Evaluation of a spring-powered captive bolt gun for killing kangaroo pouch young

Context: During commercial harvesting or non-commercial kangaroo culling programs, dependent young of shot females are required to be euthanased to prevent suffering and because they would be unlikely to survive. However, the current method for killing pouch young, namely a single, forceful blow to the base of the skull, is applied inconsistently by operators and perceived by the public to be inhumane. Aims: To determine whether an alternative method for killing pouch young, namely a spring-operated captive bolt gun, is effective at causing insensibility in kangaroo pouch young. Methods: Trials of spring-operated captive bolt guns were conducted first on the heads of 15 dead kangaroo young and then on 21 live pouch young during commercial harvesting. We assessed the effectiveness at causing insensibility in live animals and damage caused to specific brain areas. We also measured depth of bolt penetration and skull thickness. Performance characteristics (e.g. bolt velocity) of two types of spring-operated guns were also measured and compared with cartridge-powered devices. Key results: When tested on the heads of dead animals, the spring-operated captive bolt gun consistently produced a large entrance cavity and a well defined wound tract, which extended into the cerebrum, almost extending the full thickness of the brain, including the brainstem. When tested on live pouch young, the captive bolt gun caused immediate insensibility in only 13 of 21 animals. This 62% success rate is significantly below the 95% minimum acceptable threshold for captive bolt devices in domestic animal abattoirs. Failure to stun was related to bolt placement, but other factors such as bolt velocity, bolt diameter and skull properties such as thickness and hardness might have also contributed. Spring-operated captive bolt guns delivered 20 times less kinetic energy than did cartridge-powered devices. Conclusions: Spring-operated captive bolt guns cannot be recommended as an acceptable or humane method for stunning or killing kangaroo pouch young. Implications: Captive bolt guns have potential as a practical alternative to blunt head trauma for effective euthanasia and reducing animal (and observer) distress. However, operators must continue to use the existing prescribed killing methods until cartridge-powered captive bolt guns have been trialled as an alternative bolt propelling method. Additional keywords: animal welfare, blunt trauma, culling, euthanasia, humaneness, kangaroo harvesting

Atomic layer depostion of TiO2/Al2O3 films for optical applications

Atomic layer deposition (ALD) is an important technology for depositing functional coatings on accessible, reactive surfaces with precise control of thickness and nanostructure. Unlike conventional chemical vapour deposition, where growth rate is dependent on reactant flux, ALD employs sequential surface chemical reactions to saturate a surface with a (sub-) monolayer of reactive compounds such as metal alkoxides or covalent halides, followed by reaction with a second compound such as water to deposit coatings layer-by-layer. A judicious choice of reactants and processing conditions ensures that the reactions are self-limiting, resulting in controlled film growth with excellent conformality to the substrate. This paper investigates the deposition and characterisation of multi-layer TiO2 /Al2O3 films on a range of substrates, including silicon , soda glass and polycarbonate, using titanium tetrachloride/water and trimethylaluminium/water as precursor couples. Structure-property correlations were established using a suite of analytical tools, including transmission electron microscopy (TEM), secondary ion mass spectrometry (SIMS), X-ray reflectometry (XRR) and spectroscopic ellipsometry (SE). The evolution of nanostructure and composition of multi-layer high/low refractive index stacks are discussed as a function of deposition parameters

Enhancing accuracy and precision of transparent synthetic soil modelling

Over recent years non-intrusive modelling techniques have been developed to investigate soil-structure interaction problems of increasingly complex geometry. This paper concerns the development of a small-scale, 1 g, modelling technique using a transparent analogue for soil with particle image velocimetry for internal displacement measurement. Larger model geometry achieved in this research using fine-grained transparent synthetic soils has led to an increased need for rigorous photogrammetric correction techniques. A correction framework, based upon a modified version of the pinhole camera model, is presented that corrects for lens and camera movement induced errors as well as scaling from image space to object space. An additional statistical approach is also developed to enhance the system precision, by minimising the impact of increased non-coplanarity between the photogrammetry control plane and the target plane. The enhanced data correction and statistical precision is demonstrated using a case study examining the failure mechanism around a double helical screw pile installed in transparent synthetic soil representative of a soft clay

Naturally propped fractures caused by quartz cementation preserve oil reservoirs in basement rocks

MB is in receipt of a postgraduate studentship from PTDF (Nigeria). Skilled technical support was provided by M. Baron and J. Still. Two reviewers made valuable criticisms that improved the paper.Peer reviewedPostprin

Clostridium perfringens epsilon toxin increases the small intestinal permeability in mice and rats

Epsilon toxin is a potent neurotoxin produced by Clostridium perfringens types B and D, an anaerobic bacterium that causes enterotoxaemia in ruminants. In the affected animal, it causes oedema of the lungs and brain by damaging the endothelial cells, inducing physiological and morphological changes. Although it is believed to compromise the intestinal barrier, thus entering the gut vasculature, little is known about the mechanism underlying this process. This study characterizes the effects of epsilon toxin on fluid transport and bioelectrical parameters in the small intestine of mice and rats. The enteropooling and the intestinal loop tests, together with the single-pass perfusion assay and in vitro and ex vivo analysis in Ussing's chamber, were all used in combination with histological and ultrastructural analysis of mice and rat small intestine, challenged with or without C. perfringens epsilon toxin. Luminal epsilon toxin induced a time and concentration dependent intestinal fluid accumulation and fall of the transepithelial resistance. Although no evident histological changes were observed, opening of the mucosa tight junction in combination with apoptotic changes in the lamina propria were seen with transmission electron microscopy. These results indicate that C. perfringens epsilon toxin alters the intestinal permeability, predominantly by opening the mucosa tight junction, increasing its permeability to macromolecules, and inducing further degenerative changes in the lamina propria of the bowel. © 2009 Goldstein et al

DNA Damage Responses in Human Induced Pluripotent Stem Cells and Embryonic Stem Cells

BACKGROUND: Induced pluripotent stem (iPS) cells have the capability to undergo self-renewal and differentiation into all somatic cell types. Since they can be produced through somatic cell reprogramming, which uses a defined set of transcription factors, iPS cells represent important sources of patient-specific cells for clinical applications. However, before these cells can be used in therapeutic designs, it is essential to understand their genetic stability.\ud \ud METHODOLOGY/PRINCIPAL FINDINGS: Here, we describe DNA damage responses in human iPS cells. We observe hypersensitivity to DNA damaging agents resulting in rapid induction of apoptosis after γ-irradiation. Expression of pluripotency factors does not appear to be diminished after irradiation in iPS cells. Following irradiation, iPS cells activate checkpoint signaling, evidenced by phosphorylation of ATM, NBS1, CHEK2, and TP53, localization of ATM to the double strand breaks (DSB), and localization of TP53 to the nucleus of NANOG-positive cells. We demonstrate that iPS cells temporary arrest cell cycle progression in the G(2) phase of the cell cycle, displaying a lack of the G(1)/S cell cycle arrest similar to human embryonic stem (ES) cells. Furthermore, both cell types remove DSB within six hours of γ-irradiation, form RAD51 foci and exhibit sister chromatid exchanges suggesting homologous recombination repair. Finally, we report elevated expression of genes involved in DNA damage signaling, checkpoint function, and repair of various types of DNA lesions in ES and iPS cells relative to their differentiated counterparts.\ud \ud CONCLUSIONS/SIGNIFICANCE: High degrees of similarity in DNA damage responses between ES and iPS cells were found. Even though reprogramming did not alter checkpoint signaling following DNA damage, dramatic changes in cell cycle structure, including a high percentage of cells in the S phase, increased radiosensitivity and loss of DNA damage-induced G(1)/S cell cycle arrest, were observed in stem cells generated by induced pluripotency.\ud \u

Clostridium perfringens epsilon toxin mutant Y30A-Y196A as a recombinant vaccine candidate against enterotoxemia

Epsilon toxin (Etx) is a β-pore-forming toxin produced by Clostridium perfringens toxinotypes B and D and plays a key role in the pathogenesis of enterotoxemia, a severe, often fatal disease of ruminants that causes significant economic losses to the farming industry worldwide. This study aimed to determine the potential of a site-directed mutant of Etx (Y30A-Y196A) to be exploited as a recombinant vaccine against enterotoxemia. Replacement of Y30 and Y196 with alanine generated a stable variant of Etx with significantly reduced cell binding and cytotoxic activities in MDCK.2 cells relative to wild type toxin (>430-fold increase in CT50) and Y30A-Y196A was inactive in mice after intraperitoneal administration of trypsin activated toxin at 1000× the expected LD50 dose of trypsin activated wild type toxin. Moreover, polyclonal antibody raised in rabbits against Y30A-Y196A provided protection against wild type toxin in an in vitro neutralisation assay. These data suggest that Y30A-Y196A mutant could form the basis of an improved recombinant vaccine against enterotoxemia

Design development post contract signing in New Zealand:Client's or contractor's cost?

By offering fixed-price contracts for designs supplied by clients, contractors legally warrant that they can build what has been designed and do so within their fixed price. Yet detailed drawings are often issued during construction in response to contractors' requests for information on the basis that they cannot otherwise build what has been designed. Claim-entitlement decisions are often made by construction professionals (architects, engineers and quantity surveyors) without legal training in contractual interpretation, potentially varying who pays for design development after contract signing, contractors or clients. Prior studies have addressed buildability obligations relating to ground conditions and foundations. This study applies key principles of contract law to consider who should pay for instructed drawing details post contract signing under the New Zealand standard NZS 3910:2013, 'Conditions of contract for building and civil engineering construction', in terms of (a) when a variation claim may be accepted; (b) the effect of contractor involvement on design development; and (c) the effect if claimed from a building subcontractor to a consultant manager (no head contractor). A claim-entitlement flow chart and a table comparing the head contractor's and consultant construction manager's obligations provide practical guides for contract administrators. Identifying terms prone to interpretation informs contract drafters towards reducing ambiguity for contract users and therefore the potential for dispute