24 research outputs found

    Bulk ion heating with ICRH in JET DT plasmas

    Get PDF
    Reactor relevant ICRH scenarios have been assessed during DT experiments on the JET tokamak using H mode divertor discharges with ITER-like shapes and safety factors. Deuterium minority heating in tritium plasmas was demonstrated for the first time. For 9% deuterium, an ICRH power of 6 MW gave 1.66 MW of fusion power from reactions between suprathermal deuterons and thermal tritons. The Q value of the steady state discharge reached 0.22 for the length of the RF flat-top (2.7 s), corresponding to three plasma energy replacement times. The Doppler broadened neutron spectrum showed a deuteron energy of 125 keV, which was optimum for fusion and close to the critical energy. Thus, strong bulk ion heating was obtained at the same time as high fusion efficiency. Deuterium fractions around 20% produced the strongest ion heating together with a strong reduction of the suprathermal deuteron tail. The ELMs had low amplitude and high frequency and each ELM transported less plasma energy content than the 1% required by ITER. The energy confinement time, on the ITERH97-P scale, was 0.90, which is sufficient for ignition in ITER. 3He minority heating, in approximately 50:50 D:T plasmas with up to 10% 3He, also demonstrated strong bulk ion heating. Central ion temperatures up to 13 keV were achieved, together with central electron temperatures up to 12 keV. The normalized H mode confinement time was 0.95. Second harmonic tritium heating produced energetic tritons above the critical energy. This scheme heats the electrons in JET, unlike in ITER where the lower power density will allow mainly ion heating. The inverted scenario of tritium minority ICRH in a deuterium plasma was demonstrated as a successful heating method producing both suprathermal neutrons and bulk ion heating. Theoretical calculations of the DT reactivity mostly give excellent agreement with the measured reaction rates

    Understanding the behavior of advanced high-strength steels using atom probe tomography

    Get PDF
    The key evidence for understanding the mechanical behavior of advanced high strength steels was provided by atom probe tomography (APT). Chemical overstabilization of retained austenite (RA) leading to the limited transformation-induced plasticity (TRIP) effect was deemed to be the main factor responsible for the low ductility of nanostructured bainitic steel. Appearance of the yield point on the stress-strain curve of prestrained and bake-hardened transformationinduced plasticity steel is due to the unlocking from weak carbon atmospheres of newly formed during prestraining dislocations

    Physical Properties and Chemical Content of Canine Femoral Cortical Bone in Nutritional Osteopenia its Reversibility and the Effect of Fluoride

    No full text
    corecore