Facet recovery and light emission from GaN/InGaN/GaN core-shell structures grown by metal organic vapour phase epitaxy on etched GaN nanorod arrays

The use of etched nanorods from a planar template as a growth scaffold for a highly regular GaN/InGaN/GaN core-shell structure is demonstrated. The recovery of m-plane non-polar facets from etched high-aspect-ratio GaN nanorods is studied with and without the introduction of a hydrogen silsesquioxane passivation layer at the bottom of the etched nanorod arrays. This layer successfully prevented c-plane growth between the nanorods, resulting in vertical nanorod sidewalls (∼89.8°) and a more regular height distribution than re-growth on unpassivated nanorods. The height variation on passivated nanorods is solely determined by the uniformity of nanorod diameter, which degrades with increased growth duration. Facet-dependent indium incorporation of GaN/InGaN/GaN core-shell layers regrown onto the etched nanorods is observed by high-resolution cathodoluminescence imaging. Sharp features corresponding to diffracted wave-guide modes in angle-resolved photoluminescence measurements are evidence of the uniformity of the full core-shell structure grown on ordered etched nanorods

Increasing Maximum Gain in InAs Quantum Dot Lasers on GaAs and Si

InAs quantum-dot (QD) lasers emitting at 1300nm with nominally undoped and modulated p-type doping are studied. Modal-gain measurements indicate a higher gain can be achieved from the ground-state for a given Fermi-level separation with p-doping and a reduced temperature-dependence of threshold current for short-cavity lasers

Quantum well engineering in InGaN/GaN core-shell nanorod structures

We report the ability to control relative InN incorporation in InGaN/GaN quantum wells (QWs) grown on the semi-polar and non-polar facets of a core-shell nanorod LED structure by varying the growth conditions. A study of the cathodoluminescence emitted from series of structures with different growth temperatures and pressures for the InGaN QW layer revealed that increasing the growth pressure had the effect of increasing InN incorporation on the semi-polar facets, while increasing the growth temperature improves the uniformity of light emission from the QWs on the non-polar facets

Optical properties and resonant cavity modes in axial InGaN/GaN nanotube microcavities

Microcavities based on group-III nitride material offer a notable platform for the investigation of light-matter interactions as well as the development of devices such as high efficiency light emitting diodes (LEDs) and low-threshold nanolasers. Disk or tube geometries in particular are attractive for low-threshold lasing applications due to their ability to support high finesse whispering gallery modes (WGMs) and small modal volumes. In this article we present the fabrication of homogenous and dense arrays of axial InGaN/GaN nanotubes via a combination of displacement Talbot lithography (DTL) for patterning and inductively coupled plasma top-down dry-etching. Optical characterization highlights the homogeneous emission from nanotube structures. Power-dependent continuous excitation reveals a non-uniform light distribution within a single nanotube, with vertical confinement between the bottom and top facets, and radial confinement within the active region. Finite-difference time-domain simulations, taking into account the particular shape of the outer diameter, indicate that the cavity mode of a single nanotube has a mixed WGM-vertical Fabry-Perot mode (FPM) nature. Additional simulations demonstrate that the improvement of the shape symmetry and dimensions primarily influence the Q-factor of the WGMs whereas the position of the active region impacts the coupling efficiency with one or a family of vertical FPMs. These results show that regular arrays of axial InGaN/GaN nanotubes can be achieved via a low-cost, fast and large-scale process based on DTL and top-down etching. These techniques open a new perspective for cost effective fabrication of nano-LED and nano-laser structures along with bio-chemical sensing applications

Structural and optical emission uniformity of m-plane InGaN single quantum wells in core-shell nanorods

Controlling the long-range homogeneity of core-shell InGaN/GaN layers is essential for their use in light-emitting devices. This paper demonstrates variations in optical emission energy as low as ~7 meV.µm-1 along the m-plane facets from core-shell InGaN/GaN single quantum wells as measured through high-resolution cathodoluminescence hyperspectral imaging. The layers were grown by metal organic vapor phase epitaxy on etched GaN nanorod arrays with a pitch of 2 µm. High-resolution transmission electron microscopy and spatially-resolved energy-dispersive X-ray spectroscopy measurements demonstrate a long-range InN-content and thickness homogeneity along the entire 1.2 μm length of the m-plane. Such homogeneous emission was found on the m-plane despite the observation of short range compositional fluctuations in the InGaN single quantum well. The ability to achieve this uniform optical emission from InGaN/GaN core-shell layers is critical to enable them to compete with and replace conventional planar light-emitting devices

Cathodoluminescence hyperspectral imaging of nitride core-shell structures

In this work, we demonstrate the use of hyperspectral CL in the evaluation of periodic arrays of GaN/InxGa1-xN core-shell nanorods. These were fabricated using a top-down approach, in which columns are formed from a GaN template using nano-imprint lithography and ICP etching, followed by MOCVD regrowth [2]. The formation of quantum wells (QWs) on the mplane sidewall facets offers a route to avoiding the detrimental electric fields associated with LEDs grown on the c-plane, while the use of periodic features has the potential to improve light extraction and directionality

Strong photonic crystal behavior in regular arrays of core-shell and quantum disc InGaN/GaN nanorod light-emitting diodes

We show that arrays of emissive nanorod structures can exhibit strong photonic crystal behavior, via observations of the far-field luminescence from core-shell and quantum disc InGaN/GaN nanorods. The conditions needed for the formation of directional Bloch modes characteristic of strong photonic behavior are found to depend critically upon the vertical shape of the nanorod sidewalls. Index guiding by a region of lower volume-averaged refractive index near the base of the nanorods creates a quasi-suspended photonic crystal slab at the top of the nanorods which supports Bloch modes. Only diffractive behavior could be observed without this region. Slab waveguide modelling of the vertical structure shows that the behavioral regime of the emissive nanorod arrays depends strongly upon the optical coupling between the nanorod region and the planar layers below. The controlled crossover between the two regimes of photonic crystal operation enables the design of photonic nanorod structures formed on planar substrates that exploit either behavior depending on device requirements