Fabrication of an in-plane SU-8 cantilever with integrated strain gauge for wall shear stress measurements in fluid flows.

We present a cantilever fabricated from the polymer SU-8 for the measurement of wall shear stress in fluid flows. The pressure induced deflection of the cantilever, measured using a calibrated and integrated nichrome strain gauge, can be related to the wall shear stress on the surface. The initial degree of curvature of the cantilever can be controlled via the exposure dose, which allows a small positive deflection to be achieved, and so minimises the intrusion into the flow. Wind tunnel testing results show a sensitivity greater than 2.5 mV/Pa, with a shear stress of 0.38 Pa and excitation of 1 V

ESTIMATING THE STOCK OF GLASS EELS IN AN ESTUARY BY MARK-RECAPTURE EXPERIMENTS USING VITAL DYES

Glass eels (Anguilla anguilla) arriving after the fishing season in the Vilaine estuary (France) were caught by boat and at a trapping ladder located at a blocking dam upstream in the estuary. They were marked with Bismarck brown, rhodamine B or neutral red, and released into the estuary. The effect of marking on behaviour, mortality and recapture differed according to the dye and concentration used. The glass eels also differed in response to marking according to their origin. Estuarine glass eels were clearly desynchronized in their selective tidal stream transport and left the release area after a few tidal cycles. Trapped glass eels were less sensitive to marking. They remained in the release area and were recaptured in larger number both in the trapping ladder and in the estuary. These results supported a model of two behavioral fractions in the estuary: flow-carried migrants and active glass eels with stronger rheotactic behaviour. The proportion of active glass eels in the estuary shifted from none for the two weeks after the fishery closure, to 10% value of the total stock. At the trapping ladder, the migration ended in June each year, while a large stock was still present in the estuary. These observations favour the interpretation of a short duration of the active phase at this site followed by the transition towards a more benthic behavior. The daily efficiency of the trapping ladder was calculated as 4% of the active stock from both stock estimations and average recapture rate. This value was consistent with the low annual efficiency of the trapping ladder, calculated as 30% of the estuarine stock of glass eels that arrived after the fishing season

Quadratic BSDEs driven by a continuous martingale and application to utility maximization problem

In this paper, we study a class of quadratic Backward Stochastic Differential Equations (BSDEs) which arises naturally when studying the problem of utility maximization with portfolio constraints. We first establish existence and uniqueness results for such BSDEs and then, we give an application to the utility maximization problem. Three cases of utility functions will be discussed: the exponential, power and logarithmic ones

Une synthèse des modèles de représentation des connaissances à base de Graphes Conceptuels et OWL

Nous présentons et comparons deux approches de modélisation, formelles et concrètes, pour représenter et manipuler des connaissances d’un domaine. Le modèle des graphes conceptuels permet de modéliser des connaissances en terme de graphes, basés sur un support. Cette approche de modélisation est intensionnelle, est munie d’une sémantique en logique du premier ordre, et fait l’hypothèse d’un monde fermé pour ses raisonnements. Le langage OWL permet de décrire des ontologies et des faits sur le Web, suivant une approche de modélisation extensionnelle. Il possède une sémantique issue des logiques de descriptions, et fait l’hypothèse d’un monde ouvert pour ses raisonnements

SafeSlice: A model slicing and design safety inspection tool for SysML

Software safety certification involves checking that the software design meets the (software) safety requirements. In practice, inspections are one of the primary vehicles for ensuring that safety requirements are satisfied by the design. Unless the safety-related aspects of the design are clearly delineated, the inspections conducted by safety assessors would have to consider the entire design, although only small fragments of the design may be related to safety. In a model-driven development context, this means that the assessors have to browse through large models, understand them, and identify the safety-related fragments. This is time-consuming and error-prone, specially noting that the assessors are often third-party regulatory bodies who were not involved in the design. To address this problem, we describe in this paper a prototype tool called, SafeSlice, that enables one to automatically extract the safety-related slices (fragments) of design models. The main enabler for our slicing technique is the traceability between the safety requirements and the design, established by following a structured design methodology that we propose. Our work is grounded on SysML, which is being increasingly used for expressing the design of safety-critical systems. We have validated our work through two case studies and a control experiment which we briefly outline in the paper. © 2011 ACM

Zinc Oxide Nanowires Deposited on Polymeric Hotplates for Low-power Gas Sensors

Zinc oxides (ZnO) nanowires were successfully deposited on plastic low-power micro-hotplates using the thermal oxidation technique. Metallic zinc layer was deposited on the sensing transducer by RF magnetron sputtering and then oxidized in a controlled atmosphere in order to obtain ZnO nanostructures. Morphological investigations confirmed the nanometric dimensions of the fabricated nanostructures. The n-type behavior of the nanostructured material was evaluated towards different chemical species to highlight the electrical properties of the materials. Calibration curves for the detection of several chemical species were defined. © 2012 The Authors. Published by Elsevier Ltd

Analytical solution of a model for complex food webs

We investigate numerically and analytically a recently proposed model for food webs [Nature {\bf 404}, 180 (2000)] in the limit of large web sizes and sparse interaction matrices. We obtain analytical expressions for several quantities with ecological interest, in particular the probability distributions for the number of prey and the number of predators. We find that these distributions have fast-decaying exponential and Gaussian tails, respectively. We also find that our analytical expressions are robust to changes in the details of the model.Comment: 4 pages (RevTeX). Final versio

Assessing architectural evolution: A case study

This is the post-print version of the Article. The official published can be accessed from the link below - Copyright @ 2011 SpringerThis paper proposes to use a historical perspective on generic laws, principles, and guidelines, like Lehman’s software evolution laws and Martin’s design principles, in order to achieve a multi-faceted process and structural assessment of a system’s architectural evolution. We present a simple structural model with associated historical metrics and visualizations that could form part of an architect’s dashboard. We perform such an assessment for the Eclipse SDK, as a case study of a large, complex, and long-lived system for which sustained effective architectural evolution is paramount. The twofold aim of checking generic principles on a well-know system is, on the one hand, to see whether there are certain lessons that could be learned for best practice of architectural evolution, and on the other hand to get more insights about the applicability of such principles. We find that while the Eclipse SDK does follow several of the laws and principles, there are some deviations, and we discuss areas of architectural improvement and limitations of the assessment approach