602 research outputs found
Characterisation of the CAFOS linear spectro-polarimeter
Aims. This research note presents a full analysis of the CAFOS polarimeter
mounted at the Calar Alto 2.2m telescope. It also provides future users of this
mode with all necessary information to properly correct for instrumental
effects in polarization data obtained with this instrument.
Methods. The standard stars BD+59d389 (polarized) and HD14069 (unpolarized)
were observed with CAFOS in November, 2010, using 16 half-wave plate angles.
The linear spectropolarimetric properties of CAFOS were studied using a Fourier
Analysis of the resulting data.
Results. CAFOS shows a roughly constant instrumental polarization at the
level of ~0.3% between 4000 and 8600 A. Below 4000 A the spurious polarization
grows to reach ~0.7% at 3600 A. This instrumental effect is most likely
produced by the telescope optics, and appears to be additive. The Wollaston
prism presents a clear deviation from the ideal behavior. The problem is
largely removed by the usage of at least 4 retarder plate angles. The
chromatism of the half-wave plate causes a peak-to-peak oscillation of ~11
degrees in the polarization angle. This can be effectively corrected using the
tabulated values presented in this paper. The Fourier analysis shows that the
k!=0,4 harmonics are practically negligible between 3800 and 7400 A.
Conclusions. After correcting for instrumental polarization and retarder
plate chromatism, with 4 half-wave plate angles CAFOS can reach an rms linear
polarization accuracy of about 0.1%.Comment: 5 pages, 5 figures, Accepted for publication in A&A (Research Note
The Axisymmetric Pulsar Magnetosphere
We present, for the first time, the structure of the axisymmetric force-free
magnetosphere of an aligned rotating magnetic dipole, in the case in which
there exists a sufficiently large charge density (whose origin we do not
question) to satisfy the ideal MHD condition, , everywhere.
The unique distribution of electric current along the open magnetic field lines
which is required for the solution to be continuous and smooth is obtained
numerically. With the geometry of the field lines thus determined we compute
the dynamics of the associated MHD wind. The main result is that the
relativistic outflow contained in the magnetosphere is not accelerated to the
extremely relativistic energies required for the flow to generate gamma rays.
We expect that our solution will be useful as the starting point for detailed
studies of pulsar magnetospheres under more general conditions, namely when
either the force-free and/or the ideal MHD condition are not
valid in the entire magnetosphere. Based on our solution, we consider that the
most likely positions of such an occurrence are the polar cap, the crossings of
the zero space charge surface by open field lines, and the return current
boundary, but not the light cylinder.Comment: 15 pages AAS Latex, 5 postscript figure
Magnetohydrodynamic jets from different magnetic field configurations
Using axisymmetric MHD simulations we investigate how the overall jet
formation is affected by a variation in the disk magnetic flux profile and/or
the existence of a central stellar magnetosphere. Our simulations evolve from
an initial, hydrostatic equilibrium state in a force-free magnetic field
configuration. We find a unique relation between the collimation degree and the
disk wind magnetization power law exponent. The collimation degree decreases
for steeper disk magnetic field profiles. Highly collimated outflows resulting
from a flat profile tend to be unsteady. We further consider a magnetic field
superposed of a stellar dipole and a disk field in parallel or anti-parallel
alignment. Both stellar and disk wind may evolve in a pair of outflows,
however, a reasonably strong disk wind component is essential for jet
collimation. Strong flares may lead to a sudden change in mass flux by a factor
two. We hypothesize that such flares may eventually trigger jet knots.Comment: 5 pages, 4 figures; proceedings from conference: Protostellar Jets in
Context, held in Rhodes, July 7-12, 200
Accretion-Powered Stellar Winds II: Numerical Solutions for Stellar Wind Torques
[Abridged] In order to explain the slow rotation observed in a large fraction
of accreting pre-main-sequence stars (CTTSs), we explore the role of stellar
winds in torquing down the stars. For this mechanism to be effective, the
stellar winds need to have relatively high outflow rates, and thus would likely
be powered by the accretion process itself. Here, we use numerical
magnetohydrodynamical simulations to compute detailed 2-dimensional
(axisymmetric) stellar wind solutions, in order to determine the spin down
torque on the star. We explore a range of parameters relevant for CTTSs,
including variations in the stellar mass, radius, spin rate, surface magnetic
field strength, the mass loss rate, and wind acceleration rate. We also
consider both dipole and quadrupole magnetic field geometries.
Our simulations indicate that the stellar wind torque is of sufficient
magnitude to be important for spinning down a ``typical'' CTTS, for a mass loss
rate of yr. The winds are wide-angle,
self-collimated flows, as expected of magnetic rotator winds with moderately
fast rotation. The cases with quadrupolar field produce a much weaker torque
than for a dipole with the same surface field strength, demonstrating that
magnetic geometry plays a fundamental role in determining the torque. Cases
with varying wind acceleration rate show much smaller variations in the torque
suggesting that the details of the wind driving are less important. We use our
computed results to fit a semi-analytic formula for the effective Alfv\'en
radius in the wind, as well as the torque. This allows for considerable
predictive power, and is an improvement over existing approximations.Comment: Accepted for publication in Ap
Dynamics and Structure of Three-Dimensional Trans-Alfvenic Jets. II. The Effect of Density and Winds
Two three-dimensional magnetohydrodynamical simulations of strongly
magnetized conical jets, one with a poloidal and one with a helical magnetic
field, have been performed. In the poloidal simulation a significant sheath
(wind) of magnetized moving material developed and partially stabilized the jet
to helical twisting. The fundamental pinch mode was not similarly affected and
emission knots developed in the poloidal simulation. Thus, astrophysical jets
surrounded by outflowing winds could develop knotty structures along a straight
jet triggered by pinching. Where helical twisting dominated the dynamics,
magnetic field orientation along the line-of-sight could be organized by the
toroidal flow field accompanying helical twisting. On astrophysical jets such
structure could lead to a reversal of the direction of Faraday rotation in
adjacent zones along a jet. Theoretical analysis showed that the different
dynamical behavior of the two simulations could be entirely understood as a
result of dependence on the velocity shear between jet and wind which must
exceed a surface Alfven speed before the jet becomes unstable to helical and
higher order modes of jet distortion.Comment: 25 pages, 15 figures, in press Astrophysical Journal (September
Ultra-Relativistic Magneto-Hydro-Dynamic Jets in the context of Gamma Ray Bursts
We present a detailed numerical study of the dynamics and evolution of
ultrarelativistic magnetohydrodynamic jets in the black hole-disk system under
extreme magnetization conditions. We find that Lorentz factors of up to 3000
are achieved and derived a modifiedMichel scaling (Gamma ~ sigma) which allows
for a wide variation in the flow Lorentz factor. Pending contamination induced
by mass-entrainment, the linear Michel scaling links modulations in the
ultrarelativistic wind to variations in mass accretion in the disk for a given
magnetization. The jet is asymptotically dominated by the toroidal magnetic
field allowing for efficient collimation. We discuss our solutions (jets) in
the context of Gamma ray bursts and describe the relevant features such as the
high variability in the Lorentz factor and how high collimation angles (~ 0-5
degrees), or cylindrical jets, can be achieved. We isolate a jet instability
mechanism we refer to as the "bottle-neck" instability which essentially relies
on a high magnetization and a recollimation of the magnetic flux surfaces. The
instability occurs at large radii where any dissipation of the magnetic energy
into radiation would in principle result in an optically thin emission.Comment: 31 pages, 6 figures. Submitted to ApJ. Higher Quality figures at
http://www.capca.ucalgary.ca/paper
Pain-relief learning in flies, rats, and man: basic research and applied perspectives
Memories relating to a painful, negative event are adaptive and can be stored for a lifetime to support preemptive avoidance, escape, or attack behavior. However, under unfavorable circumstances such memories can become overwhelmingly powerful. They may trigger excessively negative psychological states and uncontrollable avoidance of locations, objects, or social interactions. It is therefore obvious that any process to counteract such effects will be of value. In this context, we stress from a basic-research perspective that painful, negative events are "Janus-faced" in the sense that there are actually two aspects about them that are worth remembering: What made them happen and what made them cease. We review published findings from fruit flies, rats, and man showing that both aspects, respectively related to the onset and the offset of the negative event, induce distinct and oppositely valenced memories: Stimuli experienced before an electric shock acquire negative valence as they signal upcoming punishment, whereas stimuli experienced after an electric shock acquire positive valence because of their association with the relieving cessation of pain. We discuss how memories for such punishment-and relief-learning are organized, how this organization fits into the threat-imminence model of defensive behavior, and what perspectives these considerations offer for applied psychology in the context of trauma, panic, and nonsuicidal self-injury
Can Protostellar Jets Drive Supersonic Turbulence in Molecular Clouds?
Jets and outflows from young stellar objects are proposed candidates to drive
supersonic turbulence in molecular clouds. Here, we present the results from
multi-dimensional jet simulations where we investigate in detail the energy and
momentum deposition from jets into their surrounding environment and quantify
the character of the excited turbulence with velocity probability density
functions. Our study include jet--clump interaction, transient jets, and
magnetised jets. We find that collimated supersonic jets do not excite
supersonic motions far from the vicinity of the jet. Supersonic fluctuations
are damped quickly and do not spread into the parent cloud. Instead subsonic,
non-compressional modes occupy most of the excited volume. This is a generic
feature which can not be fully circumvented by overdense jets or magnetic
fields. Nevertheless, jets are able to leave strong imprints in their cloud
structure and can disrupt dense clumps. Our results question the ability of
collimated jets to sustain supersonic turbulence in molecular clouds.Comment: 33 pages, 18 figures, accepted by ApJ, version with high resolution
figures at:
http://www.ita.uni-heidelberg.de/~banerjee/publications/jet_paper.pd
The structure of black hole magnetospheres. I. Schwarzschild black holes
We introduce a multipolar scheme for describing the structure of stationary,
axisymmetric, force-free black-hole magnetospheres in the ``3+1'' formalism. We
focus here on Schwarzschild spacetime, giving a complete classification of the
separable solutions of the stream equation. We show a transparent term-by-term
analogy of our solutions with the familiar multipoles of flat-space
electrodynamics. We discuss electrodynamic processes around disk-fed black
holes in which our solutions find natural applications: (a) ``interior''
solutions in studies of the Blandford-Znajek process of extracting the hole's
rotational energy, and of the formation of relativistic jets in active galactic
nuclei and ``microquasars'', and, (b) ``exterior'' solutions in studies of
accretion disk dynamos, disk-driven winds and jets. On the strength of existing
numerical studies, we argue that the poloidal field structures found here are
also expected to hold with good accuracy for rotating black holes, except for
maximum possible rotation rates. We show that the closed-loop exterior
solutions found here are not in contradiction with the Macdonald-Thorne
theorem, since these solutions, which diverge logarithmically on the hole's
horizon , apply only to those regions which exclude .Comment: 6 figures. Accepted for publication by MNRA
Locking of the Rotation of Disk-Accreting Magnetized Stars
We investigate the rotational equilibrium state of a disk accreting
magnetized stars using axisymmetric magnetohydrodynamic (MHD) simulations. In
this ``locked'' state, the spin-up torque balances the spin-down torque so that
the net average torque on the star is zero. We investigated two types of
initial conditions, one with a relatively weak stellar magnetic field and a
high coronal density, and the other with a stronger stellar field and a lower
coronal density. We observed that for both initial conditions the rotation of
the star is locked to the rotation of the disk. In the second case, the radial
field lines carry significant angular momentum out of the star. However, this
did not appreciably change the condition for locking of the rotation of the
star. We find that in the equilibrium state the corotation radius is
related to the magnetospheric radius as for
case (1) and for case (2). We estimated periods of
rotation in the equilibrium state for classical T Tauri stars, dwarf novae and
X-ray millisecond pulsars.Comment: 10 pages, 9 figures. Accepted by ApJ, will appear in vol. 634, 2005
December
- …