UV radiation promotes flavonoid biosynthesis, while negatively affecting the biosynthesis and de-epoxidation of xanthophylls: consequence for photoprotection?

There is evidence that UV radiation may detrimentally affect the biosynthesis of carotenoids, particularly de-epoxided xanthophylls, while strongly promoting phenylpropanoid, particularly flavonoid biosynthesis in a range of taxa. Here we tested the hypothesis that mesophyll flavonoids might protect chloroplasts from UV-induced photo-oxidative damage, by partially compensating for the UV-induced depression of xanthophyll biosynthesis. To test this hypothesis we grew two members of the Oleaceae family, Ligustrum vulgare L. and Phillyrea latifolia L., under either partial shading or fully exposed to sunlight, in the presence or in the absence of UV radiation. The examined species, which display very similar flavonoid composition, largely differ in their ability to limit the transmission of UV and visible light through the leaf and, hence, in the accumulation of flavonoids in mesophyll cells. We conducted measurements of photosynthesis, chlorophyll a fluorescence kinetics, the concentrations of individual carotenoids and phenylpropanoids at the level of whole-leaf, as well as the content of epidermal flavonoids. We also performed multispectral fluorescence micro-imaging to unveil the intra-cellular distribution of flavonoids in mesophyll cells. UV radiation decreased the concentration of carotenoids, particularly of xanthophylls, while greatly promoting the accumulation of flavonoids in palisade parenchyma cells. These effects were much greater in L. vulgare than in P. latifolia. UV radiation significantly inhibited the de-epoxidation of xanthophyll cycle pigments, while enhancing the concentration of luteolin, and particularly of quercetin glycosides. Flavonoids accumulated in the vacuole and the chloroplasts in palisade cells proximal to the adaxial epidermis. We hypothesize that flavonoids might complement the photo-protective functions of xanthophylls in the chloroplasts of mesophyll cells exposed to the greatest doses of UV radiation. However, UV radiation might result in adaxial mesophyll cells being less effective in dissipating the excess of radiant energy, e.g., by decreasing their capacity of thermal dissipation of excess visible light in the chloroplast

Metabolic plasticity in the hygrophyte Moringa oleifera exposed to water stress

Over the past decades, introduction of many fast-growing hygrophilic, and economically valuable plants into xeric environments has occurred. However, production and even survival of these species may be threatened by harsh climatic conditions unless an effective physiological and metabolic plasticity is available. Moringa oleifera Lam., a multipurpose tree originating from humid sub-tropical regions of India, is widely cultivated in many arid countries because of its multiple uses. We tested whether M. oleifera can adjust primary and secondary metabolism to efficiently cope with increasing water stress. It is shown that M. oleifera possesses an effective isohydric behavior. Water stress induced a quick and strong stomatal closure, driven by abscisic acid (ABA) accumulation, and leading to photosynthesis inhibition with consequent negative effects on biomass production. However, photochemistry was not impaired and maximal fluorescence and saturating photosynthesis remained unaffected in stressed leaves. We report for the first time that M. oleifera produces isoprene, and show that isoprene emission increased three-fold during stress progression. It is proposed that higher isoprene biosynthesis helps leaves cope with water stress through its antioxidant or membrane stabilizing action, and also indicates a general MEP (methylerythritol 4-phosphate) pathway activation that further helps protect photosynthesis under water stress. Increased concentrations of antioxidant flavonoids were also observed in water stressed leaves, and probably cooperate in limiting irreversible effects of the stress in M. oleifera leaves. The observed metabolic and phenotypic plasticity may facilitate the establishment of M. oleifera in xeric environments, sustaining the economic and environmental value of this plant

In Vivo Model of Osteoarthritis to Compare Allogenic Amniotic Epithelial Stem Cells and Autologous Adipose Derived Cells

SIMPLE SUMMARY: An early resolution of osteoarthritis (OA), through minimally invasive orthobiological solutions, would be important to enable a return to daily and sport activities, and delay prosthesis solutions. No study has yet evaluated amniotic epithelial stem cells (AECs) in OA. They could be considered a valid alternative to adipose derived cells, expanded or concentrated, because they differentiate into three lineages and express mesenchymal and embryonic markers, without a tumorigenic phenotype. The innovative aspects of this study are the comparison of three injective orthobiological treatments, the in vivo use of AECs in OA, and the evaluation of structural and inflammatory fronts of OA for up to six months. ABSTRACT: The challenge of osteoarthritis (OA) is to find a minimally invasive orthobiological therapy to contrast OA progression, on inflammatory and structural fronts. The aim of the present study is to compare the effects of an intra-articular injection of three orthobiological treatments, autologous culture expanded adipose-derived mesenchymal stromal cells (ADSCs), autologous stromal vascular fraction (SVF) and allogenic culture expanded amniotic epithelial stem cells (AECs), in an animal model of OA. OA was induced in 24 sheep by bilateral lateral meniscectomy and, at 3 and 6 months post-treatment, the results were analyzed with macroscopy, histology, histomorphometry, and biochemistry. All the three treatments showed better results than control (injection of NaCl), but SVF and AECs showed superiority over ADSCs, because they induced higher cartilage regeneration and lower inflammation. SVF showed better results than AECs at 3 and 6 months. To conclude, SVF seems to be more favorable than the other biological options, because it is easily obtained and rapidly used after harvesting, with good healing potential. AECs cause no discomfort and could be also considered for the treatment of OA joints

Multifunctionalization Modulates Hydroxyapatite Surface Interaction with Bisphosphonate: Antiosteoporotic and Antioxidative Stress Materials

Multifunctionalized biomaterials with enhanced bone antiresorptive properties were obtained through adsorption of a bisphosphonate, risedronate, on hydroxyapatite (HA) nanocrystals functionalized with zinc ions and polyethylenimine (PEI). Zn incorporation into the HA structure amounts to about 8 atom %, whereas the PEI content of the bifunctionalized material ZnHAPEIBP is about 5.9 wt %. The mechanism of adsorption and release of the bisphosphonate on ZnHAPEI is compared with that on ZnHA: risedronate adsorption isotherm on ZnHA is a Langmuir type, whereas the isotherm of adsorption on ZnHAPEI is better fitted with a Freundlich model and involved a higher amount of adsorbed risedronate. In vitro cell tests were carried out with a coculture model of osteoblasts and osteoclasts using a model simulating oxidative stress and consequent cellular senescence and osteoporosis by the addition of H2O2. The conditions utilized in the coculture model strongly affect osteoblast behavior. The results show that the composite materials allow an increase in osteoblast viability and recover impairment, revealing a novel characteristic of risedronate that is able to counteract the negative effects of oxidative stress when associated with differently functionalized samples. Both PEI and the bisphosphonate reduce osteoclast viability. Moreover, PEI, and even more risedronate, exerts an inhibitory effect on osteoclast activity

Eudragit s100 entrapped liposome for curcumin delivery: Anti-oxidative effect in Caco-2 cells

Curcumin is a natural polyphenol with strong antioxidant activity. However, this molecule shows a very poor bioavailability, instability, and rapid metabolism in vivo. In this work curcumin was loaded in Eudragit-coated liposomes to create a gastroresistant carrier, able to protect its load from degradation and free it at the site of absorption in the colon region. Small unilamellar vesicles were prepared and coated with Eudragit by a pH-driven method. The physico-chemical properties of the prepared systems were assessed by light scattering, transmission electron microscopy, infrared spectroscopy, and differential scanning calorimetry. The uptake of vesicles by Caco-2 cells and the anti-oxidant activity in cells were evaluated. The produced vesicles showed dimensions of about forty nanometers that after covering with Eudragit resulted to have micrometric dimensions at acid pH. The experiments showed that at pH > 7.0 the polymeric coating dissolves, releasing the nanometric liposomes and allowing them to enter Caco-2 cells. Delivered curcumin loaded vesicles were then able to decrease significantly ROS levels as induced by H2O2 in Caco-2 cells. The proposed work showed the possibility of realizing effective gastroresistant curcumin liposome formulations for the delivery of antioxidant molecules to Caco-2 cells, potentially applicable to the treatment of pathological conditions related to intestinal oxidative stress. View Full-Tex

Biomimetic fabrication of antibacterial calcium phosphates mediated by polydopamine

In this work we developed new antibacterial composite materials using polydopamine (PDA) to trigger the deposition of silver nanoparticles (AgNPs) onto calcium phosphates, namely octacalcium phosphate (OCP) and α-tricalcium phosphate (αTCP). Functionalization of OCP and αTCP with a self-polymerized polydopamine layer was obtained by soaking the calcium phosphates in dopamine solution. The PDA surface of functionalized calcium phosphates (OCPd and αTCPd) promoted the deposition of AgNPs by reducing silver ions when soaked in a silver nitrate solution. The amount of deposited AgNPs can be modulated by varying the concentration of silver nitrate solution and the type of substrate. The results of in vitro tests carried out with osteoblast-like MG63 cells indicate that the combination of AgNPs with OCP provides more biocompatible materials than those obtained using αTCP as substrate. In particular, the study of osteoblast activity and differentiation was focused on the samples OCPdAg5 (silver content = 8.2 wt%) and αTCPdAg5 (silver content = 4.7 wt%), which did not show any cytotoxicity, and compared with those obtained on pure OCP and αTCP. The results demonstrate that the AgNPs loaded materials support osteoblast viability and differentiation, whereas they significantly inhibit the growth of relevant antibiotic-resistant pathogenic bacteria

Lights and shadows concerning platelet products for musculoskeletal regeneration.

Various types of platelet (PLT) products, such as Platelet Rich Plasma (PRP) and Platelet Gel (PG), derived from autologous peripheral blood, have been used for tissue repair. The good clinical outcomes, due mainly to their safety and Growth Factor (GF) content, have led to a wide use of PLT products in many fields of medicine. However, until now the existing literature adds controversies to the use of PLT concentrates. When talking about PLTs and their products, a great number of variables have to be considered. These variables are mainly related to PRP preparation methods, the type of activators, intra- and inter-species variability, types of pathology to be treated, the ways and times of administration and the association of PRP or PG with other treatments. This review considers and discusses these causes of variability with particular attention to orthopaedic implications. The possibility of improving the knowledge on variables affecting therapeutic efficacy will surely help in addressing the best combination of factors implied in the different steps of PLT concentrate preparation and use

Serum Resistin and Kidney Function: A Family-Based Study in Non-Diabetic, Untreated Individuals

Background: High serum resistin levels have been associated with kidney dysfunction. Most of these studies have been carried out in individuals with severe kidney impairment, diabetes, cardiovascular disease and related treatments. Thus, the observed association might have been influenced by these confounders. Our aim was to study the relationship between serum resistin, urinary albumin/creatinine ratio (ACR) and glomerular filtration rate (GFR) in a family-based sample, the Gargano Family Study (GFS) of 635 non diabetic, untreated Whites. Methods: A linear mixed effects model and bivariate analyses were used to evaluate the phenotypic and genetic relations between serum resistin and both ACR and eGFR. All analyses were adjusted for sex, age, age squared, BMI, systolic blood pressure, smoking habits and physical exercise. Results: After adjustments, resistin levels were slightly positively associated with ACR ($\beta \pm$SE = 0.049$\pm$0.023, p = 0.035) and inversely related to eGFR ($\beta \pm$SE = −1.43$\pm$0.61, p = 0.018) levels. These associations remained significant when either eGFR or ACR were, reciprocally, added as covariates. A genetic correlation (ρg = −0.31$\pm$0.12; adjusted p = 0.013) was observed between resistin and eGFR (but not ACR) levels. Conclusion: Serum resistin levels are independently associated with ACR and eGFR in untreated non-diabetic individuals. Serum resistin and eGFR share also some common genetic background. Our data strongly suggest that resistin plays a role in modulating kidney function

Ionized jet deposition of silver nanostructured coatings: Assessment of chemico-physical and biological behavior for application in orthopedics

Infection is one of the main issues connected to implantation of biomedical devices and represents a very difficult issue to tackle, for clinicians and for patients. This study aimed at tackling infection through antibacterial nanostructured silver coatings manufactured by Ionized Jet Deposition (IJD) for application as new and advanced coating systems for medical devices. Films composition and morphology depending on deposition parameters were investigated and their performances evaluated by correlating these properties with the antibacterial and antibiofilm efficacy of the coatings, against Escherichia coli and Staphylococcus aureus strains and with their cytotoxicity towards human cell line fibroblasts. The biocompatibility of the coatings, the nanotoxicity, and the safety of the proposed approach were evaluated, for the first time, in vitro and in vivo by rat subcutaneous implant models. Different deposition times, corresponding to different thicknesses, were selected and compared. All silver coatings exhibited a highly homogeneous surface composed of nanosized spherical aggregates. All coatings having a thickness of 50 nm and above showed high antibacterial efficacy, while none of the tested options caused cytotoxicity when tested in vitro. Indeed, silver films impacted on bacterial strains viability and capability to adhere to the substrate, in a thickness-dependent manner. The nanostructure obtained by IJD permitted to mitigate the toxicity of silver, conferring strong antibacterial and anti-adhesive features, without affecting the coatings biocompatibility. At the explant, the coatings were still present although they showed signs of progressive dissolution, compatible with the release of silver, but no cracking, delamination or in vivo toxicity was observed