Post-Agricultural Succession in El PetÉn, Guatemala

We compared post-agricultural succession across the range of farming activities practiced in Guatemala's northern lowlands: agroforestry, swidden, ranching, and input-intensive monocultures. At 10 sites over 13 to 40 months we assessed the following characteristics of trees and shrubs that were>1 cm diameter at breast height: height, basal-area accumulation, recruitment of all individuals and fleshy-fruited individuals, and accumulation of all species and fleshy-fruited species. Succession, as measured by all these response variables except height, was dramatically faster on agroforestry and swidden sites than on pastures or input-intensive monocultures. Overall recruitment was faster for swiddens than for agroforests, but other response variables did not differ significantly between the two treatments. Regression results suggest that initial ground cover by herbs inhibited recruitment of woody colonists. The significant positive coefficient for initial basal area and the significant negative coefficient for distance from forest for accumulation of both fleshy-fruited individuals and species are probably explained by the behavioral responses of seed-dispersing animals. Our results suggest that the conservation strategy of discouraging swidden agriculture in favor of sedentary, input-intensive agriculture to relieve pressure on old-growth forest may be counterproductive over the long term.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/75095/1/j.1523-1739.2003.01265.x.pd

Experimental Evidence for Different Strain Regimes of Crack Populations in a Clay Model

We report results from clay extension experiments used as a model for the evolution of fault populations due to stress interactions. At yielding cracks begin to appear and the brittle strain due to them quickly reaches a rate matching the applied stretching rate. The crack density (number of cracks per unit area) initially increases apace, then reaches a maximum at a critical strain, decreasing thereafter. At low strains, where the crack population is dilute, a power law length distribution is observed, which at high strain, gradually transitions to an exponential. This agrees with fault populations data observed in low and high strain settings. These results indicate that fault populations ranging from power law to exponential size-frequency distributions reflect the population evolution with increased strain

Photoelectron Imaging of Viruses and DNA: Evaluation of Substrates by Unidirectional Low Angle Shadowing and Photoemission Current Measurements

ABSTRACT Photoelectron imaging (photoelectron emission microscopy, PEM or PEEM) is a promising high resolution surface-sensitive technique for biophysical studies. At present, image quality is often limited by the underlying substrate. For photoelectron imaging, the substrate must be electrically conductive, low in electron emission, and relatively flat. A number of conductive substrate materials with relatively low electron emission were examined for surface roughness. Low angle, unidirectional shadowing of the specimens followed by photoelectron microscopy was found to be an effective way to test the quality of substrate surfaces. Optimal results were obtained by depositing -0.1 nm of platinum-palladium (80:20) at an angle of 30. Among potential substrates for photoelectron imaging, silicon and evaporated chromium surfaces were found to be much smoother than evaporated magnesium fluoride, which initially appeared promising because of its very low electron emission. The best images were obtained with a chromium substrate coated with a thin layer of dextran derivatized with spermidine, which facilitated the spreading and adhesion of biomolecules to the surfaces. Making use of this substrate, improved photoelectron images are reported for tobacco mosaic virus particles and DNA-recA complexes. INTRODUCTION There are a number of new or improved ways of imaging DNA and DNA-protein complexe

The North Wyke Farm Platform: Methodologies Used in the Remote Sensing of the Quantity and Quality of Drainage Water

The North Wyke Farm Platform(NWFP) for agri-environmental research in temperate grassland was established in the UK in 2010 (Orr et al. 2011). Here we describe the instrumentation and methodologies used to monitor the quantity and quality of drainage water at a total of 15 H-flumes draining 5 sub-catchments within three farmlets. Each of 15 flume laboratories is supplied with 3 kW of mains power and connected to both fibre optic and UHF (Ultra High Frequency) radio networks for data exchange. The radio data network also provides telemetry for rain gauges and soil temperature/moisture probes located away from the flumes and within the catchment blocks. Water flow is measured using bubbler flow meters and when flow is above a defined threshold level, water is pumped into bespoke 13-litre stainless steel bypass cells on a 15-minute cycle using bi-directional peristaltic pumps. A range of sensors located within the bypass cells measure the following water quality parameters: nitrate, ammonium, dissolved organic carbon, temperature, conductivity, turbidity, pH and dissolved oxygen. Total phosphorus and ortho phosphorus are measured at one flume in each farmlet. Networked auto-samplers are also provided at each flume site for the measurement of other wa-ter quality parameters as required. All data are logged and sent to a dedicated server at a 15 min resolution while a web front end allows advanced visualization capabilities and remote control of the entire system. The system is configured to allow for flexibility and future expansion to a wider range of parameters

Propulsion Control Technology Development Needs to Address NASA Aeronautics Research Mission Goals for Thrusts 3a and 4

The Commercial Aero-Propulsion Control Working Group (CAPCWG), consisting of propulsion control technology leads from The Boeing Company, GE Aviation, Honeywell, Pratt & Whitney, Rolls-Royce, and NASA (National Aeronautics and Space Administration) Glenn Research Center, has been working together over the past year to identify propulsion control technology areas of common interest that we believe are critical to achieving the challenging NASA Aeronautics Research goals for Thrust 3a: Ultra-Efficient Commercial Vehicles - Subsonic Transports, and Thrust 4: Transition to Alternative Propulsion and Energy. This paper describes the various propulsion control technology development areas identified by CAPCWG as most critical for NASA to invest in. For Thrust 3a these are: i) Integrated On-Board Model Based Engine Control and Health Management; ii) Flexible and Modular Networked Control Hardware and Software Architecture; iii) Intelligent Air/Fuel Control for Low Emissions Combustion; and iv) Active Clearance Control. For Thrust 4a, the focus is on Hybrid Electric Propulsion (HEP) for single aisle commercial aircraft. The specific technology development areas include: i) Integrated Power and Propulsion System Dynamic Modeling for Control; ii) Control Architectures for HEP; iii) HEP Control Verification and Validation; and iv) Engine/Airplane Control Integration. For each of the technology areas, the discussion includes: problem to be solved and how it relates to NASA goals, and the challenges to be addressed in reducing risk

The North Wyke Farm Platform: A New UK National Capability for Research into Sustainability of Agricultural Temperate Grassland Management

The North Wyke Farm Platform is a new UK National Capability that will enable studies that can be closely monitored and controlled under different land-use options at the farm-scale. As a Biotechnology and Biological Sciences Research Council-funded National Capability, the Farm Platform provides centralised scientific facilities including core data (field and water chemistry, water flow rates, greenhouse gas emissions from soils, livestock and agronomic data, and farm management records). Access to the Farm Platform for experimental work or to data will be available to other research users and collaborators. This shared approach will enhance the depth and breadth of information gained for the benefit of the wider community

Light Water Reactor Sustainability Program Integrated Program Plan

Nuclear power has safely, reliably, and economically contributed almost 20% of electrical generation in the United States over the past two decades. It remains the single largest contributor (more than 70%) of non-greenhouse-gas-emitting electric power generation in the United States. Domestic demand for electrical energy is expected to experience a 31% growth from 2009 to 2035. At the same time, most of the currently operating nuclear power plants will begin reaching the end of their initial 20-year extension to their original 40-year operating license for a total of 60 years of operation. Figure E-1 shows projected nuclear energy contribution to the domestic generating capacity. If current operating nuclear power plants do not operate beyond 60 years, the total fraction of generated electrical energy from nuclear power will begin to decline - even with the expected addition of new nuclear generating capacity. The oldest commercial plants in the United States reached their 40th anniversary in 2009. The U.S. Department of Energy Office of Nuclear Energy's Research and Development Roadmap (Nuclear Energy Roadmap) organizes its activities around four objectives that ensure nuclear energy remains a compelling and viable energy option for the United States. The four objectives are as follows: (1) develop technologies and other solutions that can improve the reliability, sustain the safety, and extend the life of the current reactors; (2) develop improvements in the affordability of new reactors to enable nuclear energy to help meet the Administration's energy security and climate change goals; (3) develop sustainable nuclear fuel cycles; and (4) understand and minimize the risks of nuclear proliferation and terrorism. The Light Water Reactor Sustainability (LWRS) Program is the primary programmatic activity that addresses Objective 1. This document summarizes the LWRS Program's plans

In-spiraling Clumps in Blue Compact Dwarf Galaxies

Giant star-formation clumps in dwarf irregular galaxies can have masses exceeding a few percent of the galaxy mass enclosed inside their orbital radii. They can produce sufficient torques on dark matter halo particles, halo stars, and the surrounding disk to lose their angular momentum and spiral into the central region in 1 Gyr. Pairs of giant clumps with similarly large relative masses can interact and exchange angular momentum to the same degree. The result of this angular momentum loss is a growing central concentration of old stars, gas, and star formation that can produce a long-lived starburst in the inner region, identified with the BCD phase. This central concentration is proposed to be analogous to the bulge in a young spiral galaxy. Observations of star complexes in five local BCDs confirm the relatively large clump masses that are expected for this process. The observed clumps also seem to contain old field stars, even after background light subtraction, in which case the clumps may be long-lived. The two examples with clumps closest to the center have the largest relative clump masses and the greatest contributions from old stars. An additional indication that the dense central regions of BCDs are like bulges is the high ratio of the inner disk scale height to the scale length, which is comparable to 1 for four of the galaxies.Comment: 15 pages, 2 figures, accepted by ApJ 1/5/201