888 research outputs found
101: High-dose chemotherapy with autologous stem cell transplantation in 61 patients with light chain amyloidosis A single centre experience
Accelerated lifetime testing and failure analysis of quartz based GaAs planar Schottky diodes
Accelerated lifetime tests have been performed on integrated planar GaAs Schottky diodes that were bonded to quartz substrates upside-down with a heat-cured epoxy. Results at 175°C, 200°C, and 240°C were analyzed using the Arrhenius-lognormal model. These tests predict a room temperature MTTF of 3x10^8 hours, a value that is comparable to conventional high-frequency planar Schottky diodes. This result demonstrates that the use of an appropriate epoxy to obtain GaAs devices on quartz substrates does not significantly reduce the lifetime of the devices
Resumption of elective orthopaedic surgery in the us epicenter of covid-19
© 2020 Krauss et al. On March 1, 2020, New York State confirmed its first case of COVID-19. This state has had the largest initial mortality in the United States with more than 479,000 confirmed cases and over 25,000 deaths as of October 10, 2020. All elective surgeries in New York State were suspended on March 23, 2020, due to the national state of emergency. Syosset Hospital is a 75-bed community hospital dedicated primarily to elective surgery. During the COVID-19 surge, the hospital was converted to provide needed beds for the treatment of COVID-19 illness. In anticipation of the resumption of urgent elective procedures, this hospital became one of the two designated sites within the Northwell Health system to be “non-COVID.” Once the hospital was emptied of all inpatients, a complete and thorough cleaning and disinfection was performed on the entire building. All equipment was thoroughly decontaminated following Centers for Disease Control and Prevention (CDC) guidelines. In anticipation of the resumption of elective surgery, each surgeon evaluated their cancelled case list to determine patient priority, based on a scale of 1 (elective, non-urgent), 2 (semi-urgent), 3 (urgent), to 4 (highly urgent). Site-specific disaster credentialing was expedited so that emergent surgeries could be performed by surgeons located at other Northwell sites. To ensure a structured and informative onboarding process, each visiting surgeon received a “welcome” email which requested pertinent information to facilitate the surgical process. Presurgical, surgical, and postoperative protocols were revised based on federal and local guidance and regulations. Resumption of elective surgery post COVID-19 placed the hospital into uncharted territory
Dilemmas concerning heart procurement in controlled donation after circulatory death
With an expanding population at risk for heart failure and the resulting increase in patients admitted to the waiting list for heart transplantation, the demand of viable organs exceeds the supply of suitable donor hearts. Use of hearts after circulatory death has reduced this deficit. Two primary techniques for heart procurement in circulatory death donors have been described: direct procurement and perfusion and thoraco-abdominal normothermic regional perfusion. While the former has been accepted as an option for heart procurement in circulatory death donors, the latter technique has raised some ethical questions in relation to the dead donor rule. In this paper we discuss the current dilemmas regarding these heart procurement protocols in circulatory death donors.</p
High-resolution three-dimensional imaging radar
A three-dimensional imaging radar operating at high frequency e.g., 670 GHz, is disclosed. The active target illumination inherent in radar solves the problem of low signal power and narrow-band detection by using submillimeter heterodyne mixer receivers. A submillimeter imaging radar may use low phase-noise synthesizers and a fast chirper to generate a frequency-modulated continuous-wave (FMCW) waveform. Three-dimensional images are generated through range information derived for each pixel scanned over a target. A peak finding algorithm may be used in processing for each pixel to differentiate material layers of the target. Improved focusing is achieved through a compensation signal sampled from a point source calibration target and applied to received signals from active targets prior to FFT-based range compression to extract and display high-resolution target images. Such an imaging radar has particular application in detecting concealed weapons or contraband
Physical and Biogeochemical Studies in the Subtropical and Tropical Atlantic
Maria S. Merian Cruise Report MSM18/L2
Cruise No. 18, Leg 2
May 11 – June 19, 2011
Mindelo (Cape Verde Islands) – Mindelo (Cape Verde Islands
Circulation and Oxygen Distribution in the Tropical Atlantic Cruise No. 80, Leg 1; October 26 to November 23, 2009 Mindelo (Cape Verde) to Mindelo (Cape Verde)
METEOR cruise 80/1 was a contribution to the SFB 754 “Climate-Biogeochemistry Interactions in the Tropical Ocean”. Shipboard, glider and moored observations are used to study the temporal and spatial variability of physical and biogeochemical parameters within the oxygen minimum zone (OMZ) of the tropical North Atlantic. As part of the BMBF “Nordatlantik” project, it further focuses on the equatorial current system including the Equatorial Undercurrent (EUC) and intermediate currents below. During the cruise, hydrographic station observations were performed using a CTD/O2 rosette, including water sampling for salinity, oxygen, nutrients and other biogeochemical tracers. Underway current measurements were successfully carried out with the 75 kHz ADCP borrowed from R/V POSEIDON during the first part of the cruise, and R/V METEOR’s 38 kHz ADCP during the second part. During M80/1, an intensive mooring program was carried out with 8 mooring recoveries and 8 mooring deployments. Right at the beginning of the cruise, a multidisciplinary mooring near the Cape Verde Islands was recovered and redeployed. Within the framework of SFB 754, two moorings with CTD/O2 profilers were recovered and redeployed with other instrumentation in the center and at the southern rim of the OMZ of the tropical North Atlantic. The equatorial mooring array as part of BMBF “North Atlantic” project consists of 5 current meter moorings along 23°W between 2°S and 2°N. It is aimed at quantifying the variability of the thermocline water supply toward the equatorial cold tongue which develops east of 10°W during boreal summer. Several glider missions were
performed during the cruise. One glider was recovered that was deployed two months earlier. Another glider was deployed for two short term missions, near the equator for about 8 days and near 8°N for one day. This glider was equipped with a new microstructure probe in addition to
standard sensors, i.e. CTD/O2, chlorophyll and turbidity
Minimizing Induced Drag with Weight Distribution, Lift Distribution, Wingspan, and Wing-Structure Weight
Because the wing-structure weight required to support the critical wing section bending moments is a function of wingspan, net weight, weight distribution, and lift distribution, there exists an optimum wingspan and wing-structure weight are presented for rectangular wings with four different sets of design constraints. These design constraints are fixed lift distribution and net weight combined with 1) fixed maximum stress and wing loading, 2) fixed maximum deflection and wing loading, 3) fixed maximum stress and stall speed and 4) fixed maximum deflection and stall speed. For each of these analytic solutions, the optimum wing-structure weight is found to depend only on the net weight, independent of the arbitrary fixed lift distribution. Analytic solutions for optimum weight and lift distributions are also presented for the same four sets of design constraints. Depending on the design constraints, the optimum lift distribution can differ significantly from the elliptic lift distribution. Solutions for two example wing designs are presented, which demonstrate how the induced drag varies with lift distribution, wingspan, and wing-structure weight in the design space near the optimum solution. Although the analytic solutions presented here are restricted to rectangular wings, these solutions provide excellent test cases for verifying numerical algorithms used for more general multidisciplinary analysis and optimization
- …