Shelf-Ocean material exchange influencing the Atlantic chemical composition off NW Iberian margin since the last glaciation

Rivers are the main conduit of sediment to the shelf. The basin geology, the drainage area and the discharge rate are the major factors that determine their sediment load (Milliman and Syvistski, 1992). Besides suspended particles, dissolved components may also give some information on the eroded crust. Sr isotopes in carbonate shells of biological organisms have been used to study, in the geological record, the influence exerted by the chemical weathering of the continental crust on the seawater composition (Macdougall, 1991). In this work, Sr isotope ratios obtained in tests of foraminifera representing the last 40 ka are presented and discussed in the scope of the palaeogeographical evolution of NW Iberia. This work aims to present and discuss the results of Sr isotope analyses (performed, by TIMS, in the Isotope Geology Laboratory of the University of Aveiro) of tests of two species of foraminifera, from nine samples taken along the OMEX core KC 024-19 (181 cm; 42°08’98’’N, 10°29´96’’W, and 2765m), collected in the Galicia Bank area, off Galicia. Taking into account that Sr contained in the carbonate tests is usually considered as preserving the signature of the contemporaneous seawater, one planktonic species (Globigerina bulloides) and one benthic species (Cibicides wuellerstorfi) were selected in order to try to detect Sr isotope variations both through time and between two different levels of the water column. The core age model, which records the last 40 ka, is based on a combination of oxygen isotope stratigraphy, eight AMS 14C datings and the synchronisation of the last four Heinrich Events in the Iberian Margin sedimentary records. As a whole, the obtained 87Sr/86Sr ratios vary between 0.709209 and 0.709108, with a mean 2σ error of 0.000025. These values lie within the range of modern marine Sr isotope ratios (0.70910-0.70922), as previously defined using analyses of both seawater and marine carbonates (see compilation by Faure and Mensing, 2005). Despite their small variation, the 87Sr/86Sr ratios obtained in G. bulloides seem to indicate that Sr dissolved in seawater at the KC 024-19 core site became slightly less radiogenic after the Last Glacial Maximum (LGM). This decrease is concomitant with diminishing amounts of the detrital components in the sediments (Fig. 1). Therefore, both the composition of dissolved Sr, as revealed by results on tests of planktonic foraminifera, and the proportions of suspended terrigenous particulate material arriving at the KC 024-19 site point to a decreasing importance of the contribution of the erosion of the Iberian Variscan crust since the Last Glacial Maximum and in the Holocene. The 87Sr/86Sr ratios measured in tests of benthic foraminifera (C. wuellerstorfi) are more erratic and no correlation can be established with palaeogeographical/palaeoclimatic constraints. The difference between the behaviour of Sr compositions in G. bulloides and C. wuellerstorfi may indicate that whilst the planktonic foraminifera should reproduce very closely the seawater composition, the benthic organisms should, in addition to the major role of seawater, also be affected by some sort of interaction with the sediments. As such, planktonic foraminifera are probably more reliable indicators of seawater composition in studies involving very small periods and corresponding very slight variations of the 87Sr/86Sr ratios. Taking into account that G. bulloides is a common planktonic species (living mostly in the first 50m of the water column), whose tests seem to be in equilibrium with sea water composition, variations in its 87Sr/86Sr ratios can be related with changes in the chemical composition of the water of the Atlantic Ocean off NW Iberian Margin. The highest 87Sr/86Sr values are contemporaneous with a period of low sea level (about -140 m; Dias et al., 2000) during the LGM. According to Dias et al. (2000) at 18 ka BP the shoreline was close to the shelf break. The summital parts of the Gerês and Estrela mountains were covered by local glaciers and close to the coast freezing occurred frequently. The river catchments, which extended far to the shelf, received more rainfall due to a longer, compared to present day conditions, wet season, which promoted both physical and chemical weathering. Higher pluviosity combined with the effect of spring ice melting maintained high river discharge and consequently caused very important sediment supply to the coastal zone. The extremely narrow shelf was a very energetic environment due to sea bottom inclination and very limited long wave refraction. Therefore, at that time, a long wet season and very competent rivers should have caused important erosion of the Variscan basement in NW Iberia. Additionally, then, the shoreline was much closer to the KC 024-19 site. The combination of all these factors favoured an important deposition of terrigenous sediments and the local slight enrichment in radiogenic Sr of the seawater. With sea level rise, after the deglaciation and during the Holocene, the river estuaries became progressively far away from the shelf break. Their competence of transport also became progressively reduced and the offshore transport of detrital sediments became progressively lower. Conversely the biogenic carbonate proportion in the sediments increased, due to lower dilution by the terrigenous particles. Simultaneously, the values of 87Sr/86Sr in the seawater at the KC 024-19 site became lower, as a consequence of a complete homogenization with the ocean global composition, which was now more effective with the increasing distance towards shoreline

Ibuprofen nanocrystals: Production, lyophilization and release profile

Ibuprofen (IBU) is a poorly water-soluble non-steroidal anti-inflammatory drug with proven effectiveness for treating inflammatory, musculoskeletal, and rheumatic disorders. Nanocrystals (NCs) have been proposed as drug delivery systems to improve the solubility and bioavailability of poorly water-soluble compounds. Ibuprofen NCs (IBU-NCs) have been produced by the melt-emulsification method using a combination of Tween®80(1.0%, w/v)/Span®80(0.5%, w/v) as surfactant as these molecules are generally recognized as safe (GRAS) as non-toxic, non-irritating and are of low cost. The obtained main particle size (z-Ave) and polydispersity index (PdI) were 159.4 ± 3.265 nm and 0.24 ± 0.007, respectively. Lyophilization slightly increased the mean particle size and PdI compared to the non-freeze-dried IBU-NCs. The obtained IBU-NCs powders were of white and fine texture. The type and concentration of cryoprotector (trehalose, glucose, sucrose) influenced both the size and the in vitro release profile tested in Franz diffusion cells. Due to the smaller z-Ave, NCs:Trehalose (2:1) of 170.6 ± 3.880 nm (0.417 ± 0.050), NCs:Glucose (3:1) of 275.3 ± 8.351 nm (0.144 ± 0.021) and NCs:Sucrose (4:1) of 223.3 ± 10.35 nm (0.402 ± 0.016) were selected for the in vitro drug release tests. Within the first 6 hours, resuspended lyophilized nanocrystals released between 50-70% of the drug

Toxicity and effects of copper sulfate on parasitic control and hematological response of tambaqui Colossoma macropomum.

The purpose of this work was to determine the mean lethal concentration (LC50-96h) of copper sulfate (CuSO4) for juveniles Colossoma macropomum (Characidae), to evaluate the effectiveness of different concentrations of CuSO4 on elimination of parasites, as well as to study the effects of CuSO4 on blood parameters after short-term exposure. After determination of the LC50-96h from 17.5 mg L-1 of CuSO4, it was investigated the effects of exposure for 48 h to 1.75, 4.37 and 8.75 mg L-1 of CuSO4, on parasites and blood parameters. In gills and skin, concentrations of 4.37 and 8.75 mg L-1 of CuSO4 eliminated Monogenoidea Anacanthorus spathulatus. In fish exposed to different concentrations of CuSO4, plasma total protein, chloride, potassium, glucose and copper levels, hemoglobin and hematocrit were similar to controls, whereas sodium levels presented decrease in fish exposed to 1.75 and 4.37 mg L-1. Red blood cell counts decreased in fish exposed to different three concentrations of CuSO4, while the Mean Corpuscular Volume (MCV) increased. However, exposure to 8.75 mg L-1 of CuSO4 caused decrease on total leukocytes, lymphocytes, neutrophils and PAS-positive granular leukocytes (PAS-GL) number when compared to control fish

ROAZ Autonomous Surface Vehicle Design and Implementation

The design of an Autonomous Surface Vehicle for operation in river and estuarine scenarios is presented. Multiple operations with autonomous underwater vehicles and support to AUV missions are one of the main design goals in the ROAZ system. The mechanical design issues are discussed. Hardware, software and implementation status are described along with the control and navigation system architecture. Some preliminary test results concerning a custom developed thruster are presented along with hydrodynamic drag calculations by the use of computer fluid dynamic methods

Infill masonry: simple analytical methods for seismic design

The latest earthquake codes in Europe require the safety assessment of no-structural elements (parapets, masonry wall’s veneer, infill walls, etc.), as their collapse entails risks for people or for the main structure stability. This work made possible th e development of a design method, supported by previous experimental researches by applying cyclic out-of-plane loads to damaged masonry infill in RC frames. Panels tested reproduce Portuguese traditional RC structure construction system and two reinforced solutions were created as innovative solutions. The experimental campaign was carried out in order to determine: masonry properties; out-of-plane panel behaviour with previous in-plane damage; building behaviour subjected to dynamic tests performed in shaking table. Using finite element method to reproduce experimental tests and to broaden the range of samples it was possible to figure out equations according to parametric analysis which was able to reproduce in-plane and out-plane behaviour leading to an estimated load bearing capacity of each model and to determine frame strength and its stiffness. Those equations permit to design or verify the masonry infill panels in RC frames subjected to seismic loads

Behavior of masonry infill panels in RC frames subjected to in plane and out of plane loads

The building envelope in Europe is usually made of masonry walls, with enclosure and infill functions. Masonry walls have a major economical importance and contribute significantly to the building performance. Even if infill walls have no load-bearing function, they contribute significantly to the seismic behavior of buildings. Therefore, their adequate structural performance is needed, avoiding the occurrence of severe in-plane damage, with very large economical losses, and the out-of-plane expulsion, which additionally represents a large risk for human life. Recent earthquake codes in Europe require the safety assessment of non-structural elements (parapets, veneer masonry walls, infill walls, etc.), when their collapse entails risks for people or for the main structure. The Eurocode standards, entering the mandatory stage now, incorporate new requirements to be fulfilled by buildings or their parts. Such is the case of masonry infilled RC frames whose panels, according to Eurocode 8, are explicitly required to withstand the out-of-plane movement induced by earthquakes. Appropriate measures should be taken to avoid brittle failure and premature disintegration of the infill walls, as well as the partial or total out-of-plane collapse of slender masonry panels. This paper presents the experimental work and results achieved by applying cyclic out-ofplane loads to damaged masonry infilled RC frames. The masonry panels were previously damaged by applying an in-plane cyclic load after which the cyclic out-of- plane loads were applied. The frames and panels tested follow the traditional Portuguese RC structure construction system to which different types of reinforcement have been introduced in the panels

Ácido indolbutiríco e tamanho de estaca de raiz na produção de mudas de bacurizeiro (Platonia insignis Mart.).

O maracujazeiro amarelo (Passiflora edulis f. flavicarpa) é originário da América Tropical, responsável por mais de 95% da produção do Brasil. Baixos índices de produção podem está associados ao ataque de pragas. O processo de amostragem é um dos passos mais importante para tomada de decisão de controle de pragas. Assim o objetivo deste trabalho foi avaliar o índice de infestação da abelha arapuá no cultivo de maracujazeiro amarelo no brejo paraibano. O trabalho foi realizado no município de Areia-PB, em uma área de 1,5 ha, no mês de julho de 2010, em plantas adultas no segundo ano de produção. O processo de amostragem foi realizado em toda a planta, dividindo-se a copa em dois lados, Em seguida foi atribuído o critério de notas, para todas as flores nas plantas amostradas e estas, posteriormente, computadas para a obtenção da intensidade ou grau de infestação (GI). Houve diferença para as duas avaliações, mostrando que o grau de infestação é alterado. Fato que pode está associado ao número flores existente

Activated sludge process monitoring through in-situ NIR spectral analysis

The application of near infrared (NIR) spectroscopy for industrial process monitoring is achieving increasing importance over the last twenty years. In fact, the real time monitoring capacity of NIR spectroscopy is a very important feature for process monitoring, prediction and control as it allows a fast evaluation of the state of the process. However, the application of NIR spectroscopy in wastewater treatment processes is still to be explored. Although some applications of the technique for wastewater monitoring have been reported in the literature, there is still a need for more investigation related with applications, limitations and advantages of the technique when compared with other methods. An activated sludge reactor for aerobic treatment of a complex medium was monitored in situ with a NIR transflectance probe and traditional chemical parameters analysed off-line. NIR spectrophotometric data measured at the feed, reactor and settler were coupled to principal component analysis (PCA) to infer about the ability of this monitoring system to detect changes in the feed influent. The analysis of the score plots resulting from PCA permitted to identify the moments at which the perturbations occurred and to follow the consequent instability induced in the reactor till the day where the system is recuperated. The promising results obtained, suggest the interest in more detailed studies on the feasibility of NIR spectroscopy as an alternative method for monitoring and control of wastewater treatment processes.Fundação para a Ciência e a Tecnologia (FCT) - POCTI/AMB/60141/2001

DEVELOPMENT OF AN AIR HEATING AND HUMIDIFYING SYSTEM FOR MECHANICAL VENTILATION OF INTENSIVE CARE UNIT PATIENTS

The mechanical ventilators, also named artificial ventilators, are devices used in Intensive Care Units (ICU) for clinically critical patients. The equipment provides artificial breathing for the patient, creating favorable conditions for the patient recovery. It works as a system that is connected to the electric grid and two other networks, one supplies compressed air and the other supplies pure oxygen. Inside the equipment the gases are mixed, and then warmed up and humidified to be finally delivered to the patient. The existing system for treatment of the mixture is not effective, since it delivers the breathing air to the patient out of the normal physiology recommended range, i.e., temperature ~32-34°C and relative humidity ~80-95%. The objective of this work was to develop a new air heating and humidifying system for mechanical ventilation. First, it was built an air feeding system, composed by a compressor and an electronically controlled valve to simulate an actual mechanical ventilation system in the laboratory. A device for conditioning the air (temperature and humidity) was conceived and built for treating the air feeding system output air. The results of the laboratory measurements show that the developed equipment was capable of making the breathing air to reach the recommended ranges by the normal physiology