Physical Properties of Metallic Antiferromagnetic CaCo{1.86}As2 Single Crystals

We report studies of CaCo{1.86}As2 single crystals. The electronic structure is probed by angle-resolved photoemission spectroscopy (ARPES) measurements of CaCo{1.86}As2 and by full-potential linearized augmented-plane-wave calculations for the supercell Ca8Co15As16 (CaCo{1.88}As2). Our XRD crystal structure refinement is consistent with the previous combined refinement of x-ray and neutron powder diffraction data showing a collapsed-tetragonal ThCr2Si2-type structure with 7(1)% vacancies on the Co sites corresponding to the composition CaCo{1.86}As2 [D. G. Quirinale et al., Phys. Rev. B 88, 174420 (2013)]. The anisotropic magnetic susceptibility chi(T) data are consistent with the magnetic neutron diffraction data of Quirianale et al. that demonstrate the presence of A-type collinear antiferromagnetic order below the Neel temperature TN = 52(1) K with the easy axis being the tetragonal c axis. However, no clear evidence from the resistivity rho(T) and heat capacity Cp(T) data for a magnetic transition at TN is observed. A metallic ground state is demonstrated from band calculations and the rho(T), Cp(T) and ARPES data, and spin-polarized calculations indicate a competition between the A-type AFM and FM ground states. The Cp(T) data exhibit a large Sommerfield electronic coefficient reflecting a large density of states at the Fermi energy D(EF), consistent with the band structure calculations which also indicate a large D(EF) arising from Co 3d bands. At 1.8 K the M(H) data for H|| c exhibit a well-defined first-order spin-flop transition at an applied field of 3.5 T. The small ordered moment of 0.3 muB/Co obtained from the M(H) data at low T, the large exchange enhancement of chi and the lack of a self-consistent interpretation of the chi(T) and M(H,T) data in terms of a local moment Heisenberg model together indicate that the magnetism of CaCo{1.86}As2 is itinerant.Comment: 18 pages, 15 figures, 4 tables, 61 references; v2: extended the fits of experimental data by additional electronic structure calculations; published versio

Surface stress and lattice dynamics in oxide ultrathin films

The lattice misfit between the substrate and an epitaxial film leads in general to static forces, which define the interface stress, and dynamic responses that modify the thin-film lattice dynamics. Although these are both fundamental concepts that are important for film growth and thin-film properties, they have not been investigated in a combined way so far. Therefore, herein, surface stress experiments in combination with surface phonon studies for three different, cubic oxide ultrathin film systems are reviewed. Within the class of binary oxides, NiO(001) grown on Ag(001) is chosen, which exhibits a -2.2% lattice mismatch, and BaO(001) on Pt(001), a system with a negligible lattice mismatch. For the ternary oxides, perovskite thin films of BaTiO3 grown epitaxially on Pt(001) with a lattice mismatch of -2.3% are focused upon. The surface stress experiments are conducted with an optical two-beam curvature technique under in situ growth conditions. Surface and thin-film phonons are determined by high-resolution electron energy loss spectroscopy. Surface stress and lattice dynamics are discussed in the range from the oxide monolayer to thin films of about 20 unit cell in thickness

Electrical detection of picosecond acoustic pulses in vertical transport devices with nanowires

Picosecond acoustic pulses, generated in a thin aluminum transducer, are injected into semiconductor vertical transport devices consisting of core-shell GaAsP nanowires. The acoustic pulses induce current pulses in the device with amplitude ∼1 μA. The spectrum of the electrical response is sensitive to the elastic properties of the device and has a frequency cutoff at ∼10 GHz. This work shows the potential of the technique for studies the elastic properties of complex semiconductor nanodevices.Peer reviewe

Ba{1-x}KxMn2As2: An Antiferromagnetic Local-Moment Metal

The compound BaMn2As2 with the tetragonal ThCr2Si2 structure is a local-moment antiferromagnetic insulator with a Neel temperature TN = 625 K and a large ordered moment mu = 3.9 mu_B/Mn. We demonstrate that this compound can be driven metallic by partial substitution of Ba by K, while retaining the same crystal and antiferromagnetic structures together with nearly the same high TN and large mu. Ba_{1-x}K_xMn2As2 is thus the first metallic ThCr2Si2-type MAs-based system containing local 3d transition metal M magnetic moments, with consequences for the ongoing debate about the local moment versus itinerant pictures of the FeAs-based superconductors and parent compounds. The Ba_{1-x}K_xMn2As2 class of compounds also forms a bridge between the layered iron pnictides and cuprates and may be useful to test theories of high Tc superconductivity.Comment: 5 two-column typeset pages, 5 figures, 20 references; v2: minor revisions, 4 new references, published versio

Exotic Kondo crossover in a wide temperature region in the topological Kondo insulator SmB6 revealed by high-resolution ARPES

Temperature dependence of the electronic structure of SmB6 is studied by high-resolution ARPES down to 1 K. We demonstrate that there is no essential difference for the dispersions of the surface states below and above the resistivity saturating anomaly (~ 3.5 K). Quantitative analyses of the surface states indicate that the quasi-particle scattering rate increases linearly as a function of temperature and binding energy, which differs from Fermi-Liquid behavior. Most intriguingly, we observe that the hybridization between the d and f states builds gradually over a wide temperature region (30 K < T < 110 K). The surface states appear when the hybridization starts to develop. Our detailed temperature-dependence results give a complete interpretation of the exotic resistivity result of SmB6, as well as the discrepancies among experimental results concerning the temperature regions in which the topological surface states emerge and the Kondo gap opens, and give new insights into the exotic Kondo crossover and its relationship with the topological surface states in the topological Kondo insulator SmB6.Comment: 8 pages, 5 figure

Ni+-irradiated InGaAs/GaAs quantum wells: picosecond carrier dynamics

Room-temperature carrier dynamics as functions of heavy-ion implantation and subsequent thermal annealing were investigated for technologically important InGaAs/GaAs quantum wells (QWs) by means of a time-resolved up-conversion method. Sub-picosecond lifetimes were achieved at 10 MeV Ni+ doses of (20-50) x 1010 ions cm-2. The decay rates reached a maximum at the highest irradiation dose, yielding the shortest lifetime of the confined QW states of 600 fs. A simple theoretical model is proposed for the photodynamics of the carriers. The relaxation rate depended on the irradiation dose according to a power law of 1.2, while the irradiated and subsequently annealed samples exhibited a power law of 0.35. The results are qualitatively interpreted.Room-temperature carrier dynamics as functions of heavy-ion implantation and subsequent thermal annealing were investigated for technologically important InGaAs/GaAs quantum wells (QWs) by means of a time-resolved up-conversion method. Sub-picosecond lifetimes were achieved at 10 MeV Ni+ doses of (20-50) x 1010 ions cm-2. The decay rates reached a maximum at the highest irradiation dose, yielding the shortest lifetime of the confined QW states of 600 fs. A simple theoretical model is proposed for the photodynamics of the carriers. The relaxation rate depended on the irradiation dose according to a power law of 1.2, while the irradiated and subsequently annealed samples exhibited a power law of 0.35. The results are qualitatively interpreted.Room-temperature carrier dynamics as functions of heavy-ion implantation and subsequent thermal annealing were investigated for technologically important InGaAs/GaAs quantum wells (QWs) by means of a time-resolved up-conversion method. Sub-picosecond lifetimes were achieved at 10 MeV Ni+ doses of (20-50) x 1010 ions cm-2. The decay rates reached a maximum at the highest irradiation dose, yielding the shortest lifetime of the confined QW states of 600 fs. A simple theoretical model is proposed for the photodynamics of the carriers. The relaxation rate depended on the irradiation dose according to a power law of 1.2, while the irradiated and subsequently annealed samples exhibited a power law of 0.35. The results are qualitatively interpreted.Peer reviewe

Evaluating assumptions of scales for subjective assessment of thermal environments – Do laypersons perceive them the way, we researchers believe?

People's subjective response to any thermal environment is commonly investigated by using rating scales describing the degree of thermal sensation, comfort, and acceptability. Subsequent analyses of results collected in this way rely on the assumption that specific distances between verbal anchors placed on the scale exist and that relationships between verbal anchors from different dimensions that are assessed (e.g. thermal sensation and comfort) do not change. Another inherent assumption is that such scales are independent of the context in which they are used (climate zone, season, etc.). Despite their use worldwide, there is indication that contextual differences influence the way the scales are perceived and therefore question the reliability of the scales’ interpretation. To address this issue, a large international collaborative questionnaire study was conducted in 26 countries, using 21 different languages, which led to a dataset of 8225 questionnaires. Results, analysed by means of robust statistical techniques, revealed that only a subset of the responses are in accordance with the mentioned assumptions. Significant differences appeared between groups of participants in their perception of the scales, both in relation to distances of the anchors and relationships between scales. It was also found that respondents’ interpretations of scales changed with contextual factors, such as climate, season, and language. These findings highlight the need to carefully consider context-dependent factors in interpreting and reporting results from thermal comfort studies or post-occupancy evaluations, as well as to revisit the use of rating scales and the analysis methods used in thermal comfort studies to improve their reliability

The Scales Project, a cross-national dataset on the interpretation of thermal perception scales

Thermal discomfort is one of the main triggers for occupants’ interactions with components of the built environment such as adjustments of thermostats and/or opening windows and strongly related to the energy use in buildings. Understanding causes for thermal (dis-)comfort is crucial for design and operation of any type of building. The assessment of human thermal perception through rating scales, for example in post-occupancy studies, has been applied for several decades; however, long-existing assumptions related to these rating scales had been questioned by several researchers. The aim of this study was to gain deeper knowledge on contextual influences on the interpretation of thermal perception scales and their verbal anchors by survey participants. A questionnaire was designed and consequently applied in 21 language versions. These surveys were conducted in 57 cities in 30 countries resulting in a dataset containing responses from 8225 participants. The database offers potential for further analysis in the areas of building design and operation, psycho-physical relationships between human perception and the built environment, and linguistic analyses