs in each simple random sample. The outputs of each estimation method are then compared to a reference map where the quantity and spatial allocation of lawns is known for each spatial unit of analysis. Results indicate that the OLS prediction method specified with the independent social driver variables performs better than a uniform prediction method when both are compared to the full-study area reference map

Element resolved ultrafast demagnetization rates in ferrimagnetic CoDy

Femtosecond laser induced ultrafast magnetization dynamics have been studied in multisublattice CoxDy1-x alloys. By performing element and time-resolved X-ray spectroscopy, we distinguish the ultrafast quenching of Co3d and Dy4f magnetic order when the initial temperatures are below (T=150K) or above (T=270K) the temperature of magnetic compensation (Tcomp). In accordance with former element-resolved investigations and theoretical calculations, we observe different dynamics for Co3d and Dy4f spins. In addition we observe that, for a given laser fluence, the demagnetization amplitudes and demagnetization times are not affected by the existence of a temperature of magnetic compensation. However, our experiment reveals a twofold increase of the ultrafast demagnetization rates for the Dy sublattice at low temperature. In parallel, we measure a constant demagnetization rate of the Co3d sublattice above and below Tcomp. This intriguing difference between the Dy4f and Co3d sublattices calls for further theoretical and experimental investigations.Comment: 6 Figure, 2 Table