Light environment and Seasonal Dynamics of Microalgae in the Annual Sea Ice at Terra Nova Bay, Ross Sea, Antarctica

We investigated the physical conditions of the Spring pack ice environment at Terra Nova Bay to understand their influence on the structure and physiology of sympagic microalgae. Bio-optical methods were used to study the availability and spectral quality of solar radiation, both inside and underneath the ice cover. Pack ice thickness was around 2.5 m, with a temperature between -2 and -7°C. On average, only 1.4% of surface PAR penetrated to the bottom ice and less than 0.6% below platelet ice level. Surface UV-B radiation under the bottom ice was 0.2-0.4%. Biomass concentrations up to 2400 mg Chl a m-3, dominated by two species of diatoms (Entomoneis kjellmannii and Nitschia cf. stellata), showed marked spatial and temporal patterns. Maximum values were in the platelet ice during the first half of November, and in the bottom ice two weeks later. Strong shade adaptation characteristics emerged clearly and explained the relevant abundance of microalgae within the sea ice, with specific absorption coefficients (a*) as low as 0.005 m2 (mg Chl a)-1 and the photo-acclimation index (Ek) in the range of in situ irradiance. The biomass specific production values were low, around 0.12-0.13 mg C mg Chl a-1 h-1. The hypothesis suggesting bottom ice colonization by platelet ice microalgae is supported here

Experimental determination of the permeability of engineering textiles: Benchmark II

In this second international permeability benchmark, the in-plane permeability values of a carbon fabric were studied by twelve research groups worldwide. One participant also investigated the deformation of the tested carbon fabric. The aim of this work was to obtain comparable results in order to make a step toward standardization of permeability measurements. Unidirectional injections were thus conducted to determine the unsaturated in-plane permeability tensor of the fabric. Procedures used by participants were specified in the guidelines defined for this benchmark. Participants were asked to use the same values for parameters such as fiber volume fraction, injection pressure and fluid viscosity to minimize sources of scatter. The comparison of the results from each participant was encouraging. The scatter between data obtained while respecting the guidelines was below 25%. However, a higher dispersion was observed when some parameters differed from the recommendations of this exercise.The authors are grateful to J.M. Beraud from Hexcel Fabrics for his support that made possible this exercise. The contributions of J.B. Alms, N.C. Correia, S. Advani, E. Ruiz and P.C.T. Goncalves to the preparation of the guidelines document and templates are acknowledged by the participants of this benchmark.Vernet, N.; Ruiz, E.; Advani, S.; Alms, JB.; Aubert, M.; Barburski, M.; Barari, B.... (2014). Experimental determination of the permeability of engineering textiles: Benchmark II. Composites Part A: Applied Science and Manufacturing. 61:172-184. doi:10.1016/j.compositesa.2014.02.010S1721846

Experimental characterisation of textile compaction response: A benchmark exercise

This paper reports the results of an international benchmark exercise on the measurement of fibre bed compaction behaviour. The aim was to identify aspects of the test method critical to obtain reliable results and to arrive at a recommended test procedure for fibre bed compaction measurements. A glass fibre 2/2 twill weave and a biaxial (±45°) glass fibre non-crimp fabric (NCF) were tested in dry and wet conditions. All participants used the same testing procedure but were allowed to use the testing frame, the fixture and sample geometry of their choice. The results showed a large scatter in the maximum compaction stress between participants at the given target thickness, with coefficients of variation ranging from 38% to 58%. Statistical analysis of data indicated that wetting of the specimen significantly affected the scatter in results for the woven fabric, but not for the NCF. This is related to the fibre mobility in the architectures in both fabrics. As isolating the effect of other test parameters on the results was not possible, no statistically significant effect of other test parameters could be proven. The high sensitivity of the recorded compaction pressure near the minimum specimen thickness to changes in specimen thickness suggests that small uncertainties in thickness can result in large variations in the maximum value of the compaction stress. Hence, it is suspected that the thickness measurement technique used may have an effect on the scatter

Numerical prediction and experimental characterisation of meso-scale-voids in liquid composite moulding

International audienc

Erkennung von Leckagen an FVK-Hochleistungsstrukturbauteilen

Thermografie ermöglicht es Temperaturen an Bauteilen nicht nur punktuell sondern auch global zu erfassen. Im Stader Forschungsautoklaven BALU wird durch den Einsatz der Technologie eine Erhöhung der Informationsdichte innerhalb des Aushärteprozesses erreicht, die nicht nur zur Verbesserung der Prozessüberwachung sondern auch zur Leckageerkennung eingesetzt werden kann