202 research outputs found
Monitoring DC anode current of a grounded-cathode photomultiplier tube
Abstract The Pierre Auger Observatories (PAO) for the highest energy cosmic rays will make use of both the Cherenkov and Air Fluorescence techniques. Surface Detectors (SD) and Fluorescence Detectors (FD) will have to operate in a desert-type environment during at least 15 years. In order to avoid dust deposition, due to electrostatics, and other practical inconveniences derived from biasing the cathode with a negative potential, the 15 000 PMTs of the FD will operate in the grounded cathode configuration. Despite the fact that the anodes will remain at high voltage with respect to ground, the DC anode current, which varies with background light, will have to be recorded. We have developed a current monitoring system based on a novel optocoupled feedback circuit that allows sensitive, linear, and temperature-independent measurements of the DC anode current. A distinctive feature of this circuit is that it uses optical coupling between passive components at high voltage and active components near the ground potential. This represents a substantial improvement over classical solutions which require the supply of power to an active circuit at high voltage. We report on the first tests performed with both active and passive biasing networks which demonstrate the validity of this new method
A Water Tank Cerenkov Detector for Very High Energy Astroparticles
Extensive airshower detection is an important issue in current astrophysics
endeavours. Surface arrays detectors are a common practice since they are easy
to handle and have a 100% duty cycle. In this work we present an experimental
study of the parameters relevant to the design of a water Cerenkov detector for
high energy airshowers. This detector is conceived as part of the surface array
of the Pierre Auger Project, which is expected to be sensitive to ultra high
energy cosmic rays. In this paper we focus our attention in the geometry of the
tank and its inner liner material, discussing pulse shapes and charge
collections.Comment: Accepted in Nucl. Instr. and Meth. A, LaTex 18 pages, 7 figure
Electronic structure of superconducting graphite intercalate compounds: The role of the interlayer state
Although not an intrinsic superconductor, it has been long--known that, when
intercalated with certain dopants, graphite is capable of exhibiting
superconductivity. Of the family of graphite--based materials which are known
to superconduct, perhaps the most well--studied are the alkali metal--graphite
intercalation compounds (GIC) and, of these, the most easily fabricated is the
CK system which exhibits a transition temperature K. By increasing the alkali metal concentration (through high pressure
fabrication techniques), the transition temperature has been shown to increase
to as much as K in CNa. Lately, in an important recent
development, Weller \emph{et al.} have shown that, at ambient conditions, the
intercalated compounds \cyb and \cca exhibit superconductivity with transition
temperatures K and K respectively, in excess
of that presently reported for other graphite--based compounds. We explore the
architecture of the states near the Fermi level and identify characteristics of
the electronic band structure generic to GICs. As expected, we find that charge
transfer from the intercalant atoms to the graphene sheets results in the
occupation of the --bands. Yet, remarkably, in all those -- and only
those -- compounds that superconduct, we find that an interlayer state, which
is well separated from the carbon sheets, also becomes occupied. We show that
the energy of the interlayer band is controlled by a combination of its
occupancy and the separation between the carbon layers.Comment: 4 Figures. Please see accompanying experimental manuscript
"Superconductivity in the Intercalated Graphite Compounds C6Yb and C6Ca" by
Weller et a
Contribution to the understanding of tribological properties of graphite intercalation compounds with metal chloride
Intrinsic tribological properties of lamellar compounds are usually attributed to the presence of van der Waals gaps in their structure through which interlayer interactions are weak. The controlled variation of the distances and interactions between graphene layers by intercalation of electrophilic species in graphite is used in order to explore more deeply the friction reduction properties of low-dimensional compounds. Three graphite intercalation compounds with antimony pentachloride, iron trichloride and aluminium trichloride are studied. Their tribological properties are correlated to their structural parameters, and the interlayer interactions are deduced from ab initio bands structure calculations
Search for an annual modulation of dark-matter signals with a germanium spectrometer at the Sierra Grande Laboratory
Data collected during three years with a germanium spectrometer at the Sierra
Grande underground laboratory have been analyzed for distinctive features of
annual modulation of the signal induced by WIMP dark matter candidates. The
main motivation for this analysis was the recent suggestion by the DAMA/NaI
Collaboration that a yearly modulation signal could not be rejected at the 90%
confidence level when analyzing data obtained with a high-mass low-background
scintillator detector. We performed two different analyses of the data: First,
the statistical distribution of modulation-significance variables (expected
from an experiment running under the conditions of Sierra Grande) was compared
with the same variables obtained from the data. Second, the data were analyzed
in energy bins as an independent check of the first result and to allow for the
possibility of a crossover in the expected signal. In both cases no
statistically significant deviation from the null result was found, which could
support the hypothesis that the data contain a modulated component. A plot is
also presented to enable the comparison of these results to those of the DAMA
collaboration.Comment: New version accepted by Astroparticle Physics. Changes suggested by
the referee about the theoretical prediction of rates are included.
Conclusions remain unaffected. 14 pages, LaTeX, 7 figures. Uses epsfig macr
Superconductivity in the Intercalated Graphite Compounds C6Yb and C6Ca
In this letter we report the discovery of superconductivity in the
isostructural graphite intercalation compounds C6Yb and C6Ca, with transition
temperatures of 6.5K and 11.5K respectively. A structural characterisation of
these compounds shows them to be hexagonal layered systems in the same class as
other graphite intercalates. If we assume that all the outer s-electrons are
transferred from the intercalant to the graphite sheets, then the charge
transfer in these compounds is comparable to other superconducting graphite
intercalants such as C8K 1,2 . However, the superconducting transition
temperatures of C6Yb and C6Ca are up to two orders of magnitude greater.
Interestingly, superconducting upper critical field studies and resistivity
measurements suggest that these compounds are significantly more isotropic than
pure graphite. This is unexpected as the effect of introducing the intercalant
is to move the graphite layer further apart.Comment: 2 Figures. Please see accompanying theoretical manuscript,
"Electronic Structure of the Superconducting Graphite Intercalates" by Csanyi
et al., cond-mat/050356
Homologous Recombination Is Stimulated by a Decrease in dUTPase in Arabidopsis
Deoxyuridine triphosphatase (dUTPase) enzyme is an essential enzyme that protects DNA against uracil incorporation. No organism can tolerate the absence of this activity. In this article, we show that dUTPase function is conserved between E. coli (Escherichia coli), yeast (Saccharomyces cerevisiae) and Arabidopsis (Arabidopsis thaliana) and that it is essential in Arabidopsis as in both micro-organisms. Using a RNA interference strategy, plant lines were generated with a diminished dUTPase activity as compared to the wild-type. These plants are sensitive to 5-fluoro-uracil. As an indication of DNA damage, inactivation of dUTPase results in the induction of AtRAD51 and AtPARP2, which are involved in DNA repair. Nevertheless, RNAi/DUT1 constructs are compatible with a rad51 mutation. Using a TUNEL assay, DNA damage was observed in the RNAi/DUT1 plants. Finally, plants carrying a homologous recombination (HR) exclusive substrate transformed with the RNAi/DUT1 construct exhibit a seven times increase in homologous recombination events. Increased HR was only detected in the plants that were the most sensitive to 5-fluoro-uracils, thus establishing a link between uracil incorporation in the genomic DNA and HR. Our results show for the first time that genetic instability provoked by the presence of uracils in the DNA is poorly tolerated and that this base misincorporation globally stimulates HR in plants
Cross-domain interference costs during concurrent verbal and spatial serial memory tasks are asymmetric
Some evidence suggests that memory for serial order is domain-general. Evidence also points to asymmetries in interference between verbal and visual-spatial tasks. We confirm that concurrently remembering verbal and spatial serial lists provokes substantial interference compared with remembering a single list, but we further investigate the impact of this interference throughout the serial position curve, where asymmetries are indeed apparent. A concurrent verbal order memory task affects spatial memory performance throughout the serial positions of the list, but performing a spatial order task affects memory for the verbal serial list only for early list items; in the verbal task only, the final items are unaffected by a concurrent task. Adding suffixes eliminates this asymmetry, resulting in impairment throughout the list for both tasks. These results suggest that domain-general working memory resources may be supplemented with resources specific to the verbal domain, but perhaps not with equivalent spatial resources
- âŠ