836 research outputs found

    Breakdown of Scaling in the Nonequilibrium Critical Dynamics of the Two-Dimensional XY Model

    Full text link
    The approach to equilibrium, from a nonequilibrium initial state, in a system at its critical point is usually described by a scaling theory with a single growing length scale, ξ(t)t1/z\xi(t) \sim t^{1/z}, where z is the dynamic exponent that governs the equilibrium dynamics. We show that, for the 2D XY model, the rate of approach to equilibrium depends on the initial condition. In particular, ξ(t)t1/2\xi(t) \sim t^{1/2} if no free vortices are present in the initial state, while ξ(t)(t/lnt)1/2\xi(t) \sim (t/\ln t)^{1/2} if free vortices are present.Comment: 4 pages, 3 figure

    Tuning of metal-insulator transition of two-dimensional electrons at parylene/SrTiO3_3 interface by electric field

    Full text link
    Electrostatic carrier doping using a field-effect-transistor structure is an intriguing approach to explore electronic phases by critical control of carrier concentration. We demonstrate the reversible control of the insulator-metal transition (IMT) in a two dimensional (2D) electron gas at the interface of insulating SrTiO3_3 single crystals. Superconductivity was observed in a limited number of devices doped far beyond the IMT, which may imply the presence of 2D metal-superconductor transition. This realization of a two-dimensional metallic state on the most widely-used perovskite oxide is the best manifestation of the potential of oxide electronics

    Residual Stress, Mechanical Behavior and Electrical Properties of Cu/Nb Thin-Film Multilayers

    Full text link
    Effect of compositional wavelength (modulation) on residual stress, electrical resistivities and mechanical properties of Cu/Nb thin-film multilayers sputtered onto single-crystal Si substrates, was evaluated. Electrical resistivities were measured down to 4 K using a standard 4-point probe. Differential specimen curvature was used to determine residual stress, and a microprobe was used to obtain hardness and elastic modulus. Profilometry, ion-beam analysis and TEM were used. Hardness of the Cu-Nb multilayers increased with decreasing compositional wavelength so that the layered structures had hardness values in excess of either constituent and the hardness predicted by the rule of mixtures. A peak in net residual compressive stress of the multilayers was observed at a compositional wavelength of 100 nm. No resistivity plateau was observed within the composition wavelength range studied

    Geophysical monitoring of simulated homicide burials for forensic investigations

    Get PDF
    Finding hidden bodies, believed to have been murdered and buried, is problematic, expensive in terms of human resource and currently has low success rates for law enforcement agencies. Here we present, for the first time, ten years of multidisciplinary geophysical monitoring of simulated clandestine graves using animal analogues. Results will provide forensic search teams with crucial information on optimal detection techniques, equipment configuration and datasets for comparison to active and unsolved cold case searches. Electrical Resistivity (ER) surveys showed a naked burial produced large, low-resistivity anomalies for up to four years, but then the body became difficult to image. A wrapped burial had consistent small, high-resistivity anomalies for four years, then large high-resistivity anomalies until the survey period end. Ground Penetrating Radar (GPR) 110-900 MHz surveys showed the wrapped burial could be detected throughout. 225 MHz GPR data was optimal, but the naked burial was poorly imaged after six years. Results suggested conducting both ER and GPR surveys if the burial style was unknown when searching for interred remains. Surveys in winter and spring produced the best datasets, and, as post-burial time increases, surveying in these seasons became increasingly important. This multidisciplinary study provides critical new insights for law enforcement and families of the disappeared worldwide

    Semblance analysis to assess GPR data from a five-year forensic study of simulated clandestine graves

    Get PDF
    Ground penetrating radar (GPR) surveys have proven useful for locating clandestine graves in a number of forensic searches. There has been extensive research into the geophysical monitoring of simulated clandestine graves in different burial scenarios and ground conditions. Whilst these studies have been used to suggest optimum dominant radar frequencies, the data themselves have not been quantitatively analysed to-date. This study uses a common-offset configuration of semblance analysis, both to characterise velocity trends from GPR diffraction hyperbolae and, since the magnitude of a semblance response is proportional to signal-to-noise ratio, to quantify the strength of a forensic GPR response. 2D GPR profiles were acquired over a simulated clandestine burial, with a wrapped-pig cadaver monitored at three-month intervals between 2008 and 2013 with GPR antennas of three different centre-frequencies (110, 225 and 450 MHz). The GPR response to the cadaver was a strong diffraction hyperbola. Results show, in contrast to resistivity surveys, that semblance analysis show little sensitivity to changes attributable to decomposition, and only a subtle influence of seasonality: velocity increases (0.01–0.02 m/ns) were observed in summer, associated with a decrease (5–10%) in peak semblance magnitude, SM, and potentially in the reflectivity of the cadaver. The lowest-frequency antennas consistently gave the highest signal-to-noise ratio although the grave was nonetheless detectable by all frequencies trialled. These observations suggest that forensic GPR surveys could be undertaken with little seasonal hindrance. Whilst GPR analysis cannot currently provide a quantitative diagnostic proxy for time-since-burial, the consistency of responses suggests that graves will remain detectable beyond the five years shown here

    Curved Tails in Polymerization-Based Bacterial Motility

    Full text link
    The curved actin ``comet-tail'' of the bacterium Listeria monocytogenes is a visually striking signature of actin polymerization-based motility. Similar actin tails are associated with Shigella flexneri, spotted-fever Rickettsiae, the Vaccinia virus, and vesicles and microspheres in related in vitro systems. We show that the torque required to produce the curvature in the tail can arise from randomly placed actin filaments pushing the bacterium or particle. We find that the curvature magnitude determines the number of actively pushing filaments, independent of viscosity and of the molecular details of force generation. The variation of the curvature with time can be used to infer the dynamics of actin filaments at the bacterial surface.Comment: 8 pages, 2 figures, Latex2

    Analysing Change: Complex Rather than Dialectical?

    Get PDF
    The file attached to this record is the author's final peer reviewed version. The Publisher's final version can be found by following the DOI link.This article offers a discussion of dialectics from a complexity perspective. Dialectics is a term much utilized but infrequently defined. This article suggests that a spectrum of ideas exist concerning understandings of dialectics. We are particularly critical of Hegelian dialectics, which we see as anthropocentric and teleological. While Marxist approaches to dialectics, in the form of historical materialism, marked a break from the idealist elements of Hegelian dialectics, they retained traces of this approach. The article offers a partial discussion of essential elements of dialectics, which we consider to be the analysis of change, the centrality of contradiction, and the methodology of abstraction. Points of overlap with complexity thinking are highlighted, together with those points where complexity thinking and dialectical approaches diverge. We conclude with some suggestions as to how complexity thinking might contribute to a development of dialectical approaches

    Placenta-Like Structure of the Aphid Endoparasitic Wasp Aphidius ervi: A Strategy of Optimal Resources Acquisition

    Get PDF
    Aphidius ervi (Hymenoptera: Braconidae) is an entomophagous parasitoid known to be an effective parasitoid of several aphid species of economic importance. A reduction of its production cost during mass rearing for inundative release is needed to improve its use in biological control of pests. In these contexts, a careful analysis of its entire development phases within its host is needed. This paper shows that this parasitoid has some characteristics in its embryological development rather complex and different from most other reported insects, which can be phylogenetically very close. First, its yolkless egg allows a high fecundity of the female but force them to hatch from the egg shell rapidly to the host hemocoel. An early cellularisation allowing a rapid differentiation of a serosa membrane seems to confirm this hypothesis. The serosa wraps the developing embryo until the first instar larva stage and invades the host tissues by microvilli projections and form a placenta like structure able to divert host resources and allowing nutrition and respiration of embryo. Such interspecific invasion, at the cellular level, recalls mammal's trophoblasts that anchors maternal uterine wall and underlines the high adaptation of A. ervi to develop in the host body
    corecore