A parametric study of motor starting for a 2- to 10-kilowatt Brayton power system

A study of the motor starting of a Brayton cycle power system was conducted to provide estimates of system sensitivity to several controllable parameters. These sensitivity estimates were used as a basis for selection of an optimum motor-start scheme to be implemented on the 2- to 10-kilowatt Brayton power system designed and presently under test. The studies were conducted with an analog simulation of the Brayton power system and covered a range of frequencies from 400 Hz (33 percent design) to 1200 Hz (design), voltage-to-frequency ratios of 0.050 (50 percent design) to 0.100 (design), turbine-inlet temperatures of 800 K (1440 R, 70 percent design) to 1140 K (2060 deg R, design), and prestart pressure levels of 14.5 psia to 29.0 psia. These studies have shown the effect of selected system variables on motor starting. The final selection of motor-start variables can therefore be made on the basis of motor-start inverter complexity, battery size and weight, desired steady-state pressure level after startup, and other operational limitations. In general, the study showed the time required for motor starting to be inversely proportional to motor frequency, voltage, turbine-inlet temperature, and pressure level. An increase in any of these parameters decreases startup time

Suppression of vortex channeling in meandered YBa2Cu3O7-d grain boundaries

We report on the in-plane magnetic field (H) dependence of the critical current density (Jc) in meandered and planar single grain boundaries (GBs) isolated in YBa2Cu3O7-d (YBCO) coated conductors. The Jc(H)properties of the planar GB are consistent with those previously seen in single GBs of YBCO films grown on SrTiO3 bi-crystals. In the straight boundary a characteristic flux channeling regime when H is oriented near the GB plane, associated with a reduced Jc, is seen. The meandered GB does not show vortex channeling since it is not possible for a sufficient length of vortex line to lie within it.Comment: Submitted to AP

Destination Online Communication: Why Less is Sometimes More. A Study of Online Communications of English Destinations

This research investigates the relationship between Web site design and the Web site end-user experience of a vast number of English tourism destinations, both local and regional ones. Following recent research in the field, this paper evaluates destinations' online communication based on the implemented Web site features and on the effectiveness of the communication itself, borrowing its research methodology from different domains. After content and functionality analysis, a user-experience, scenario-based investigation has been carried out, which demonstrated that complex Web sites do not always serve end-users' needs properly; in other words, Web site complexity is not directly related with good user experience. This research may help destination managers to foster their online communication if they have fewer content and functionalities but are better focused and clearly user-oriented. © 2014 Taylor & Francis

Motor starting techniques for the 2 to 15 kW Brayton space power system

Motor starting techniques for 2-15 kW Brayton space power syste

Cu_{2}O as nonmagnetic semiconductor for spin transport in crystalline oxide electronics

We probe spin transport in Cu_{2}O by measuring spin valve effect in La_{0.7}Sr_{0.3}MnO_{3}/Cu_{2}O/Co and La_{0.7}Sr_{0.3}MnO_{3}/Cu_{2}O/La_{0.7}Sr_{0.3}MnO_{3} epitaxial heterostructures. In La_{0.7}Sr_{0.3}MnO_{3}/Cu_{2}O/Co systems we find that a fraction of out-of-equilibrium spin polarized carrier actually travel across the Cu_{2}O layer up to distances of almost 100 nm at low temperature. The corresponding spin diffusion length dspin is estimated around 40 nm. Furthermore, we find that the insertion of a SrTiO_{3} tunneling barrier does not improve spin injection, likely due to the matching of resistances at the interfaces. Our result on dspin may be likely improved, both in terms of Cu_{2}O crystalline quality and sub-micrometric morphology and in terms of device geometry, indicating that Cu_{2}O is a potential material for efficient spin transport in devices based on crystalline oxides.Comment: 15 pages, 10 figure

Superconducting magnesium diboride films on Silicon with Tc0 about 24K grown via vacuum annealing from stoichiometric precursors

Superconducting magnesium diboride films with Tc0 ~ 24 K and sharp transition \~ 1 K were successfully prepared on silicon substrates by pulsed laser deposition from a stoichiometric MgB2 target. Contrary to previous reports, anneals at 630 degree and a background of 2x10^(-4) torr Ar/4%H2 were performed without the requirement of Mg vapor or an Mg cap layer. This integration of superconducting MgB2 films on silicon may thus prove enabling in superconductor-semiconductor device applications. Images of surface morphology and cross-section profiles by scanning electron microscopy (SEM) show that the films have a uniform surface morphology and thickness. Energy dispersive spectroscopy (EDS) reveals these films were contaminated with oxygen, originating either from the growth environment or from sample exposure to air. The oxygen contamination may account for the low Tc for those in-situ annealed films, while the use of Si as the substrate does not result in a decrease in Tc as compared to other substrates.Comment: 5 pages, 4 figures, 15 references; due to file size limit, images were blure

Nitrogen fixation in the Mediterranean Sea

The Mediterranean Sea is an oligotrophic basin characterized by low nutrient levels and unusually high NO3/PO4 molar ratios in the deeper layers, that reach the maximum (N/P = 28) in the Eastern Mediterranean. An external nitrogen source needs to be claimed in order to explain the nitrogen excess. Pantoja et al. (2002) found that the 15N/14N natural abundance in particulate and in dissolved inorganic nitrogen display low values, suggesting an important role of a "light" nitrogen source. Two hypotheses can be invoked: (i) nitrogen compounds from atmospheric deposition and/or(ii)atmospheric molecular nitrogen throughout nitrogen fixation . During TRANSMED oceanographic cruise carried out in the framework of Italian project VECTOR(June 2007), N2 fixation experiments have been carried out all over the Mediterranean Sea and outside the Gibraltar Strait. Surprisingly, very low rates (< 0.10 nmol N2*l-1*d-1) have been observed in different areas of the basin, while higher values have been observed in Atlantic Ocean according with literature data. These preliminary results suggest a major role for nitrogen atmospheric deposition in shaping the NO3/PO4 anomaly of the basin. Pantoja, S., D. J. Repeta, J. P. Sachs, and D. M. Sigman (2002). Stable isotope constraints on the nitrogen cycle of the Mediterranean Sea water column, Deep Sea Res., Part I, 4, 1609- 1621

Processing and properties of ferroelectric relaxor lead scandium tantalate Pb(Sc1/2Ta1/2)O3 thin films

Thin films of Pb(Sc1/2Ta1/2)O3 (PST) were fabricated using an optimized chemical solution deposition procedure involving the de-hydration of scandium acetate and the addition of up to 30% excess lead in solution. The choice of substrate was found to impact the thermal induced stress in the films as confirmed by wafer bending and in-plane grazing angle x-ray diffraction measurements. The presence of either a compressive or a tensile in-plane stress led to a reduction in the temperature of the dielectric maximum, whereas the value of the dielectric maximum remained relatively unchanged; its value reduced by an order of magnitude compared with ceramic samples. It is concluded that mechanical stress alone is not the sole factor in the reduction of PST thin film permittivity. Microstructural features resulting from processing induced defects or an incomplete transformation to the relaxor state may be responsible for this commonly observed phenomeno