4,581 research outputs found
Diffractive beam splitter characterization via a power-recycled interferometer
We used the high-precision laser interferometer technique of power recycling to characterize the optical loss of an all-reflective grating beam splitter. This beam splitter was used to set up a Michelson interferometer with a power-recycling resonator with a finesse of 883. Analyzing the results obtained, we determined the beam splitter's total optical loss to be (0.193+/-0.019)%. Low loss all-reflective beam splitters might find application in future high-power laser interferometers for the detection of gravitational waves
Power-recycled michelson interferometer with a 50/50 grating beam splitter
We designed and fabricated an all-reflective 50/50 beam splitter based on a dielectric grating. This beam splitter was used to set up a power-recycled Michelson interferometer with a finesse of about FPR ≈ 880. Aspects of the diffractive beam splitter as well as of the interferometer design are discussed.DFG/SFB/TR
Clindamycin is neuroprotective in experimental Streptococcus pneumoniae meningitis compared with ceftriaxone
Mechanical Q-factor measurements on a test mass with a structured surface
We present mechanical Q-factors (quality factors) of a crystalline quartz test mass with a nano-structured surface, measured in the temperature regime from 5 to 300 K. The nano-structure was a grating with a period of 2 mu m and a depth of about 0.1 mu m. Comparative measurements were performed on the plain substrate and on the structured test mass with different numbers of SiO2/Ta2O5 coating layers. The measurements at different stages of the test mass fabrication process show that the surface distortion induced by the nanostructure does not severely lower the mechanical Q-factor of the substrate. Damping due to a multi-layer coating stack was found to be orders of magnitude higher. The results provide vital information concerning the potential usage of low-thermal noise nano-structured test masses in future generations of high-precision laser interferometers and in current attempts to measure quantum effects of macroscopic mirror oscillators.DFG/SFB/Transregio
Construction and Performance of Large-Area Triple-GEM Prototypes for Future Upgrades of the CMS Forward Muon System
At present, part of the forward RPC muon system of the CMS detector at the
CERN LHC remains uninstrumented in the high-\eta region. An international
collaboration is investigating the possibility of covering the 1.6 < |\eta| <
2.4 region of the muon endcaps with large-area triple-GEM detectors. Given
their good spatial resolution, high rate capability, and radiation hardness,
these micro-pattern gas detectors are an appealing option for simultaneously
enhancing muon tracking and triggering capabilities in a future upgrade of the
CMS detector. A general overview of this feasibility study will be presented.
The design and construction of small (10\times10 cm2) and full-size trapezoidal
(1\times0.5 m2) triple-GEM prototypes will be described. During detector
assembly, different techniques for stretching the GEM foils were tested.
Results from measurements with x-rays and from test beam campaigns at the CERN
SPS will be shown for the small and large prototypes. Preliminary simulation
studies on the expected muon reconstruction and trigger performances of this
proposed upgraded muon system will be reported.Comment: 7 pages, 25 figures, submitted for publication in conference record
of the 2011 IEEE Nuclear Science Symposium, Valencia, Spai
The status of GEO 600
The GEO 600 laser interferometer with 600m armlength is part of a worldwide network of gravitational wave detectors. GEO 600 is unique in having advanced multiple pendulum suspensions with a monolithic last stage and in employing a signal recycled optical design. This paper describes the recent commissioning of the interferometer and its operation in signal recycled mode
An overview of the design, construction and performance of large area triple-GEM prototypes for future upgrades of the CMS forward muon system
GEM detectors are used in high energy physics experiments given their good spatial resolution, high rate capability and radiation hardness. An international collaboration is investigating the possibility of covering the 1.6 < vertical bar eta vertical bar < 2.4 region of the CMS muon endcaps with large-area triple-GEM detectors. The CMS high-eta area is actually not fully instrumented, only Cathode Strip Chamber (CSC) are installed. The vacant area presents an opportunity for a detector technology able to to cope with the harsh radiation environment; these micropattern gas detectors are an appealing option to simultaneously enhance muon tracking and triggering capabilities in a future upgrade of the CMS detector. A general overview of this feasibility study is presented. Design and construction of small (10cm x 10cm) and full-size trapezoidal (1m x 0.5m) triple-GEM prototypes is described. Results from measurements with x-rays and from test beam campaigns at the CERN SPS is shown for the small and large prototypes. Preliminary simulation studies on the expected muon reconstruction and trigger performances of this proposed upgraded muon system are reported
Phase and alignment noise in grating interferometers
Diffraction gratings have been proposed as core optical elements in future
laser-interferometric gravitational-wave detectors. In this paper we derive
equations for the coupling between alignment noise and phase noise at
diffraction gratings. In comparison to a standard reflective component (mirror
or beam splitter) the diffractive nature of the gratings causes an additional
coupling of geometry changes into alignment and phase noise. Expressions for
the change in angle and optical path length of each outgoing beam are provided
as functions of a translation or rotation of the incoming beam with respect to
the grating. The analysis is based entirely on the grating equation and the
geometry of the setup. We further analyse exemplary optical setups which have
been proposed for the use in future gravitational wave detectors. We find that
the use of diffraction gratings yields a strong coupling of alignment noise
into phase noise. By comparing the results with the specifications of current
detectors we show that this additional noise coupling results in new,
challenging requirements for the suspension and isolation systems for the
optical components.Comment: 16 pages, 6 figure
A Joint Search for Gravitational Wave Bursts with AURIGA and LIGO
The first simultaneous operation of the AURIGA detector and the LIGO
observatory was an opportunity to explore real data, joint analysis methods
between two very different types of gravitational wave detectors: resonant bars
and interferometers. This paper describes a coincident gravitational wave burst
search, where data from the LIGO interferometers are cross-correlated at the
time of AURIGA candidate events to identify coherent transients. The analysis
pipeline is tuned with two thresholds, on the signal-to-noise ratio of AURIGA
candidate events and on the significance of the cross-correlation test in LIGO.
The false alarm rate is estimated by introducing time shifts between data sets
and the network detection efficiency is measured with simulated signals with
power in the narrower AURIGA band. In the absence of a detection, we discuss
how to set an upper limit on the rate of gravitational waves and to interpret
it according to different source models. Due to the short amount of analyzed
data and to the high rate of non-Gaussian transients in the detectors noise at
the time, the relevance of this study is methodological: this was the first
joint search for gravitational wave bursts among detectors with such different
spectral sensitivity and the first opportunity for the resonant and
interferometric communities to unify languages and techniques in the pursuit of
their common goal.Comment: 18 pages, IOP, 12 EPS figure
Searching for gravitational waves from known pulsars
We present upper limits on the amplitude of gravitational waves from 28
isolated pulsars using data from the second science run of LIGO. The results
are also expressed as a constraint on the pulsars' equatorial ellipticities. We
discuss a new way of presenting such ellipticity upper limits that takes
account of the uncertainties of the pulsar moment of inertia. We also extend
our previous method to search for known pulsars in binary systems, of which
there are about 80 in the sensitive frequency range of LIGO and GEO 600.Comment: Accepted by CQG for the proceeding of GWDAW9, 7 pages, 2 figure
- …