A study of poultry processing plant noise characteristics and potential noise control techniques

The noise environment in a typical poultry processing plant was characterized by developing noise contours for two representative plants: Central Soya of Athens, Inc., Athens, Georgia, and Tip Top Poultry, Inc., Marietta, Georgia. Contour information was restricted to the evisceration are of both plants because nearly 60 percent of all process employees are stationed in this area during a normal work shift. Both plant evisceration areas were composed of tile walls, sheet metal ceilings, and concrete floors. Processing was performed in an assembly-line fashion in which the birds travel through the area on overhead shackles while personnel remain at fixed stations. Processing machinery was present throughout the area. In general, the poultry processing noise problem is the result of loud sources and reflective surfaces. Within the evisceration area, it can be concluded that only a few major sources (lung guns, a chiller component, and hock cutters) are responsible for essentially all direct and reverberant sound pressure levels currently observed during normal operations. Consequently, any effort to reduce the noise problem must first address the sound power output of these sources and/or the absorptive qualitities of the room

Computational Design of Chemical Nanosensors: Metal Doped Carbon Nanotubes

We use computational screening to systematically investigate the use of transition metal doped carbon nanotubes for chemical gas sensing. For a set of relevant target molecules (CO, NH3, H2S) and the main components of air (N2, O2, H2O), we calculate the binding energy and change in conductance upon adsorption on a metal atom occupying a vacancy of a (6,6) carbon nanotube. Based on these descriptors, we identify the most promising dopant candidates for detection of a given target molecule. From the fractional coverage of the metal sites in thermal equilibrium with air, we estimate the change in the nanotube resistance per doping site as a function of the target molecule concentration assuming charge transport in the diffusive regime. Our analysis points to Ni-doped nanotubes as candidates for CO sensors working under typical atmospheric conditions

High-order harmonic generation from polyatomic molecules including nuclear motion and a nuclear modes analysis

We present a generic approach for treating the effect of nuclear motion in the high-order harmonic generation from polyatomic molecules. Our procedure relies on a separation of nuclear and electron dynamics where we account for the electronic part using the Lewenstein model and nuclear motion enters as a nuclear correlation function. We express the nuclear correlation function in terms of Franck-Condon factors which allows us to decompose nuclear motion into modes and identify the modes that are dominant in the high-order harmonic generation process. We show results for the isotopes CH$_4$ and CD$_4$ and thereby provide direct theoretical support for a recent experiment [Baker {\it et al.}, Science {\bf 312}, 424 (2006)] that uses high-order harmonic generation to probe the ultra-fast structural nuclear rearrangement of ionized methane.Comment: 6 pages, 6 figure

Molecular Dynamics Simulation of Polymer-Metal Bonds

Molecular simulation is becoming a very powerful tool for studying dynamic phenomena in materials. The simulation yields information about interaction at length and time scales unattainable by experimental measurements and unpredictable by continuum theories. This is especially meaningful when referring to bonding between a polymer and a metal substrate. A very important characteristic of polymers is that their physical properties do not rely on the detailed chemical structure of the molecular chains but only on their flexibility, and accordingly they will be able to adopt different conformations. In this paper, a molecular simulation of the bonding between vinyl ester polymer and steel is presented. Four different polymers with increasing chain lengths have been studied. Atomic co-ordinates are adjusted in order to reduce the molecular energy. Conformational changes in the macromolecules have been followed to obtain the polymer pair correlation function. Radius of gyration and end-to-end distance distributions of the individual chains have been used as a quantitative measurement of their flexibility. There exists a correlation between flexibility of the molecular chains and the energy of adhesion between the polymer and the metal substrate. Close contacts between the two materials are established at certain points but every atom up to a certain distance from the interface contributes to the total value of the adhesion energy of the system

A new dawn? The Roman Catholic Church and environmental issues

This is a PDF version of an article published in New Blackfriars© 1997. The definitive version is available at www.blackwell-synergy.com.This article discusses the stance of the Roman Catholic Church on environmental issues and argues that the Church tends to stay on the fringe rather than get involved. Some of the ways in which Roman Catholic theologians have incorporated environmental issues into theological reflection is discussed, as are environmental challenges facing the Church in Britain (conservation, resources, biodiversity, animal welfare, biotechnology, cooperate/individual ethics, environmental justice, economics/policy development, and global issues)

Graphene defect formation by extreme ultraviolet generated photoelectrons

We have studied the effect of photoelectrons on defect formation in graphene during extreme ultraviolet (EUV) irradiation. Assuming the major role of these low energy electrons, we have mimicked the process by using low energy primary electrons. Graphene is irradiated by an electron beam with energy lower than 80 eV. After e-beam irradiation, it is found that the D peak, I(D), appears in the Raman spectrum, indicating defect formation in graphene. The evolution of I(D)/I(G) follows the amorphization trajectory with increasing irradiation dose, indicating that graphene goes through a transformation from microcrystalline to nanocrystalline and then further to amorphous carbon. Further, irradiation of graphene with increased water partial pressure does not significantly change the Raman spectra, which suggests that, in the extremely low energy range, e-beam induced chemical reactions between residual water and graphene is not the dominant mechanism driving defect formation in graphene. Single layer graphene, partially suspended over holes was irradiated with EUV radiation. By comparing with the Raman results from e-beam irradiation, it is concluded that the photoelectrons, especially those from the valence band, contribute to defect formation in graphene during irradiation.Comment: appears in Journal of Applied Physics 201

Initiation and evolution of interstitial leukocytic infiltration in experimental glomerulonephritis

Initiation and evolution of interstitial leukocytic infiltration in experimental glomerulonephritis. Most forms of glomerulonephritis have a significant interstitial leukocytic infiltrate which is associated with disease progression. However, there is little data concerning the timing, initial location, and development of this interstitial component. Therefore, we have addressed these issues in a study of passive accelerated anti-GBM glomerulonephritis in the rat. In this model, interstitial leukocytic infiltration was an early event in the disease process with a significant infiltrate apparent at 12 hours after administration of nephrotoxic serum (NTS). This initial infiltrate was restricted to a perivascular sheath surrounding the hilar arterioles. The sheath infiltrate then spread to include the whole hilar area by day 1, the entire periglomerular area by day 3, and became widespread throughout the cortical tubulointerstitium by day 7. The early sheath infiltrate was composed of macrophages and T cells. Both cell types continued to increase as the infiltrate expanded, and a significant accumulation of activated cells (IL-2R+) was evident from day 7 onwards. There was a highly significant correlation between interstitial macrophage infiltration and renal function impairment, proteinuria, and histologic damage. Interstitial T cell infiltration correlated with proteinuria and histologic damage, while the appearance of immune-activated mononuclear cells (IL-2R+) exhibited a highly significant correlation with all disease parameters. This study demonstrates the importance of the glomerular hilar arteriolar region as a focus for mononuclear leucocytic migration and accumulation which not only affects the structure and function of the glomerulus but subsequently the entire tubulointerstitium

About Those New Oats - Burnett and Newton

These two new oat varieties will be available for planting in 1958. You can see them growing this year at Iowa State College or in the fields of certified seed producers. Here are the details on what you can expect

What Happened to our Oats in 1953?

Stem rust, crown rust, temperatures, moisture and- believe it or not- hurricanes, tornadoes and windstorms all combined forces to wreak havoc with Iowa\u27s 1953 oat crop. Here is the story and a look ahead

Entanglement of distant optomechanical systems

We theoretically investigate the possibility to generate non-classical states of optical and mechanical modes of optical cavities, distant from each other. A setup comprised of two identical cavities, each with one fixed and one movable mirror and coupled by an optical fiber, is studied in detail. We show that with such a setup there is potential to generate entanglement between the distant cavities, involving both optical and mechanical modes. The scheme is robust with respect to dissipation, and nonlocal correlations are found to exist in the steady state at finite temperatures.Comment: 12 pages (published with minor modifications