Scalable Approach for Power Droop Reduction During Scan-Based Logic BIST

The generation of significant power droop (PD) during at-speed test performed by Logic Built-In Self Test (LBIST) is a serious concern for modern ICs. In fact, the PD originated during test may delay signal transitions of the circuit under test (CUT): an effect that may be erroneously recognized as delay faults, with consequent erroneous generation of test fails and increase in yield loss. In this paper, we propose a novel scalable approach to reduce the PD during at-speed test of sequential circuits with scan-based LBIST using the launch-on-capture scheme. This is achieved by reducing the activity factor of the CUT, by proper modification of the test vectors generated by the LBIST of sequential ICs. Our scalable solution allows us to reduce PD to a value similar to that occurring during the CUT in field operation, without increasing the number of test vectors required to achieve a target fault coverage (FC). We present a hardware implementation of our approach that requires limited area overhead. Finally, we show that, compared with recent alternative solutions providing a similar PD reduction, our approach enables a significant reduction of the number of test vectors (by more than 50%), thus the test time, to achieve a target FC

Size-segregated aerosol chemical composition at a boreal site in southern Finland, during the QUEST project

International audienceSize-segregated aerosol samples were collected during the QUEST field campaign at Hyytiälä, a boreal forest site in Southern Finland, during spring 2003. Aerosol samples were selectively collected during both particle formation events and periods in which no particle formation occurred. A comprehensive characterisation of the aerosol chemical properties (water-soluble inorganic and organic fraction) and an analysis of the relevant meteorological parameters revealed how aerosol chemistry and meteorology combine to determine a favorable "environment" for new particle formation. The results indicated that all events, typically favored during northerly air mass advection, were background aerosols (total mass concentrations range between 1.97 and 4.31 µg m-3), with an increasingly pronounced marine character as the northerly air flow arrived progressively from the west and, in contrast, with a moderate SO2-pollution influence as the air arrived from more easterly directions. Conversely, the non-event aerosol, transported from the south, exhibited the chemical features of European continental sites, with a marked increase in the concentrations of all major anthropogenic aerosol constituents. The higher non-event mass concentration (total mass concentrations range between 6.88 and 16.30 µg m-3) and, thus, a larger surface area, tended to suppress new particle formation, more efficiently depleting potential gaseous precursors for nucleation. The analysis of water-soluble organic compounds showed that clean nucleation episodes were dominated by aliphatic biogenic species, while non-events were characterised by a large abundance of anthropogenic oxygenated species. Interestingly, a significant content of ?-pinene photo-oxidation products was observed in the events aerosol, accounting for, on average, 72% of their WSOC; while only moderate amounts of these species were found in the non-event aerosol. If the organic vapors condensing onto accumulation mode particles are responsible also for the growth of newly formed thermodynamically stable clusters, our finding allows one to postulate that, at the site, ?-pinene photo-oxidation products (and probably also photo-oxidation products from other terpenes) are the most likely species to contribute to the growth of nanometer-sized particles

Chemical mass balance of size-segregated atmospheric aerosol in an urban area of the Po Valley, Italy

International audienceA complete size segregated chemical characterisation was carried out for aerosol samples collected in the urban area of Bologna over a period of one year, using five-stage low pressure Berner impactors. An original dual-substrate technique was adopted to obtain samples suitable for a complete chemical characterisation. Total mass, inorganic, and organic components were analysed as a function of size, and a detailed characterisation of the water soluble organic compounds was also performed by means of a previously developed methodology, based on HPLC separation of organic compounds according to their acid character and functional group analysis by Proton Nuclear Magnetic Resonance. Chemical mass closure of the collected samples was reached to within a few percent on average in the submicron aerosol range, while a higher unknown fraction in the coarse aerosol range was attributed to soil-derived species not analysed in this experiment. Comparison of the functional group analysis results with model results simulating water soluble organic compound production by gas-to-particle conversion of anthropogenic VOCs showed that this pathway provides a minor contribution to the organic composition of the aerosol samples in the urban area of Bologna

Functional group analysis by H NMR/chemical derivatization for the characterization of organic aerosol from the SMOCC field campaign

Water soluble organic compounds (WSOC) in aerosol samples collected in the Amazon Basin in a period encompassing the middle/late dry season and the beginning of the wet season, were investigated by H NMR spectroscopy. HiVol filter samples (PM2.5 and PM>2.5) and size-segregated samples from multistage impactor were subjected to H NMR characterization. The H NMR methodology, recently developed for the analysis of organic aerosol samples, has been improved by exploiting chemical methylation of carboxylic groups with diazomethane, which allows the direct determination of the carboxylic acid content of WSOC. The content of carboxylic carbons for the different periods and sizes ranged from 12% to 20% of total measured carbon depending on the season and aerosol size, with higher contents for the fine particles in the transition and wet periods with respect to the dry period. A comprehensive picture is presented of WSOC functional groups in aerosol samples representative of the biomass burning period, as well as of transition and semi-clean atmospheric conditions. A difference in composition between fine (PM2.5) and coarse (PM>2.5) size fractions emerged from the NMR data, the former showing higher alkylic content, the latter being largely dominated by R-O-H (or R-O-R') functional groups. Very small particles (<0.14 &mu;m), however, present higher alkyl-chain content and less oxygenated carbons than larger fine particles (0.42&ndash;1.2 &mu;m). More limited variations were found between the average compositions in the different periods of the campaign

Mass closure on the chemical species in size-segregated atmospheric aerosol collected in an urban area of the Po Valley, Italy

International audienceA complete size segregated chemical characterisation was carried out for aerosol samples collected in the urban area of Bologna over a period of one year, using five-stage low pressure Berner impactors. An original dual-substrate technique was adopted to obtain samples suitable for a complete chemical characterisation. Total mass, inorganic, and organic components were analysed as a function of size, and a detailed characterisation of the water soluble organic compounds was also performed by means of a previously developed methodology, based on HPLC separation of organic compounds according to their acid character and functional group analysis by Proton Nuclear Magnetic Resonance. Chemical mass closure of the collected samples was reached to within a few percent on average in the submicron aerosol range, while a higher unknown fraction in the coarse aerosol range was attributed to soil-derived species not analysed in this experiment. Comparison of the functional group analysis results with model results simulating water soluble organic compound production by gas-to-particle conversion of anthropogenic VOCs showed that this pathway provides a minor contribution to the organic composition of the aerosol samples in the urban area of Bologna

Size-segregated aerosol mass closure and chemical composition in Monte Cimone (I) during MINATROC

International audiencePhysical and chemical characterizations of the atmospheric aerosol were carried out at Mt. Cimone (Italy) during the 4 June-4 July 2000 period. Particle size distributions in the size range 6nm-10µm were measured with a differential mobility analyzer (DMA) and an optical particle counter (OPC). Size-segregated aerosol was sampled using a 6-stage low pressure impactor. Aerosol samples were submitted to gravimetric and chemical analyses. Ionic, carbonaceous and refractory components of the aerosol were quantified. We compared the sub- and superµm aerosol mass concentrations determined by gravimetric measurements (mGM), chemical analyses (mmCA), and by converting particle size distribution to aerosol mass concentrations (mmSD). Mean random uncertainties associated with the determination of mmGM, mmCA, and mmSD were assessed. The three estimates of the sub-µm aerosol mass concentration agreed, which shows that within experimental uncertainty, the sub-µm aerosol was composed of the quantified components. The three estimates of the super-µm aerosol mass concentration did not agree, which indicates that random uncertainties and/or possible systematic errors in aerosol sampling, sizing or analyses were not adequately accounted for. Aerosol chemical composition in air masses from different origins showed differences, which were significant in regard to experimental uncertainties. During the Saharan dust advection period, coarse dust and fine anthropogenic particles were externally mixed. No anthropogenic sulfate could be found in the super-µm dust particles. In contrast, nitrate was shifted towards the aerosol super-µm fraction in presence of desert dust

On the representativeness of coastal aerosol studies to open ocean studies: Mace Head – a case study

A unique opportunity arose during the MAP project to compare open ocean aerosol measurements with those undertaken at the Mace Head Global Atmosphere Watch Station, a station used for decades for aerosol process research and long-term monitoring. The objective of the present study is to demonstrate that the key aerosol features and processes observed at Mace Head are characteristic of the open ocean, while acknowledging and allowing for spatial and temporal gradients. Measurements were conducted for a 5-week period at Mace Head and offshore, on the Research Vessel Celtic Explorer, in generally similar marine air masses, albeit not in connected-flow scenarios. The results of the study indicate, in terms of aerosol number size distribution, higher nucleation mode particle concentrations at Mace Head than offshore, pointing to a strong coastal source of new particles that is not representative of the open ocean. The Aitken mode exhibited a large degree of similarity, with no systematic differences between Mace Head and the open ocean, while the accumulation mode showed averagely 35% higher concentrations at Mace Head. The higher accumulation mode concentration can be attributed equally to cloud processing and to a coastal enhancement in concentration. Chemical analysis showed similar or even higher offshore concentrations for dominant species, such as nss-SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;-2&lt;/sup&gt;, WSOC, WIOC and MSA. Sea salt concentration differences determined a 40% higher supermicron mass at Mace Head, although this difference can be attributed to a higher wind speed at Mace Head during the comparison period. Moreover, the relative chemical composition as a function of size illustrated remarkable similarity. While differences to varying degrees were observed between offshore and coastal measurements, no convincing evidence was found of local coastal effects, apart from nucleation mode aerosol, thus confirming the integrity of previously reported marine aerosol characterisation studies at Mace Head

In situ physical and chemical characterisation of the Eyjafjallajökull aerosol plume in the free troposphere over Italy

Abstract. Continuous measurements of physical and chemical properties at the Mt. Cimone (Italy) GAW-WMO (Global Atmosphere Watch, World Meteorological Organization) Global Station (2165 m a.s.l.) have allowed the detection of the volcanic aerosol plume resulting from the Eyjafjallajökull (Iceland) eruption of spring 2010. The event affected the Mt. Cimone site after a transport over a distance of more than 3000 km. Two main transport episodes were detected during the eruption period, showing a volcanic fingerprint discernible against the free tropospheric background conditions typical of the site, the first from April 19 to 21 and the second from 18 to 20 May 2010. This paper reports the modification of aerosol characteristics observed during the two episodes, both characterised by an abrupt increase in fine and, especially, coarse mode particle number. Analysis of major, minor and trace elements by different analytical techniques (ionic chromatography, particle induced X-ray emission–particle induced gamma-ray emission (PIXE–PIGE) and inductively coupled plasma mass spectrometry (ICP-MS)) were performed on aerosols collected by ground-level discrete sampling. The resulting database allows the characterisation of aerosol chemical composition during the volcanic plume transport and in background conditions. During the passage of the volcanic plume, the fine fraction was dominated by sulphates, denoting the secondary origin of this mode, mainly resulting from in-plume oxidation of volcanic SO2. By contrast, the coarse fraction was characterised by increased concentration of numerous elements of crustal origin, such as Fe, Ti, Mn, Ca, Na, and Mg, which enter the composition of silicate minerals. Data analysis of selected elements (Ti, Al, Fe, Mn) allowed the estimation of the volcanic plume's contribution to total PM10, resulting in a local enhancement of up to 9.5 μg m−3, i.e. 40% of total PM10 on 18 May, which was the most intense of the two episodes. These results appear significant, especially in light of the huge distance of Mt. Cimone from the source, confirming the widespread diffusion of the Eyjafjallajökull ashes over Europe