93 research outputs found
Selection criteria for pile diameter in seismic areas
According to modern seismic codes such as Eurocode 8, pile foundations in earthquake-prone areas must resist two different, yet simultaneous bending actions resulting from kinematic and inertial interaction. Due to the different nature of the two demands, pile must resist seismic actions following different patters, thus leading to different design requirements. In this work, analytical solutions are presented to define maximum and a minimum pile diameters required to resist kinematic and inertial effects in an essentially elastic manner, respectively. It is shown that the range of admissible diameters decreases with decreasing soil stiffness and with increasing design acceleration, collapsing into a single admissible diameter for certain problem configurations. Regions where no pile diameter can guarantee elastic response during strong seismic shaking are identified
A simple method for N-M interaction diagrams of circular reinforced concrete cross sections
A novel analytical method is derived for the ultimate capacity interaction diagram (i.e., axial compression, N - bending moment resistance, M) of reinforced concrete (RC) columns with circular cross section. To this aim, the longitudinal rebar arrangement is replaced with a thin steel ring equivalent to the total steel area; moreover, according to modern design approaches, simplified stress–strain relationships for concrete and reinforcing steel are used. Illustrative applications demonstrate that the ultimate capacity computed by the proposed analytical approach agrees well with the results obtained by rigorous methods based on consolidated numerical algorithms. The new solution allows for a rapid, accurate assessment of circular cross section capacity by means of hand calculations; this is especially useful at the conceptual design stage of various structural and geotechnical systems. The method can be easily extended to more general configurations, such as multiple steel rings and composite concrete-steel sections
Failure envelopes of pile groups under combined axial-moment loading: Theoretical background and experimental evidence
Abstract The problem of failure envelopes of pile groups subjected to vertical and eccentric load is investigated both theoretically and experimentally. A critical review of literature works on failure envelopes for pile groups under combined axial-moment loading is first provided. Emphasis is placed on a recent, exact solution derived from theorems of limit analysis by idealizing piles as uniaxial rigid-perfectly plastic elements. The application of the relevant equations over a practical range of problems needs only the axial capacities in compression and uplift of the isolated piles. An intense program of centrifuge experiments carried out along with different load paths on annular shaped pile groups aimed at validating the equations pertinent to the above solution is presented and discussed. The endpoints of the load paths followed in the centrifuge lie approximately above the analytical failure envelope, giving confidence that the reference equations can be reliably adopted to assess the capacity of a pile group under combined axial-moment loading. Finally, the kinematics of the collapse mechanism observed experimentally is compared to that determined from the application of the reference theory
Failure envelopes of pile groups under combined axial-moment loading: Theoretical background and experimental evidence
The problem of failure envelopes of pile groups subjected to vertical and eccentric load is investigated both theoretically and experimentally. A critical review of literature works on failure envelopes for pile groups under combined axial-moment loading is first provided. Emphasis is placed on a recent, exact solution derived from theorems of limit analysis by idealizing piles as uniaxial rigid-perfectly plastic elements. The application of the relevant equations over a practical range of problems needs only the axial capacities in compression and uplift of the isolated piles. An intense program of centrifuge experiments carried out along with different load paths on annular shaped pile groups aimed at validating the equations pertinent to the above solution is presented and discussed. The endpoints of the load paths followed in the centrifuge lie approximately above the analytical failure envelope, giving confidence that the reference equations can be reliably adopted to assess the capacity of a pile group under combined axial-moment loading. Finally, the kinematics of the collapse mechanism observed experimentally is compared to that determined from the application of the reference theory
Recommended from our members
Experimental investigation of kinematic pile bending in layered soils using dynamic centrifuge modelling
This research provides an insight into the previously unexplored aspects of kinematic pile bending, especially for large-intensity earthquakes where the soil behaviour is highly non-linear. In this study, a series of dynamic centrifuge experiments was conducted on pile foundations embedded in a two-layered soil profile to investigate the kinematic effects on pile foundations during model earthquakes. A single pile and a closely spaced 3 × 1 row pile group were used as model pile foundations, and the soil model consisted of a soft clay underlain by dense sand. It was observed that the peak kinematic pile bending moment occurs slightly beneath the interface of the soil layers and this depth is larger for the pile group compared to a single pile. Also, the piles in a group attract lower bending moments but carry larger residual kinematic pile bending moments compared to a single pile. Furthermore, the elastic solutions available in the literature for estimating the kinematic pile bending moments are shown to yield satisfactory results only for small-intensity earthquakes, but vastly underestimate for large-intensity earthquakes, if methods are applied injudiciously. The importance of considering soil non-linearity effects and accurate determination of shear strain at the interface of layered soils during large-intensity earthquakes for a reliable assessment of kinematic pile bending moment from methods in the literature is demonstrated using dynamic centrifuge test data. </jats:p
Malignant otitis externa in the antibiotic resistance era: key to successful treatment
Malignant otitis externa in the antibiotic resistance era: key to successful treatment. Objective: Malignant
otitis externa (MOE) is a rare aggressive, necrotizing infection of the external auditory canal and the temporal bone.
MOE may have a poor prognosis when it is not treated promptly and adequately. It is most commonly reported in males,
older individuals, patients with diabetes, or patients that are immunocompromised. Pseudomonas aeruginosa is the main
pathogenic agent involved. This study aimed to evaluate a clinical series of patients with MOE and discuss the current
literature on the topic.
Methodology: This retrospective study included 8 patients with MOE that were evaluated and treated, medically and/
or surgically, at the University Hospital of Ferrara between January 2012 and December 2016. We retrieved data from
medical records on the clinical history, imaging, and treatment.
Results: In all cases, a microbiological examination disclosed the presence of P. aeruginosa. The infection was eventually
controlled in all cases, after a median of 6 months of therapy. All patients were followed-up for an average of 12 months
after infection resolution.
Conclusion: Currently, no specific guidelines for MOE treatment are available in the literature. Based on our findings, we
proposed a diagnostic and therapeutic flow-chart for managing this infection
Centrifuge modelling of the behaviour of pile groups under vertical eccentric load
Annular shaped pile groups are a very common foundation layout for onshore wind turbines and other slender structures. In this study, their performance under vertical loads of moderate to high eccentricity, including moment rotation response and bearing capacity, was investigated by centrifuge testing on small scale physical models embedded in kaolin clay. To identify experimentally the capacity of the examined pile groups under different load paths, the model foundations were loaded monotonically until a clear collapse mechanism was achieved. The testing procedure and the proposed interpretation methodology can be easily adapted to load paths or pile layouts other than those considered in the current study. The experimental data can be adopted as a useful benchmark for mathematical models aimed at predicting the response of pile groups to complex load paths. The results of this testing program can also be used to assess the degree of conservatism of current methods adopted by industry for the design of piled foundations subjected to eccentric loads
Pile design in seismic areas: Small or large diameter?
This work investigates the role of pile diameter in resisting seismic actions, with reference to two example subsoils, namely a dry sand and a fully saturated NC clay. After a ground response analysis in free-field conditions for different values of peak rock acceleration, mobilized soil stiffness and surface acceleration are used as ingredients for assessing the kinematic and inertial moment in a concrete pile. An optimum pile diameter is identified as the one that, while guaranteeing safety, corresponds to the minimum cost. It is also proven that, with a constant value of reinforcement area and length, increasing pile diameter (i.e. increasing safety factor and cost) leads rapidly to failure. Likewise, if pile reinforcement is designed only for inertial action, increasing pile diameter is severely detrimental
FILTERING EFFECT FOR A PILE IN TWO-LAYER SOIL
The aim of this work is to investigate the kinematic response of fixed-head vertical floating piles embedded in two layer soils with shallow interfaces and subjected to upward-propagating seismic waves. The problem is explored numerically by means of a rigorous finite element analysis, to quantify the kinematically-induced reduction of the horizontal free-field spectral acceleration. Insight about the beneficial role of the stiffer layer is provided
- …