Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET

The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR

On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection

A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)

Relationship of edge localized mode burst times with divertor flux loop signal phase in JET

A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM

Search for patterns by combining cosmic-ray energy and arrival directions at the Pierre Auger Observatory

Energy-dependent patterns in the arrival directions of cosmic rays are searched for using data of the Pierre Auger Observatory. We investigate local regions around the highest-energy cosmic rays with E > = 6×1019 eV by analyzing cosmic rays with energies above E > = 5×1018 eV arriving within an angular separation of approximately 15°. We characterize the energy distributions inside these regions by two independent methods, one searching for angular dependence of energy-energy correlations and one searching for collimation of energy along the local system of principal axes of the energy distribution. No significant patterns are found with this analysis. The comparison of these measurements with astrophysical scenarios can therefore be used to obtain constraints on related model parameters such as strength of cosmic-ray deflection and density of point sources

Removal of recovery boiler fireside deposits by thermal shedding

Copyright Pulp & Paper Canada. Reprinted with permission from Annex Business Media.Recovery boiler fireside deposits are occassionaly removed by thermal shedding, which rapidly cools the boiler to cause deposits to contract, crack, and be readily blown off by sootblowers. A laboratory study on deposit thermal expansion and two field studies on the effectiveness of thermal shedding have led to development of a new shedding procedure, which requires less boiler downtime. but still achieves the same deposit removal efficiency with minimal damage to boiler tubes.This work is part of the research on plugging and unplugging recovery ery boilers, jointly supported by Babcock & Wilcox Company, Champion International Corporation, Irving Pulp and Paper Limited, James River Corporation, Skeena Cellulose, Westvaco Corporation, Weyerhaeuser Company, and the Ontario Ministry of Colleges and Universities through its URIF program

Removal of recovery boiler fireside deposits by thermal shedding

Copyright Pulp & Paper Canada. Reprinted with permission from Annex Business Media.Recovery boiler fireside deposits are occassionaly removed by thermal shedding, which rapidly cools the boiler to cause deposits to contract, crack, and be readily blown off by sootblowers. A laboratory study on deposit thermal expansion and two field studies on the effectiveness of thermal shedding have led to development of a new shedding procedure, which requires less boiler downtime. but still achieves the same deposit removal efficiency with minimal damage to boiler tubes.This work is part of the research on plugging and unplugging recovery ery boilers, jointly supported by Babcock & Wilcox Company, Champion International Corporation, Irving Pulp and Paper Limited, James River Corporation, Skeena Cellulose, Westvaco Corporation, Weyerhaeuser Company, and the Ontario Ministry of Colleges and Universities through its URIF program

Impact of nitrogen seeding on confinement and power load control of a high-triangularity JET ELMy H-mode plasma with a metal wall

This paper reports the impact on confinement and power load of the high-shape 2.5MA ELMy H-mode scenario at JET of a change from an all carbon plasma facing components to an all metal wall. In preparation to this change, systematic studies of power load reduction and impact on confinement as a result of fuelling in combination with nitrogen seeding were carried out in JET-C and are compared to their counterpart in JET with a metallic wall. An unexpected and significant change is reported on the decrease of the pedestal confinement but is partially recovered with the injection of nitrogen.Comment: 30 pages, 16 figure