Surface induced magnetization reversal of MnP nanoclusters embedded in GaP

We investigate the quasi-static magnetic behavior of ensembles of non-interacting ferromagnetic nanoparticles consisting of MnP nanoclusters embedded in GaP(001) epilayers grown at 600, 650 and 700{\deg}C. We use a phenomenological model, in which surface effects are included, to reproduce the experimental hysteresis curves measured as a function of temperature (120-260 K) and direction of the applied field. The slope of the hysteresis curve during magnetization reversal is determined by the MnP nanoclusters size distribution, which is a function of the growth temperature. Our results show that the coercive field is very sensitive to the strength of the surface anisotropy, which reduces the energy barrier between the two states of opposite magnetization. Notably, this reduction in the energy barrier increases by a factor of 3 as the sample temperature is lowered from 260 to 120 K.Comment: 7 pages, 5 figure

Implications and consequences of ferromagnetism universally exhibited by inorganic nanoparticles

Occurrence of surface ferromagnetism in inorganic nanoprticles as a universal property not only explains many of the unusual magnetic features of oxidic thin films, but also suggests its possible use in creating new materials, as exemplified by multiferroic BaTiO3 nanoparticles. While the use of Mn-doped ZnO and such materials in spintronics appears doubtful, it is possible to have materials exhibiting coexistence of (bulk) superconductivity with (surface) ferromagnetism.Comment: 11 pages, 3 figures, 1 tabl

Optical Conductivity of Manganites: Crossover from Jahn-Teller Small Polaron to Coherent Transport in the Ferromagnetic State

We report on the optical properties of the hole-doped manganites Nd_{0.7}Sr _{0.3}MnO_{3}, La_{0.7}Ca_{0.3}MnO_{3}, and La_{0.7}Sr_{0.3}MnO_{3}. The low-energy optical conductivity in the paramagnetic-insulating state of these materials is characterized by a broad maximum near 1 eV. This feature shifts to lower energy and grows in optical oscillator strength as the temperature is lowered into the ferromagnetic state. It remains identifiable well below Tc and transforms eventually into a Drude-like response. This optical behavior and the activated transport in the paramagnetic state of these materials are consistent with a Jahn-Teller small polaron. The optical spectra and oscillator strength changes compare well with models that include both double exchange and the dynamic Jahn-Teller effect in the description of the electronic structure.Comment: 27 pages (Latex), 6 figures (PostScript

First-principles study of the inversion thermodynamics and electronic structure of FeM2X4 (thio)spinels (M = Cr, Mn, Co, Ni; X = O, S)

FeM2X4 spinels, where M is a transition metal and X is oxygen or sulfur, are candidate materials for spin filters, one of the key devices in spintronics. We present here a computational study of the inversion thermodynamics and the electronic structure of these (thio)spinels for M = Cr, Mn, Co, Ni, using calculations based on the density functional theory with on-site Hubbard corrections (DFT+U). The analysis of the configurational free energies shows that different behaviour is expected for the equilibrium cation distributions in these structures: FeCr2X4 and FeMn2S4 are fully normal, FeNi2X4 and FeCo2S4 are intermediate, and FeCo2O4 and FeMn2O4 are fully inverted. We have analyzed the role played by the size of the ions and by the crystal field stabilization effects in determining the equilibrium inversion degree. We also discuss how the electronic and magnetic structure of these spinels is modified by the degree of inversion, assuming that this could be varied from the equilibrium value. We have obtained electronic densities of states for the completely normal and completely inverse cation distribution of each compound. FeCr2X4, FeMn2X4, FeCo2O4 and FeNi2O4 are half-metals in the ferrimagnetic state when Fe is in tetrahedral positions. When M is filling the tetrahedral positions, the Cr-containing compounds and FeMn2O4 are half-metallic systems, while the Co and Ni spinels are insulators. The Co and Ni sulfide counterparts are metallic for any inversion degree together with the inverse FeMn2S4. Our calculations suggest that the spin filtering properties of the FeM2X4 (thio)spinels could be modified via the control of the cation distribution through variations in the synthesis conditions

Enhanced magnetic properties in ZnCoAlO caused by exchangecoupling to Co nanoparticles

We report the results of a sequence of magnetisation and magneto-optical studies on laser ablated thin films of ZnCoAlO and ZnCoO that contain a small amount of metallic cobalt. The results are compared to those expected when all the magnetization is due to isolated metallic clusters of cobalt and with an oxide sample that is almost free from metallic inclusions. Using a variety of direct magnetic measurements and also magnetic circular dichroism we find that there is ferromagnetism within both the oxide and the metallic inclusions, and furthermore that these magnetic components are exchange-coupled when aluminium is included. This enhances both the coercive field and the remanence. Hence the presence of a controlled quantity of metallic nanoparticles in ZnAlO can improve the magnetic response of the oxide, thus giving great advantages for applications in spintronics

Evolutionary remodelling of N-terminal domain loops fine-tunes SARS-CoV-2 spike

The emergence of SARS-CoV-2 variants has exacerbated the COVID-19 global health crisis. Thus far, all variants carry mutations in the spike glycoprotein, which is a critical determinant of viral transmission being responsible for attachment, receptor engagement and membrane fusion, and an important target of immunity. Variants frequently bear truncations of flexible loops in the N-terminal domain (NTD) of spike; the functional importance of these modifications has remained poorly characterised. We demonstrate that NTD deletions are important for efficient entry by the Alpha and Omicron variants and that this correlates with spike stability. Phylogenetic analysis reveals extensive NTD loop length polymorphisms across the sarbecoviruses, setting an evolutionary precedent for loop remodelling. Guided by these analyses, we demonstrate that variations in NTD loop length, alone, are sufficient to modulate virus entry. We propose that variations in NTD loop length act to fine-tune spike; this may provide a mechanism for SARS-CoV-2 to navigate a complex selection landscape encompassing optimisation of essential functionality, immune-driven antigenic variation and ongoing adaptation to a new host

Preparation, magnetic properties and microstructure of lean rare-earth permanent magnetic materials

Abstract Nanocrystalline, lean rare-earth composite alloys around the nominal composition Nd Tb Fe Co B were prepared by various techniques, such as melt-spinning, melt-extraction, splat cooling and mechanically alloying. The Tb and Co content have been found to be crucial in these alloys for achieving high coercivities, up to 500 kA/m. A typical value for the remanence is 1.05}1.10 T. No crystallographic texture was observed, thus, the remanence enhancement was obtained by the spring magnet behavior. The best results have been found when using amorphous precursors and fairly high heating rates during the annealing treatment in an infrared furnace. The amount of Tb could be reduced which yields a lower coercivity but a higher remanence was obtained. TEM and MoK ssbauer analysis was carried out to determine the volume fraction of soft and hard phases. Optimized magnets contained typically a homogeneous nanocrystalline microstructure of about 50 vol% hard magnetic phase and about 50 vol% soft magnetic -Fe plus (Fe,Co) B with a narrow grain size distribution. The addition of Si or Nb and Cu improved the microstructure and the magnetic properties. Bonded magnets produced from optimized lean rare-earth magnetic powders show an improved corrosion resistance compared to magnets with higher rare-earth content. 2000 Elsevier Science B.V. All rights reserved. PACS: 61.16.Bg; 61.10.Eq; 61.18.Fs; 75.50.Ww; 81.05.Ys; 81.4

Low carbon technology performance vs infrastructure vulnerability: Analysis through the local and global properties space

Renewable energy technologies, necessary for low-carbon infrastructure networks, are being adopted to help reduce fossil fuel dependence and meet carbon mitigation targets. The evolution of these technologies has progressed based on the enhancement of technology-specific performance criteria, without explicitly considering the wider system (global) impacts. This paper presents a methodology for simultaneously assessing local (technology) and global (infrastructure) performance, allowing key technological interventions to be evaluated with respect to their effect on the vulnerability of wider infrastructure systems. We use exposure of low carbon infrastructure to critical material supply disruption (criticality) to demonstrate the methodology. A series of local performance changes are analyzed; and by extension of this approach, a method for assessing the combined criticality of multiple materials for one specific technology is proposed. Via a case study of wind turbines at both the material (magnets) and technology (turbine generators) levels, we demonstrate that analysis of a given intervention at different levels can lead to differing conclusions regarding the effect on vulnerability. Infrastructure design decisions should take a systemic approach; without these multilevel considerations, strategic goals aimed to help meet low-carbon targets, that is, through long-term infrastructure transitions, could be significantly jeopardized

Convalescent plasma in patients admitted to hospital with COVID-19 (RECOVERY): a randomised controlled, open-label, platform trial

Background: Many patients with COVID-19 have been treated with plasma containing anti-SARS-CoV-2 antibodies. We aimed to evaluate the safety and efficacy of convalescent plasma therapy in patients admitted to hospital with COVID-19. Methods: This randomised, controlled, open-label, platform trial (Randomised Evaluation of COVID-19 Therapy [RECOVERY]) is assessing several possible treatments in patients hospitalised with COVID-19 in the UK. The trial is underway at 177 NHS hospitals from across the UK. Eligible and consenting patients were randomly assigned (1:1) to receive either usual care alone (usual care group) or usual care plus high-titre convalescent plasma (convalescent plasma group). The primary outcome was 28-day mortality, analysed on an intention-to-treat basis. The trial is registered with ISRCTN, 50189673, and ClinicalTrials.gov, NCT04381936. Findings: Between May 28, 2020, and Jan 15, 2021, 11558 (71%) of 16287 patients enrolled in RECOVERY were eligible to receive convalescent plasma and were assigned to either the convalescent plasma group or the usual care group. There was no significant difference in 28-day mortality between the two groups: 1399 (24%) of 5795 patients in the convalescent plasma group and 1408 (24%) of 5763 patients in the usual care group died within 28 days (rate ratio 1·00, 95% CI 0·93–1·07; p=0·95). The 28-day mortality rate ratio was similar in all prespecified subgroups of patients, including in those patients without detectable SARS-CoV-2 antibodies at randomisation. Allocation to convalescent plasma had no significant effect on the proportion of patients discharged from hospital within 28 days (3832 [66%] patients in the convalescent plasma group vs 3822 [66%] patients in the usual care group; rate ratio 0·99, 95% CI 0·94–1·03; p=0·57). Among those not on invasive mechanical ventilation at randomisation, there was no significant difference in the proportion of patients meeting the composite endpoint of progression to invasive mechanical ventilation or death (1568 [29%] of 5493 patients in the convalescent plasma group vs 1568 [29%] of 5448 patients in the usual care group; rate ratio 0·99, 95% CI 0·93–1·05; p=0·79). Interpretation: In patients hospitalised with COVID-19, high-titre convalescent plasma did not improve survival or other prespecified clinical outcomes. Funding: UK Research and Innovation (Medical Research Council) and National Institute of Health Research